Novel experimental cements for use on the dentin-pulp complex

This aim of this study was to evaluate the physicochemical and biological properties of novel experimental cements (Hybrid, Paste and Resin) based on synergistic combinations of existing materials, including pH, diametral tensile strength (DTS) and cytotoxicity comparing them with mineral trioxide aggregate (MTA - Angelus®) and a glass ionomer cement (GIC) developed at our laboratory. For the physicochemical and biological tests, specimens with standard dimensions were produced. pH measurements were performed with digital pH meter at the following time intervals: 3, 24, 48 and 72 h. For the DTS test, cylindrical specimens were subjected to compressive load until fracture. The MTT assay was performed for cytotoxicity evaluation. Data were analyzed by ANOVA and Tukey's test (α=0.05). Paste group showed pH values similar to MTA, and Hybrid group presented pH values similar to GIC (p>0.05). The tested materials showed pH values ranging from alkaline to near neutrality at the evaluated times. MTA and GIC showed similar DTS values. The lowest and highest DTS values were seen in the Paste and Resin groups, respectively (p<0.05). Cell viability for MTA and experimental Hybrid, Paste and Resin groups was 49%, 93%, 90% and 86%, respectively, when compared with the control group. The photo-cured experimental resin cement showed similar or superior performance compared with the current commercial or other tested experimental materials.

O objetivo deste estudo foi avaliar propriedades físico-químicas e biológicas de novos cimentos experimentais (Híbrido, Pasta e Resinoso) baseado na combinação sinérgica de materiais existentes, incluindo pH, resistência à tração diametral (RTD) e citotoxidade, comparando-os ao MTA (Angelus®) e a um cimento de ionômero de vidro (CIV) desenvolvido em nosso laboratório. Para a realização dos testes físico-mecânico e biológico, foram confeccionados espécimes com dimensões padrão. O teste de pH foi realizado por meio de pH-metro digital nos tempos: 3, 24, 48 e 72 h. Para o teste de RTD, espécimes cilíndricos foram submetidos a carga compressiva até sua fratura. Para avaliação da citotoxidade, utilizou-se o teste MTT. Os dados foram analisados utilizando ANOVA e teste de Tukey (α=0,05). O grupo Pasta apresentou valores de pH semelhantes ao MTA, assim como o grupo Híbrido seguiu os parâmetros do CIV (p>0,05). Todos os materiais apresentaram valores de pH alcalinos ou próximosà neutralidade nos tempos avaliados. MTA e CIV apresentaram valores de RTD similares. Os menores e maiores valores observados foram do grupo Pasta e Resinoso, respectivamente (p<0,05). A viabilidade celular para os grupos MTA, Híbrido, Pasta, Resinoso, quando comparados ao grupo controle foi de: 49, 93, 90 e 86%, respectivamente. O cimento experimental Resinoso apresentou desempenho similar ou superior aos materiais comerciais e experimentais avaliados.

Influence of thicknesses of smear layer on the transdentinal cytotoxicity and bond strength of a resin-modified glass-ionomer cement

This study evaluated the transdentinal cytotoxicity (TC) and the bond strength (BS) of a resin-modified glass-ionomer cement (RMGIC) applied to dentin covered with smear layer (SL) of different thicknesses. Forty dentin discs had thick (TSL) or thin (THSL) smear layer created on their occlusal side. In artificial pulp chambers, MDPC-23 cells were seeded on the pulpal side of the dentin discs and divided into five groups: G1TC: no treatment (control); G2TC: TSL + RMGIC; G3TC: THSL + RMGIC; G4TC: TSL removal + RMGIC; G5TC: THSL removal + RMGIC. After 24 h, cell metabolism and morphology were evaluated by the methyltetrazolium (MTT) assay and by scanning electron microscopy (SEM), respectively. For BS, the following groups were determined: G1BS: TSL removal + RMGIC; G2BS: THSL removal + RMGIC; G3BS: TSL + RMGIC; G4BS: THSL + RMGIC. Shear bond strength was tested to failure in a mechanical testing machine MTS (0.5 mm/min). Statistically significant difference was observed only between the control and experimental groups (Kruskal-Wallis, p<0.05). The metabolic activity of the viable MDPC-23 cells in G2TC, G3TC, G4TC and G5TC decreased by 54.85%, 60.79%, 64.12% and 62.51%, respectively. Mean shear bond strength values for G1BS, G2BS, G3BS and G4BS were 7.5, 7.4, 6.4 and 6.7 MPa, respectively, without significant difference among them (ANOVA, p>0.05). RMGIC presented moderate transdentinal cytotoxic effects. Maintenance or removal of smear layer did not affect the bond strength of RMGIC to dentin substrate.

