ABSTRACT
Objective: In this study, thermoelastic stress analysis was conducted to clarify the surface stress distribution of a femur in which a BiCONTACT E stem was inserted. The contact sites between the stem and femur were examined to investigate the association with the range of stress distribution.Materials and Methods: BiCONTACT E was set up using two synthetic femurs that mimic the morphology and mechanical properties of living bone. Preoperative planning was performed using three-dimensional imaging software. The synthetic bone was placed in a sample holder. After the stem was implanted into the synthetic bone, computed tomography imaging was performed. The contact sites between the stem and the cortical part of the synthetic bone were examined using the imaging software. Subsequently, thermoelastic stress measurements were performed on the sample.Results: The results of thermoelastic stress analysis indicated a minimum change in the sum of principal stresses [Δ (σ1+σ2)] on the medial side and a maximum change in the sum of principal stresses on the lateral side. Thus, no minimum change was observed in the sum of the principal stresses at the maximum proximal part. It is reasonable to assume that the use of a cementless stem can inevitably lead to bone atrophy in the proximal part of the femur. The contact sites between the stem and femur were also investigated, and the results of the study clearly and quantitatively demonstrated the correlation of the contact sites with a range of stress distributions.Conclusion: The surface stress distribution of a femur, in which a BiCONTACT E stem was inserted, was clarified. The contact sites between the stem and femur were also investigated. Furthermore, the correlation between these results and clinical bone response was investigated in this study.
ABSTRACT
Objective: To compare the outcomes of steroid-associated osteonecrosis of the femoral head in patients with systemic lupus erythematosus who underwent conservative treatment and concentrated autologous bone marrow aspirate transplantationMethods: Osteonecrosis of the femoral head was classified according to the Japanese Investigation Committee system. Concentrated autologous bone marrow aspirate transplantation was performed by aspirating the bone marrow from both iliac crests and then transplanting it to the necrotic area after the core decompression. Patients with >2-year follow-up after the concentrated autologous bone marrow aspirate transplantation in our institution (Group I) and those with >2-year follow-up after the first hospital visit in a cooperative institution (Group II) were included in this study. After a randomized matching based on age, sex, type, stage, and etiology, the collapse rate in pre-collapsed stages and total hip arthroplasty conversion rate in all stages were compared between the two groups.Results: After the matching adjustment, 33 pairs of hips were included. Preoperatively, 1, 2, 16, and 14 hips were classified as types A, B, C1, and C2, respectively, and 15, 13, 2, and 3 hips were classified as stages 1, 2, 3A, and 3B, respectively. The collapse rates in the pre-collapsed stages were 68% and 39% in Groups I and II, respectively. Total hip arthroplasty conversion rates were 33% and 45% in Groups I and II, respectively. However, Group I had significantly higher and lower conversion rates in stages 1 and 3, respectively (both P<0.05).Conclusion: Conservative treatment may be preferable in stage 1 hips. In addition, concentrated autologous bone marrow aspirate transplantation may prevent further collapse in stage 3.