ABSTRACT
In order to improve students' ability of performing investigative study, promote practical teaching, optimize teaching philosophy and methods, we integrated the subject frontier dynamics and development achievements and knowledge into teaching content, the teaching exploration and practice of research experiment of experimental curriculum in - was performed. The experimental curriculum was used as starting point. Before experimental teaching, the learning of knowledge was completed by theoretical study and key self-study points. During experimental teaching, experimental report and analysis report were completed by group collaboration. After experimental teaching, the research experiment was reported, analyzed and summarized by group discussion and presentation. With innovate, flexible and diverse teaching forms to guide the students to experience the process of "asking questions→conducting experiment→observation→recording→analysis→conclusion→verification of assumptions-discussion→reports", the ability of independent thinking and active investigation was improved; teaching level and teaching effectiveness were promoted.
ABSTRACT
Objective To obtain the classification and characteristics of acupuncture manipulations by analyzing teacher's lifting-thrusting manipulation parameters derived from Germany-made Simi Motion 3D image analysis system using self-organizing feature map neural network (SOM). Method Thirty acupuncture teachers were selected for the study. Unilateral Quchi (LI11) was used as a point for acupuncture. A motion video of lifting-thrusting even reinforcing-reducing, reinforcing and reducing manipulations was made. The video was analyzed using Simi Motion 3D image analysis system to obtain original motion parameters at thumb tip tracking mark point. Teacher's manipulation classification parameters were analyzed using SOM. Result Acupuncture manipulation parameters showed nonnormal distribution with larger dispersion. Even reinforcing-reducing and reinforcing manipulations could be classified into four types and reducing manipulation, into five types. The characteristics of every type showed general concentration degree. Conclusion Acupuncture manipulation parameters overall showed the diversity characteristics of nonnormal distribution and are typical artificial control curve. They have the characteristic of lower concentration degree of neural network classification. Their classification is mainly based on curve shape and cycle length and related to the degree of difficulty of manipulation. This technique can be applied to the quantitative analysis of various manipulationsand the study of technical inheritance and provide reference for the standardization of acupuncture manipulation.
ABSTRACT
To design a warm-acupuncture teaching instrument to train and evaluate its manipulation. We refer to the principle and technical operation characteristics of traditional warm-acupuncture, as well as the mechanical design and single-chip microcomputer technology. The device is consisted of device noumenon, universal acupoints simulator, vibration reset system and circuit control system, including frame, platform framework, the swing framework, universal acupoints simulator, vibration reset outfit, operation time circuit, acupuncture sensation display, and vibration control circuit, etc. It can be used to train needle inserting with different angles and moxa rubbing and loading. It displays whether a needle point meets the location required. We determine whether the moxa group on a needle handle is easy to fall off through vibration test, and operation time is showed. The device can objectively help warm-acupuncture training and evaluation so as to promote its clinical standardization manipulation.
ABSTRACT
The questionnaire was adopted so as to investigate the attitudes and recognition of the manufacture eneprises of TCM diagnosis, treatment and rehabilitation equipment (DTRE) to the technical standards of, relevant products. It was found that the construction of the industrial standard and the national standard was lagged behind on TCM DTRE. Under the new situation, the enterprises are highly willing to participate in the development of the industrial, national and international standards and have a certain of understanding on the standard development. Nearly 80 % of enterprises believed that it was necessary to set up the relevant mirror organization for the development of industrial, national and international standard of TCM DITRE. In the future, the standard construction of TCM DTRE must face to the new situation. The constant increasing of the enterprises. and scientific research organizations in the standard construction must promote the development of TCM DTRE.
Subject(s)
Humans , Equipment and Supplies, Hospital , Reference Standards , Medicine, Chinese Traditional , Reference Standards , Rehabilitation , Reference StandardsABSTRACT
Retrieving literature and summarizing the experience in lecturing acupuncture and clinical practice, the authors analyzed the objective reasons of pain during the needle insertion. Three factors are considered, including needles, skin tissue of inserting site and technique of insertion. The teaching program was discussed on how to alleviate or avoid pain during the concrete manipulation. It is viewed that no matter in teaching program of acupuncture or clinical operation, for alleviating pain during needle insertion, the key points must be on the rapid insertion through skin surface and the coordination of the puncture hand and pressing hand.
ABSTRACT
Studying the industry standard of electroacupuncture therapy device (YY 0780-2010), collaborating with the clinical practice of acupuncture and moxibustion, in view of academy and safety, the comments and suggestions are proposed on the content of the standard. The standard describes manipulation norms, terms and definitions, dianjizhen and the output energy of single pulse, etc. It is expected that these comments and suggestions can be taken in consideration in the revision of industry standard or the development of national standard so as to improve the scientific level and feasibility of the technique standard of electroacupuncture therapy device.
