Explaining the Non-significant Changes in Ice-off Date over Six Decades at Lake of Bays and Lake Nipissing, South-Central Ontario

The phenomenon of non-significant trends in ice-off date under a warming climate was quantitatively explained by three efforts: exploring possible driving factors where possible and defining new factors to represent snow conditions, identifying the contributing factors through correlation and trend tests, and evaluating relative contributions through partial Mann-Kendall method. Why the ice-off became only slightly earlier over 62 years at Lake of Bays has been satisfactorily assessed: the increased winter temperature, increased total rain and decreased days of snow on ground acted as three promoting drivers to earlier ice-off date, but their promoting functions were effectively offset by adverse changes in four other factors (snowfall slope, precipitation slope, snowpack slope, and last day of snow). The ice-off date at Lake Nipissing did not have a significant trend over 58 years, although there were five factors contributing to the ice-off decline without sufficient offsetting, suggesting that the ice-off of this lake may not be sensitive, or basically elastic, to the climatic variation stressor. Relative contributions of drivers as calculated helped explain how much they contributed to ice-off trends or how much they offset the influences.

Algorithm for generating personalized external fixation model based on STL file / 国际生物医学工程杂志

Objective To study the generating algorithm of personalized external fixation model based on STL file, so as to realize the fabrication of personalized external fixation through 3D scanning, model generation and 3D printing. Compared with the traditional plaster fixation, the external fixation obtained by the proposed method has the advantages of good adhesion to the external surface of the limb, good gas permeability and light weight. Methods In order to generate a personalized external fixation model, the key generating algorithms of the model were studied. The point cloud file of the residual limb was obtained by a 3D scanner, and then was converted into an STL format file. The triangular patches were processed by cutting, offsetting, triangulating and hollowing to create an external fixation model with good gas permeability and conformable surface that is fully fitted with the body surface. Finally, the external fixation was fabricated by 3D printing. Results Using the improved point offset algorithm, the problem of severe distortion of the point offset at the plane and sharp corners was solved. Using the tangent sort method, the points on the contour ring were sorted clockwise to obtain a triangular profile. The hollowing of the model was achieved by using the typical three-dimensional "cutting tool" mathematical model and the STL file space intersection method. Conclusions The improved model generating algorithm was validated based on a wrist case, and the personalized external fixed fixation model with conformable surface was obtained. It is proved that the proposed model generating algorithm is effective and practical.