HPLC fingerprint of Tibetan medicinal plant ″Bangga″ and chemical components analysis of its two original plants by LC-MS/MS / 中国中药杂志

To obtain the chemical profile of Tibetan medicinal plant ″Bangga″, the present study established the HPLC fingerprint of ″Bangga″ and inferred common chemical constituents of its two original plants, Aconitum tanguticum and A. naviculare by LC-MS. The HPLC analysis was performed on a Kromasil 100 C_8 column(4.6 mm×250 mm, 5 μm) with acetonitrile(A)-0.1% formic acid in water(B) as mobile phase in a gradient elution mode. Besides, the flow rate was set at 1 mL·min~(-1) and the column temperature was 35 ℃. The detection wavelength was set at 255 nm and the injection volume was 10 μL. Seventeen batches of ″Bangga″ samples were analyzed and the HPLC fingerprint was established under the above conditions. Similarity evaluation was performed using Similarity Evaluation System for Chromatographic Fingerprint of Traditional Chinese Medicine(2012). As a result, 16 common peaks were selec-ted and the similarity values of 17 batches of ″Bangga″ were in the range of 0.702-0.966. Furthermore, one batch of A. tanguticum and one batch of A. naviculare were analyzed by LC-MS/MS and 74 common compounds were inferred, including 10 phenolic acids, 26 flavonoids, and 38 alkaloids. The established method, with good separation and strong specificity, is simple and feasible, and can be used for the quality control of ″Bangga″ and identification of its two original plants. A. tanguticum and A. naviculare are similar in chemical composition and component content, but are quite different in the content of flavonoids.

Effect of sclerostin on the functions and related mechanisms of cementoblasts under mechanical stress / 华西口腔医学杂志

OBJECTIVE@#The purpose of this study is to investigate the potential effects of sclerostin (SOST) on the biological funtions and related mechanisms of cementoblasts under mechanical stress.@*METHODS@#OCCM-30 cells were treated with varying doses of SOST (0, 25, 50, and 100 ng·mL⁻¹) and were loaded with uniaxial compressive stress (2 000 μ strain with a frequency of 0.5 Hz) for six hours. Western blot was utilized to detect the expressions of β-catenin, p-smad1/5/8, and smad1/5/8 proteins. Alkaline phosphatase (ALP) activity was determined, and reverse transcription polymerase chain reaction was used to measure the expressions of runt-related transcription factor 2 (Runx-2), osteocalcin (OCN), bone sialoproteins (BSP), receptor activator of NF-κB ligand (RANKL) and osteoprotegerin (OPG) mRNA.@*RESULTS@#The expression of p-smad
1/5/8 was significantly downregulated with increasing SOST. β-catenin and smad1/5/8 exhibited no difference. ALP activity decreased under mechanical compressive stress with increasing SOST concentrations. Runx-2 expression was reduced with increasing SOST concentrations, and a similar trend was observed for the BSP and OCN expressions. When the SOST concentration was enhanced, RANKL expression gradually increased, whereas the expression of OPG decreased.@*CONCLUSIONS@#Under mechanical comprehensive stress, SOST can adjust the bone morphogenetic protein (BMP) /smad signal pathway. Osteosclerosis inhibits the mineralization of cementoblasts under mechanical compressive stress, which may be achieved by inhibiting the expressions of osteogenesis factors (Runx2, OCN, BSP, and others) and by promoting the ratio of cementoclast-related factors (RANKL/OPG) through BMP signal pathways.