The fitness of adjustable dental impression trays on the Koreans / 대한치과보철학회지

Purpose: this study was to evaluate the fitness of adjustable dental impression trays on the Koreans : the trays used in the previous study by Kim et al. as part of the dental adjustable tray development project were improved and modified. Material and method: The patterns of tray were made through CAD-CAM process, and a simple silicone-base molds were made from them. The trial products were reproduced by pouring polyurethane into these molds. 30 male students(Wonkwang University, Dental College) and 30 female students (Wonkwang Health Science College, Department of Dental Hygiene) were selected and Reversible hydrocolloid impression materials were used for this study. The fitness of the trays was evaluated by measuring the width and length of impression materials of each measurement sites. Results and conclusion: 1. In adapting the trays inside the mouth, a uniform width of impression material(3.6mm) was obtained in most sites due to the tooth stops and the inclined planes accommodating the width of the tray. 2. The thickness of impression material in the central part of the palate was a mean 9.8 mm, which turned out to be somewhat thick. 3. In the mandible, the thickness of the impression material in the lingual side inferior to the contact point of the 1st and 2nd molars was 2.7mm, and the thickness of the material in the lingual side of the rearmost margin was 2.5 mm. The thickness of the impression material of these areas was relatively thin.

Retentive force of adjustable dental impression trays with different retention forms / 대한치과보철학회지

STATEMENT OF PROBLEM: The adjustable dental impression trays were made for being adjusted their width automatically along the width of dental arch. PURPOSE: The purpose of this study was to investigate the best retentive form of adjustable dental impression tray, and so to make it a more satisfactory product. MATERIALS AND METHODS: The eight pairs of adjustable trays were made of ABS(acrylonitrile butadiene styrene) with different distribution of holes and with or without the rim on the border area of them. The experiment was done with the horse-shoe shaped metal plate to pull out the set impression body from the tray, and the tray jig which was made for holding the tray on a lower part of Universal Testing achine(UTM, Zwick Z020, Zwick Co., Germany). After the impression in the tray was allowed to set four minutes, a tensile force was applied at right angles to the tray which had been previously seated on the jig. The force was applied to measure a maximum retentive force by use of a UTM at a constant strain rate of 100mm per minute. A 2-factor analysis of variance (p.05) 4. The rimless trays were more retentive generally, than the rimmed trays except 2 case: upper tray group-all area / 2 mm. intervals and lower tray group-margin only / 2 mm. intervals.(p<.05) 5. Most of the adjustable trays were showed higher retentive force than perforated metal tray except the lower group that perforated on the all area at intervals of 2 mm.