Este estudo avaliou a citotoxicidade transdentinária (CT) e a resistência de união (RU) de um cimento de ionômero de vidro modificado por resina (CIVMR) aplicado sobre dentina coberta com smear layer (SL) de diferentes espessuras. Quarenta discos de dentina tiveram smear layer espessa (TSL) ou delgada (THSL) criadas sobre a superfície oclusal. Após terem sido posicionados em câmaras pulpares artificiais, os discos de dentina receberam células MDPC-23, as quais foram semeadas sobre a supefície pulpar. Assim, os seguintes grupos foram estabelecidos: G1TC: sem tratamento (controle); G2TC: TSL + CIVMR; G3TC: THSL + CIVMR; G4TC: remoção TSL + CIVRM; G5TC: remoção THSL + CIVMR. Após 24 h, o metabolismo e morfologia celular foram avaliados pelo ensaio de metiltetrazolium (MTT) e por microscopia eletrônica de varredura (MEV), respectivamente. Para BS, os seguintes grupos foram determinados: G1BS: remoção TSL + CIVRM; G2BS: remoção THSL + CIVRM; G3BS: TSL + CIVRM; G4BS: THSL + CIVMR. A resistência de união ao cisalhamento foi avaliada em uma máquina de ensaios mecânicos MTS (0,5 mm/min). Diferença estatisticamente significativa foi observada apenas entre os grupos controle e experimentais (Kruskal-Wallis, p<0,05). A redução da atividade metabólica das células MDPC-23 viáveis nos grupos G2TC, G3TC, G4TC e G5TC foi de 54,85%; 60,79%; 64,12%; e 62,51%, respectivamente. Os valores médios de resistência de união para G1BS, G2BS, G3BS e G4BS foram de 7,5; 7,4; 6,4; e 6,7 MPa, respectivamente, sem diferença significativa entre eles (ANOVA, p>0,05). O CIVMR avaliado neste estudo apresentou moderado efeito citotóxico transdentinário. A manutenção ou remoção da smear layer não afetou a resistência de união deste material resinoso ionomérico sobre a dentina.

Effect of reduced exposure times on the cytotoxicity of resin luting cements cured by high-power led

OBJECTIVE: Applications of resin luting agents and high-power light-emitting diodes (LED) light-curing units (LCUs) have increased considerably over the last few years. However, it is not clear whether the effect of reduced exposure time on cytotoxicity of such products have adequate biocompatibility to meet clinical success. This study aimed at assessing the effect of reduced curing time of five resin luting cements (RLCs) polymerized by high-power LED curing unit on the viability of a cell of L-929 fibroblast cells. MATERIAL AND METHODS: Disc-shaped samples were prepared in polytetrafluoroethylene moulds with cylindrical cavities. The samples were irradiated from the top through the ceramic discs and acetate strips using LED LCU for 20 s (50 percent of the manufacturer's recommended exposure time) and 40 s (100 percent exposure time). After curing, the samples were transferred into a culture medium for 24 h. The eluates were obtained and pipetted onto L-929 fibroblast cultures (3x10(4) per well) and incubated for evaluating after 24 h. Measurements were performed by dimethylthiazol diphenyltetrazolium assay. Statistical significance was determined by two-way ANOVA and two independent samples were compared by t-test. RESULTS: Results showed that eluates of most of the materials polymerized for 20 s (except Rely X Unicem and Illusion) reduced to a higher extent cell viability compared to samples of the same materials polymerized for 40 s. Illusion exhibited the least cytotoxicity for 20 s exposure time compared to the control (culture without samples) followed by Rely X Unicem and Rely X ARC (90.81 percent, 88.90 percent, and 83.11 percent, respectively). For Rely X ARC, Duolink and Lute-It 40 s exposure time was better (t=-1.262 p=0,276; t=-9.399 p=0.001; and t=-20.418 p<0.001, respectively). CONCLUSION: The results of this study suggest that reduction of curing time significantly enhances the cytotoxicity of the studied resin cement materials, therefore compromising their clinical performance.

L929 cell response to root perforation repair cements: an in vitro cytotoxicity assay

This study compared the cytotoxicity of an experimental epoxy-resin and calcium hydroxide-based cement (MBPc), gray mineral trioxide aggregate (MTA) and white mineral trioxide aggregate (WMTA) using the agar overlay method with neutral red dye. L929 cells were seeded into 6-well culture plates where 48-h set test materials were placed on the agar overlay, in triplicate. Teflon and natural rubber served as negative and positive controls. After an incubation period of 24 h at 37ºC in a humidified atmosphere of 5 percent CO2 in air, a discolored area around the samples and the positive controls could be observed and measured per quadrant. The mean values were compared and converted into grades to classify the results according to the table of cytotoxicity grades according to the Standard Operating Procedures (SOP) of the Oswaldo Cruz Foundation, Brazil. The nonviable cell areas and the morphological changes in the cells were observed with an inverted microscope. The results showed grade 1 (slight) for the two types of MTA (p>0.05) and grade 2 (mild) for the MBPc (p<0.001). All samples met the requirements of the test as none of the cultures showed reactivity higher than grade 2.

O objetivo deste estudo foi comparar a citotoxicidade de um cimento experimental à base de resina epóxica e hidróxido de cálcio (MBPc), do agregado trióxido mineral (MTA) cinza e do MTA branco, utilizando o ensaio de difusão em agar com o corante vermelho neutro. Células L929 foram semeadas em placas de 6 poços e sobre elas a camada de agar, onde foram colocados os materiais endurecidos por 48 h, em triplicata, além de teflon como controle negativo e látex como controle positivo. Após 24 h em estufa umidificada a 37ºC com 5 por cento CO2, um halo claro se formou ao redor das amostras e dos controles positivos. As medidas foram tomadas, por quadrante, e as médias foram comparadas e convertidas em graus para qualificar os resultados, de acordo com a tabela de grau de citotoxicidade do POP/FIOCRUZ. As zonas de inibição e as alterações da morfologia celular foram avaliadas sob microscópio invertido. Os resultados revelaram grau 1 (leve) para os dois tipos de MTA (p>0,05) e grau 2 (branda) para o MBPc (p<0,001). Todas as amostras foram consideradas satisfatórias, pois nenhuma cultura exposta aos cimentos revelou toxicidade superior ao grau 2.