Subject(s)
Humans , Cooperative Behavior , Electroacupuncture , Methods , Equipment and Supplies , Reference StandardsABSTRACT
Electroacupuncture instruments as Chinese medicine treatment equipment clinically used most extensively play an important role in improving clinical effect of acupuncture treatment. Although the history of electroacupuncture instruments only has more than 60 years, the development of electroacupuncture equipment has experienced a very rich course. Especially in recentyears, the development of electroacupuncture instruments took on a new developing state. It is certain that thedevelopment of electroacupuncture instruments has entered a new era and the future developing speed and quality of electroacupuncture instruments will be significantly raised. By a review of the developing history of electroacupuncture equipmen, this article technically classifies electroacupuncture instruments and deeply analyzes some problems existent in the development of electroacupuncture instruments so as to propose more strict requirements for the future design of electroacupuncture instruments andsatisfy the demand of clinical acupuncture practice.
ABSTRACT
The studies of the simulation of acupuncture manipulation mainly focus on mechanical simulation and virtual simulation (SIM). In terms of mechanical simulation, the aim of the research is to develop the instruments of the simulation of acupuncture manipulation, and to apply them to the simulation or a replacement of the manual acupuncture manipulation; while the virtual simulation applies the virtual reality technology to present the manipulation in 3D real-time on the computer screen. This paper is to summarize the recent research progress on computer simulation of acupuncture manipulation at home and abroad, and thus concludes with the significance and the rising problems over the computer simulation of acupuncture manipulation. Therefore we put forward that the research on simulation manipulation should pay much attention to experts' manipulation simulation, as well as the verification studies on conformity and clinical effects.
Subject(s)
Humans , Acupuncture Therapy , Methods , Computer Simulation , Professional CompetenceABSTRACT
Acupuncture manipulation is the pivotal factor for conferring clinical efficacy of acupuncture. By retrieving in the scientific research data base and acquiring the characteristics of acupuncture manipulation parameters, we studied the cluster-algorithm on parameter analyses and implemented clustering analysis of acupuncture manipulation parameters. Then we disclose the inherent method of needling. Thus, it can be used as a theoretical base for the studies on standard, normalization and quantification of the acupuncture manipulation parameter.
Subject(s)
Humans , Acupuncture Therapy , Methods , Algorithms , Cluster Analysis , Computer SimulationABSTRACT
In the review of the literature on the quantitative study of the needling techniques, the authors believe that modern scientific technology plays an important role in the quantitative study of the needling techniques, submit the research methods and channels of the quantitative study of the needling techniques under the current condition, foresee its development prospects and emphasize the significance of the quantitative study of the needling technique in the teaching, clinical service and research process of acupuncture.
ABSTRACT
To research the effects of electroacupuncture on different quantitative parameters on analgesia in rats with adjuvant-induced arthritis. Rats of adjuvant-induced arthritis were treated by electroacupuncture with different waveforms. Pain threshold and swelling degree of joint were observed. Electroacupuncture parameters being selected were measured by frequency spectrum analysis. After treatment, the pain thresholds in the electroacupuncture groups with different waveforms were higher than that of the model group (P < 0.05, P < 0.01); the local swelling degree of inflammation of the electroacupuncture groups were higher than that of the model group (P < 0.01), but was lower than that of the control group (P < 0.05, P < 0.01). Frequency, current, voltage and pulse width of successive wave and intermittent wave were similar. Frequency,current, voltage and pulse width of sound electric wave changed continuously. The results were that all the electroacupuncture with different waveforms had the analgesic effect in rats with adjuvant-induced arthritis and the therapeutic effect of the electroacupuncture of sound electric wave was the best. It is reasonable and important that electroacupuncture parameter should be quantified.
Subject(s)
Animals , Female , Rats , Acupuncture Analgesia , Arthritis, Experimental , Therapeutics , Electroacupuncture , Methods , Pain Threshold , Random Allocation , Rats, WistarABSTRACT
OBJECTIVE: To apply the real-time data collection and demonstration system for acupuncture manipulation to quantitative analysis of acupuncture manipulation for acupuncture teaching and research. METHODS: The real-time observation and analysis of parameter changes of acupuncture manipulation were implemented by this system. RESULTS: During the course of lifting and thrusting manipulation, the needle body moved in a uniform variable motion, and the action force was still kept while the arrival of Qi was achieved. During the course of twirling manipulation, the variations of twirling number and radian caused the changes of resistance moment, and this reaction was related to the body response. During the course of rotating and shaking manipulation, the radius for rotating and shaking was related to such factors as the force, the action point and the direction. CONCLUSION: The real-time data collection and demonstration system for acupuncture manipulation can provide a new experimental method for quantitative data analysis, standardized research and teaching demonstration of acupuncture.
ABSTRACT
MS96A type spectrum analyzer was applied to determine the spectral characteristic of near infrared radiated by moxa stick moxi-bustion, ginger-partitioned moxibustion, garlic-partitioned moxibustion and Aconium Carmichaeli-par titioned moxibustion. The spectrum of moxa stick moxibustion was relatively discrete and several wave crests are appeared. But in the spectrum of ginger-partitioned moxibustion, garlic-partitioned moxibustion or Aconium Carmichaeli-partitioned moxibustion, a specific and relatively steady wave crest formed respectively. It was concluded different indirect moxibustion could bring respective spectrum of near infrared and have the relevant physiologic and biochemical effects.