ABSTRACT
Objective@#To evaluate the therapeutic effect of dental autotransplantation with the application of digital design combined with 3D printing of donor tooth models and recipient alveolar fossa model preoperatively.@*Methods@# Twelve cases that could not be retained due to tooth fracture or extensive absorption of alveolar bone were recruited in the study. Cone-beam computed tomography (CBCT) data were imported into Mimics software for digital design, and the best-matched third molar was selected as the donor tooth. Replicas of the donor teeth and the recipient socket were printed out with three-dimensional (3D) printing technologies as a simulation model for recipient tooth socket preparation. During tooth autotransplantation, preparation of the recipient tooth socket and the donor tooth were guided by the 3D-printed replicas sequentially. Then, the donor tooth was implanted into the recipient tooth pocket. Patients were followed up at 3, 6 and 12 months after the operation, with CBCT examination to evaluate the status of bone reconstruction and periodontal ligaments at each time point. @*Results@#Twelve patients were transplanted with an autogenous third molar with the apical foramen completely closed. Among them, 7 patients had alveolar fossa infection before the operation, of which 1 had extensive resorption of the alveolar bone due to the infection. All 12 patients recovered well after the operation and were followed up for at least 12 months. In total, 11 caseswere successful in tooth autotransplantation with normal mastication, and 1 case had root resorption 14 months postoperation.@*Conclusion@#Digital design combined with 3D printing technology can assistin the selection of thebest-matched donor tooth and preparation of the recipient socket before tooth transplantation proceduresand reduce the extra-alveolar exposure time of the donor tooth and number of trial placementsintothe alveolar fossa. Thus, this combined strategy can effectively improve the outcome of dental autotransplantation.
ABSTRACT
OBJECTIVES: The maintenance of the healthy periodontal ligament cells of the root surface of donor tooth and intimate surface contact between the donor tooth and the recipient bone are the key factors for successful tooth transplantation. In order to achieve these purposes, a duplicated donor tooth model can be utilized to reduce the extra-oral time using the computer-aided rapid prototyping (CARP) technique. MATERIALS AND METHODS: Briefly, a three-dimensional digital imaging and communication in medicine (DICOM) image with the real dimensions of the donor tooth was obtained from a computed tomography (CT), and a life-sized resin tooth model was fabricated. Dimensional errors between real tooth, 3D CT image model and CARP model were calculated. And extra-oral time was recorded during the autotransplantation of the teeth. RESULTS: The average extra-oral time was 7 min 25 sec with the range of immediate to 25 min in cases which extra-oral root canal treatments were not performed while it was 9 min 15 sec when extra-oral root canal treatments were performed. The average radiographic distance between the root surface and the alveolar bone was 1.17 mm and 1.35 mm at mesial cervix and apex; they were 0.98 mm and 1.26 mm at the distal cervix and apex. When the dimensional errors between real tooth, 3D CT image model and CARP model were measured in cadavers, the average of absolute error was 0.291 mm between real teeth and CARP model. CONCLUSIONS: These data indicate that CARP may be of value in minimizing the extra-oral time and the gap between the donor tooth and the recipient alveolar bone in tooth transplantation.