ABSTRACT
PURPOSE: The purpose of this study was to evaluate the biomechanical properties of a new anatomical locking metal block plate by comparing the initial biomechanical stability of three different fixation constructs for open wedge high tibial osteotomy (HTO). MATERIALS AND METHODS: Sawbones composite tibiae were used to make a 10-mm opening osteotomy model with uniplane technique. The osteotomy was secured with three different types of plates: Group I, new osteotomy plate without a metal block (n=5); Group II, new osteotomy plate with a 10-mm metal block (n=5); and Group III, two short metal block plates (n=5). Single load to failure test and staircase load-controlled cyclical failure test were performed. In the single load to failure test, the yield load, maximum failure load, and the displacement of the osteotomy gap were measured. In the staircase cyclical load to failure test, the total number of cycles to failure was recorded. Failure modes were observed during both single and cyclic load tests. RESULTS: Group II showed the highest yield and ultimate loads (1829+/-319 N, 3493+/-1250 N) compared to Group I (1512+/-157 N, 2422+/-769 N) and Group III (1369+/-378 N, 2157+/-210 N, p<0.05). The displacement of the opening gap in Group II (0.34+/-0.35 mm) was significantly lesser than the other groups (p<0.05). In the staircase cyclical load to failure test, the total number of cycles to failure was 12,860 at 950 N in Group III, 20,280 at 1,140 N in Group I, and 42,816 at 1,330 N in Group II (p<0.05). All the specimens showed complete fracture of the intact lateral sawbones area and slight displacement of the distal fragment of the specimens in the single load to test. None of the specimens showed deformed or broken screws and plates during the single load to test. During the fatigue test with staircase cyclic loading, no fracture of the lateral sawbones area was observed. CONCLUSIONS: This study demonstrated that the new anatomical locking metal block plate could provide sufficient primary stability for open wedge HTO. The addition of a metal block to this new plate can increase the stability of the osteotomy compared to the one without a metal block.
Subject(s)
Fatigue , Knee , Osteotomy , TibiaABSTRACT
PURPOSE: To analyze minimum 2-year clinical and radiological follow-up results of primary total knee replacement arthroplasty (TKRA) with metal block augmentation for tibial bony defect. MATERIALS AND METHODS: We analyzed 67 cases (52 patients) of primary TKRA with metal block augmentation for tibial bony defects from March 1999 and March 2008. Clinical results were evaluated using the Knee Society clinical rating system and the Western Ontario and McMaster University (WOMAC) score. Radiologic results were evaluated using the Knee Society roentgenographic evaluation system. RESULTS: The mean knee score and function score improved from 42.0 and 45.6 preoperatively to 94.5 and 85.4 postoperatively. At last follow-up, the mean WOMAC score was 16.8. The incidence of radiolucent lines was 10% (7 cases) during the follow-up period, but there was no case of progression. There were no statistically significant differences between the groups divided according to the block size (below 5 mm and over 8 mm) and between the stem and no-stem groups for all parameters. CONCLUSIONS: Primary TKRA with a metal block produced satisfactory results for the minimum 2-year follow-up and can be considered as a simple and effective method for the treatment of tibial bony defect in primary TKRA.