Analysis of comparative efficiencies of different transformation methods of E. coli using two common plasmid vectors.

The efficiencies of different transformation methods of E. coli DH5α strain, induced by several cations like Mg2+, Mn2+, Rb+ and especially Ca2+, with or without polyethylene glycol (PEG) and dimethyl sulfoxide (DMSO) were compared using the two commonly used plasmid vectors pCAMBIA1201 and pBI121. The widely used calcium chloride (CaCl2) method appeared to be the most efficient procedure, while rubidium chloride (RbCl) method was the least effective. The improvements in the classical CaCl2 method were found to further augment the transformation efficiency (TR)E for both the vectors like repeated alternate cycles of heat shock, followed by immediate cold, at least up to the third cycle; replacement of the heat shock step by a single microwave pulse and even more by double microwave treatment and administration of combined heat shock-microwave treatments. The pre-treatment of CaCl2-competent cells with 5% (v/v) ethanol, accompanied by single heat shock also triggered the (TR)E, which was further enhanced, when combined heat shock-microwave was applied. The minor alterations or improved approaches in CaCl2 method suggested in the present study may thus find use in more efficient E. coli transformation.

Factors affecting transformation efficiency of BCG with a Mycobacterium-Escherichia coli shuttle vector pYUB18 by electroporation

BCG has been one of the vehicles for multi-recombinant vaccine. However, low transformation efficiency of BCG with plasmid DNA hampered studies involving expression of foreign antigens in BCG. In an effort to determine the optimal conditions, this study was initiated to investigate factors involved in the transformation of BCG with a Mycobacterium-Escherichia coli shuttle vector, pYUB18, by electroporation. Mycobacterium bovis BCG (strain 1173P2) was grown in Middlebrook (M) 7H9 broth containing albumin-dextrose-catalase and 0.05% tween 80, and transformed BCG was grown in M7H10 agar containing kanamycin for counting viable cells. Pretreatment of BCG with 10 mM CaCl2 improved the transformation efficiency, but overnight incubation of BCG with 1% glycine did not. The transformation efficiency in BCG also varied depending on voltage, resistance, and DNA concentration. The maximum transformation efficiency was obtained when the infinity resistance, 12.5 Kv/cm, and 100 ng of DNA were used, and reached 1.4 x 10(5) CFU/microgram of plasmid DNA, which is about 3-100 times greater than those from previous reports. The transformation conditions described in this study, therefore, will give us a better position for employing BCG as a vehicle for developing multi-recombinant vaccines.