Résumé
Objective To make classification and segment measurement for the cases with tibiofibular and ankle fractures in parachuting landing, and investigate main classification types of parachuting fractures and fracture segments of high risk.Methods A total of 56 fracture cases in parachuting landing were collected, and the tibiofibula and ankle fractures were classified according to AO-OTA or Lauge-Hansen classification standards respectively based on their digital X-ray images. The medium plane between talus and tibia joint planes in ankle joint was defined as the reference plane. The highest and lowest injury points of tibia and fibula were marked respectively, and the fracture segment was defined between the highest and lowest point for statistical analysis.Results For tibiofibular and ankle fracture cases in parachuting landing, fracture at both tibia and fibula accounted for 80.4%. The major classification of tibiofibula fracture was 42-D/5.2 (45.8%) and 42-D/5.1 (16.7%). The major classification for ankle fracture was pronation-external rotation (PER, 59.4%) and supination-external rotation (SER, 37.5%). When tibiofibular and ankle fracture cases in parachuting landing occurred, the fracture segment of the tibia was mainly from 57 to 143 mm above the reference plane and from 6 mm below the reference plane to 24 mm above the reference plane, while the fracture segment of the fibula was 4-45 mm and 74-83 mm above the reference plane. Injury risks of all above segments were higher than 50%.Conclusions For protection of lower limbs in parachuting landing, the fracture at both tibia and fibula should be highly noticed. The ankle motion of PER and SER should be especially restricted in parachuting ankle protection.
Résumé
Objective To establish the finite element (FE) model of the anterior tibiofibular ligament injury by ankle fracture fixation, so as to compare the stress and deformation of the finite element model by using anchor-reinforced repair combined with screw fixation. Methods CT images of the ankle joint from a normal young male volunteer was selected to establish the FE model of the anterior tibiofibular joint injury by ankle fracture fixation. The injury models were divided into experimental group and control group, which were fixed by anchors or screws, respectively. The maximum stress distributions and the maximum deformation of the two models under various load conditions were observed through the FE analysis and calculation. Results Under the vertical load, the deformation of the experimental group was 6.8% higher than that of the control group. The deformation increased by 22.6% under external rotation load, while the deformation decreased by 5.1% under internal rotation load. Under the same load, differences in the maximum peak stress on the model between the control group and the experimental group was not significant. Due to the anchor fixation, the maximum stress of the experimental group were borne by the screw that fixed the distal tibial fracture, while the maximum stress of the control group was borne by strong fixation of the steel plate and the inferior tibiofibular screw. The maximum stresses on the anchor were distributed on the screw, and the suture mainly played the role of fixing. Conclusions The lower tibiofibular screw and anchor fixation could effectively treat the tibiofibular instability left by ankle fracture fixation. The anchor fixation dispersed the stress on the steel plate, and it showed greater ankle joint deformation ability while fixing the lower tibiofibula, so as to avoid the risk of broken nails.
