ABSTRACT
Objective To study the effects of mechanical load on in vivo degradation performance of high-purity magnesium (HP Mg, 99.99 wt.%) quantitatively. Methods Cylindrical Mg specimens, with a 2 mm diameter and a 14 mm length, were mounted in polyetheretherketone (PEEK) rings to bear compressive stresses ［（6.2±0.6） MPa］, tensile stresses ［（4.6±0.1） MPa］ or no stress (as control). The specimens under different stress states were implanted subcutaneously in dorsal abdominal regions of SD rats for 4 weeks. The mass loss, residual volume and surface morphology of the specimens and staining of surrounding soft tissues were used to analyze the degradation rate of HP Mg. Results Specimens and rings were completely encapsulated by membranous tissues after implantation for 4 weeks. No significant differences in the degradation rates were noted between specimens bearing stress and the control. The corrosion layers of specimens under each stress state were uniform. Conclusions The compressive and tensile stresses (4-6 MPa) could not affect significantly HP Mg degradation performance in vivo. The research findings provide theoretical references for the design and clinical application of Mg-based degradable implants.
ABSTRACT
Objective:To evaluate the reliability of flexural strength and subcritical crack growth(SCG)of WL and HT zirconia ce-ramics under cyclic loading.Methods:Bar-shaped speciments of WL(n =30)and HT(n =30)were fabricated and loaded in three-point bending and cyclically fatigued.The flexural strength and the number of cycles to fracture were obtained from three-point flexural test and cyclic fatigue test respectively.Data were examined using Weibull statistics.Pairs law was used to analysize the subcritical crack growth(SCG),the behavior of which was described in terms of crack velocity as a function of maximum stress intensity factor (KImax ).Results:The Weibull module(m)of WL and HT was 10.64 and 12.04,the stress corrosion cracking susceptive indexes(n) 23.71 and 32.87,the SCG 90% and 76.7%,the KImax 49.6% and 50.9% of its maximum stress intensity factor(KIC ),respectively. Conclusion:WL and HT produce pronounced SCG.The minimum fatigue crack growth rate of HT is lower than that of WL(νHT <νWL ).