The Significance of Knowledge, Instructions, Habits and Denture Hygiene Practice in Relation to the Maintenance of Denture Hygiene at Hospital USM’s Dental Clinic

ABSTRACT@#Good denture hygiene is crucial for the prevention of various periodontal diseases, dental caries and dental stomatitis, which can give rise to a negative impact on the general health of denture users. A comparison exercise was conducted, to determine the effectiveness of information on denture care, provided by different groups of dental personnel. A self-administered and structured questionnaire was distributed to patients who attended Hospital USM’s dental clinics, from 2014 to 2019 based on the attendance register of the clinic. The denture hygiene status of 100 participants was assessed during the interview session. The results derived through the questionnaire revealed that 100% of the respondents, who received both verbal and written instructions, practiced good dental hygiene. It was observed that the most effective instructions received by the respondents were delivered by the dental specialists. Respondents, who clean their dentures with denture cleaning tablets, soap, or denture cleaning paste, were observed to possess better denture hygiene than those who do not. Also, respondents who visit their dentists once every six months for routine dental examinations boasted a higher percentage of good denture hygiene (81.8%). A positive association was perceived, between knowledge and the status of denture hygiene.

Evaluation of the effect of denture cleansers on the surface roughness of hard denture base material: An In vitro study

Maintaining the oral hygiene of denture wearers is a challenge faced in modern dentistry. Biofilm formed on dentures has been associated with denture stomatitis, malodor, aspiration pneumonia, infectious endocarditis, gastrointestinal infection, and chronic obstructive pulmonary disease. Objective: The purpose of this study was to evaluate the effect of denture cleansers on the surface roughness of hard denture base material. Materials and Methods: A total of 100 heat-cure acrylic resin specimens were fabricated with dimensions 30 mm × 15 mm × 3 mm in length, width, and thickness, respectively. All specimens were distributed into four groups randomly. Three commonly prescribed denture cleansers were used for immersion in this study. Regular tap water was used for immersion in the control group. Surface roughness was determined before immersion and after immersion in denture cleansing solutions using contact profilometer. The data were subjected to statistical analysis using paired t-test, one-way analysis of variance, and Tukey's multiple post hoc test. Results: The change in surface roughness of acrylic samples immersed in Clanden group was statistically significant (P < 0.05) at individual group level. However, the change in surface roughness of acrylic samples after immersion, when compared between the groups, namely, control, Clinsodent, Clanden, and Fittydent, was not statistically significant (P > 0.05). Conclusion: Within the limitation of this study, the three denture cleansing materials, namely, Clinsodent powder, Clanden tablet, and Fittydent tablet, are safe to be prescribed as denture cleansers.

Effect of denture cleansers on metal ion release and surface roughness of denture base materials

Chemical disinfectants are usually associated with mechanical methods to remove stains and reduce biofilm formation. This study evaluated the effect of disinfectants on release of metal ions and surface roughness of commercially pure titanium, metal alloys, and heat-polymerized acrylic resin, simulating 180 immersion trials. Disk-shaped specimens were fabricated with commercially pure titanium (Tritan), nickel-chromium-molybdenum-titanium (Vi-Star), nickel-chromium (Fit Cast-SB Plus), and nickel-chromium-beryllium (Fit Cast-V) alloys. Each cast disk was invested in the flasks, incorporating the metal disk to the heat-polymerized acrylic resin. The specimens (n=5) were immersed in these solutions: sodium hypochlorite 0.05%, Periogard, Cepacol, Corega Tabs, Medical Interporous, and Polident. Deionized water was used as a control. The quantitative analysis of metal ion release was performed using inductively coupled plasma mass spectrometry (ELAN DRC II). A surface analyzer (Surftest SJ-201P) was used to measure the surface roughness (µm). Data were recorded before and after the immersions and evaluated by two-way ANOVA and Tukey's test (α=0.05). The nickel release proved most significant with the Vi-Star and Fit Cast-V alloys after immersion in Medical Interporous. There was a significant difference in surface roughness of the resin (p=0.011) after immersion. Cepacol caused significantly higher resin roughness. The immersion products had no influence on metal roughness (p=0.388). It could be concluded that the tested alloys can be considered safe for removable denture fabrication, but disinfectant solutions as Cepacol and Medical Interporous tablet for daily denture immersion should be used with caution because it caused greater resin surface roughness and greater ion release, respectively.