Résumé
Objective: To determine the effectiveness and the safety of the Taylor spatial frame in treatment of intermediate or distal tibiofibula fractures. Methods: The clinical data of 74 patients with intermediate or distal tibiofibular fractures treated between January 2015 and January 2017 were retrospectively analyzed. According to fixation methods, they were divided into internal fixation group (26 cases) and external fixation group (48 cases). There was no significant difference in the age, gender, cause of injury, type of fracture, time from injury to operation between 2 groups ( P>0.05). The intraoperative blood loss, fracture healing time, fixator removal time, and complications were recorded and compared. The final function evaluation criteria of Johner-Wruhs humeral shaft fracture were used to evaluate the function of the affected limb. The lower limb force line recovery after operation was evaluated according to the standard evaluation of LUO Congfeng et al. Results: Both groups were followed up 6-22 months (median, 14 months). All patients obtained the fracture healing. The intraoperative blood loss, fracture healing time, and fixator removal time were significantly higher in the internal fixation group than those in the external fixation group ( P<0.05). There were 1 case of plate exposure, 1 case of delayed fracture healing, and 1 case of plate fracture in the internal fixation group; and there were 2 cases of delayed fracture healing and 4 cases of soft tissue defect in the external fixation group; no significant difference was found in the incidence of complications between 2 groups ( χ2=0.015, P=0.904). The function of the affected limb was evaluated by Johner-Wruhs standard at 10 months after operation, the results was excellent in 19 cases, good in 5 cases, and fair in 2 cases in the internal fixation group, with an excellent and good rate of 92.3%; the results was excellent in 42 cases, good in 3 cases, and fair in 2 cases in the external fixation group, with an excellent and good rate of 95.7%; showing no significant difference between 2 groups ( χ2=0.392, P=0.531). The lower limb force line recovery after operation was evaluated according to the standard evaluation of LUO Congfeng et al.at 4 months after operation, the results was excellent in 24 cases, fair in 1 case, poor in 1 case in the internal fixation group, with an excellent and good rate of 92.3%; the results was excellent in 46 cases, fair in 1 case, poor in 1 case in the external fixation group, with an excellent and good rate of 95.8%; showing no significant difference between 2 groups ( χ2=0.520, P=0.471). Conclusion: The use of Taylor spatial frame in the treatment of the intermediate or distal tibiofibular fractures can obviously reduce the healing time and complications than the internal fixation of the plate. It can reduce the fracture treatment cycle and is beneficial to the fracture healing and limb function recovery, which is relatively safe and reliable.
Résumé
Purpose: Tibial torsion is the external rotation of the distal tibia in comparison with the proximal tibia. Rotational deformity of the tibia as a complication of tibial shaft fracture means the loss of tibial torsion. Therefore, evaluating the torsion or the rotation of the distal tibia is the first step in reducing the rotational deformity of the tibia. There are two methods for evaluating the tibial torsion, a method with CT and a method with C-arm. In both methods, the anatomical landmark for evaluation is most important. The ratio of the tibiofibular overlap and fibula width (Tibiofibular Overlap Ratio) is a landmark commonly used to evaluate the tibial torsion. Materials and Methods: The tibial torsion angle and Tibiofibular Overlap Ratio of both legs in 79 cases (48 males and 31 females; mean age 46.2 years) were measured and compared. These 79 cases received 2-D CT of the knee and ankle of both legs. To evaluate the prediction for neutral rotation of the tibia using the contralateral tibia-fibula image, 20 orthopedic residents and nurses were asked to select the same rotational tibia image among the 31 rotational 3-D CT images from 15o external rotation to 15degrees internal rotation in comparison with the mirror image. Results: There was no significant between the comparisons of the tibia torsion angle and Tibiofibular Overlap Ratio in both legs in the 79 cases. Ten orthopedic residents were able to predict the tibia rotational angle within an external rotation of 3degrees and internal rotation of 3degrees. Ten nurses were able to predict the tibia rotational angle within an external rotation of 5degrees and internal rotation of 5degrees. Conclusion: The Tibiofibular Overlap Ratio may be the simple and useful method for predicting the neutral rotation of the tibia.
Sujets)
Femelle , Humains , Mâle , Cheville , Malformations , Fibula , Genou , Jambe , Orthopédie , TibiaRésumé
Objective To discuss clinical results of the treatment of op en tibio-fibula fractures with the intramedullary interlocking nails. Methods A group of 46 cases of open tibio-fibula fractures was collected and classified according to Gustilo classification. There were 12 cases of type Ⅰ, 9 cases of type Ⅱ, 16 cases of typeⅢA, 7 cases of type ⅢB, and 2 case of type ⅢC. All o perations were performed in the emergency operation room and all patients were f ixed with intramedullary interlocking nails. Results The follow-up of 8 months to 3 years (with an average of 20 months) showed satisfactory results, though th e local wounds needed skin flap transplantation in 6 cases and muscle flap trans plantation was performed in 1 case. Conclusion Open tibio-fibula fractures of t ype Ⅰ, type Ⅱ and type ⅢA can be treated with emergency debridement and the intramedullary interlocking nails, if the injury duration is short and the vital signs of the patients are stable.