Desinfetantes químicos são normalmente associados a métodos mecânicos para remover manchas e reduzir a formação do biofilme. Este estudo avaliou o efeito de desinfetantes na liberação de íons metálicos e na rugosidade superficial do titânio comercialmente puro, ligas metálicas e resina acrílica termopolimerizável, simulando 180 ensaios de imersões. Espécimes em formato de discos foram confeccionados com titânio comercialmente puro (Tritan), liga de níquel-cromo-molibdênio-titânio (Vi-Star), liga de níquel-cromo (Fit Cast-SB Plus) e liga de níquel-cromo-berílio (Fit Cast-V). Os espécimes (n=5) foram imersos nestas soluções: hipoclorito de sódio a 0,05%, Periogard, Cepacol, Corega Tabs, Medical Interporous e Polident. Como controle, foi utilizada a água deionizada. A análise quantitativa de liberação de íons metálicos foi realizada por meio de espectrometria de massa com plasma indutivamente acoplado (ELAN DRC II). O rugosímetro (Surftest SJ-201P) foi utilizado para medir a rugosidade superficial (µm). Os dados foram registrados antes e depois das imersões e avaliados por ANOVA com dois fatores e teste de Tukey (α=0,05). A liberação de níquel provou ser mais expressiva nas ligas Vi-Star e Fit Cast-V após a imersão em Medical Interporous. Houve diferença significante na rugosidade superficial da resina (p=0,011) após a imersão. O Cepacol causou maior rugosidade superficial de forma significativa. Os produtos de imersão não influenciaram nos resultados da rugosidade do metal (p=0,388). Pode-se concluir que as ligas metálicas testadas podem ser consideradas seguras para a fabricação de próteses removíveis, mas as soluções desinfetantes como o Cepacol e a pastilha Medical Interporous para a imersão diária da prótese devem ser utilizados com cautela, pois causaram maior rugosidade superficial da resina e maior liberação de íons, respectivamente.

A microbiological evaluation of the use of denture cleansers in combination with an oral rinse in complete denture patients.

Background and Aim : Patients with complete dentures more occasionally neglect their denture and oral health by improper maintenance of dentures, resulting in bad oral and denture hygiene. This may lead to a host of multiple local and systemic problems such as stomatitis, bacterial and fungal infections, reservoirs for distant infections, denture stains and bad breath. Most denture wearers maintain their dentures with simple manual cleansing methods, which are not adequate to effectively sanitize the reservoir of microorganisms inhabiting the denture surfaces. The aim of this study was to compare the efficacy of the use of a denture cleanser and compare it with an adjunct use of chlorhexidine mouth rinse along with the denture cleanser and possibly suggest it as a suitable protocol. Materials and Methods : Two groups of complete denture patients were selected for the study. The total number of patients in each group was 12 and the total period of the study was 21 days. Three sets of microbiological samples were collected from each patient: before the start of the study, on day 8 and on day 21 of the study. The first sample was collected after an initial washover period (7 days) with plain water before the start of the study and the second set after 1 week of study initiation, where group-1 followed protocol-I (denture cleanser only) and group-2 followed protocol-II (denture cleanser and mouth rinse). A second washout period of 7 days followed and a crossover of the protocol was performed for the groups and followed for 1 week. Then, a third set of samples were collected. The colony-forming units were calculated for each patient for each sample and statistically analyzed. Friedman test for non-parametric analysis was employed for the comparison within the groups and a Mann-Whitney test was used for the statistical comparison between the groups. Results : There was a definite reduction in the bacterial numbers and a significant statistical difference after administering the protocols in both the groups (P<0.001). However, there was little significance on comparing the samples between the groups (P=0.026) in the initial study period, and there was no statistical significance when comparing the groups after the crossover (P=0.140). Conclusion : The use of denture cleansers definitely reduced the microbial numbers as compared to plain manual cleansing methods in complete dentures. Although there was a substantial decrease in the bacterial colonies after the use of the mouthwash, it was not statistically significant.