RESUMO
ObjectiveTo develop a quantitative analysis of multi-components by single marker （QAMS） for determination of bufalin， cinobufagin and resibufogenin in Shexiang Baoxin pills， and to provide a method for improving the national standard of the pills. MethodHigh performance liquid chromatography （HPLC） was developed for simultaneous determination of bufalin， cinobufagin and resibufogenin in Shexiang Baoxin pills and the methodology validation was carried out. The chromatographic separation was performed on a Nucleosil 100-5 C18 column （4.6 mm×250 mm， 5 μm） with the mobile phase of acetonitrile -0.1% potassium dihydrogen phosphate aqueous solution （pH adjusted to 3.2 with phosphoric acid） （48∶52）， and the flow rate was 0.6 mL·min-1， the detection wavelength was set at 296 nm and the column temperature was 35 ℃. Taking cinobufagin as the internal standard， the relative correction factors （RCFs） of bufalin and resibufogenin were calculated， and the key influencing factors of RCFs were investigated. Relative retention time was used for the chromatographic peak location of the analyte， combining with the on-line ultraviolet spectroscopy and accurate relative molecular weight obtained by ultra-performance liquid chromatography-quadrupole time-of-flight mass spectrometry （UPLC-QTOF/MS）. The external standard method was used to verify the contents of three components obtained by QAMS. ResultQAMS was established for the determination of bufalin， cinobufagin and resibufogenin in the samples， and RCFs of cinobufagin to bufalin and resibufogenin were 0.922 and 1.01， respectively. The total content of the three marker compounds in 11 batches of Shexiang Baoxin pills was 33.7-36.0 µg per pill. There was no significant difference between the quantitative results of QAMS and external standard method. ConclusionThe established method can be used for the quality control of bufalin， cinobufagin and resibufogenin in Shexiang Baoxin pills. It is suggested that bufalin should be considered as one of three marker compounds， and the sum of bufalin， cinobufagin and resibufogenin should be used for the content limit of this preparation.
RESUMO
Qualitative and quantitative methods were used to establish the quality of different medicinal parts of Poria cocos (Poriae Cutis, rubra Poria, white Poria, Poria cum Radix Pini) by using ultra-performance convergence chromatography coupled with photo-diode array and quadrupole time-of-flight mass spectrometry (UPC2-PDA-Q-TOF/MSE). A total of 18 chromatographic peaks were detected from Poria cocos by UPC2-PDA. Principal component analysis (PCA) and partial least squares discriminant analysis (PLS-DA) were used to compare the four medicinal parts. The results showed that there were significant differences in the components of different medicinal parts, and the main triterpenoic acids were poricoic acid A, poricoic acid B, dehydroeburicoic acid, and dehydrotrametenolic acid. When combined with the common active component polyporenic acid C, a method for determination of five triterpenoic acids in different parts of Poria cocos was established. These components could be separated within 15 min, and the amount of methanol was 3.63% of that of HPLC method. Taking the five triterpenoid acids as an index, the content of triterpenoid acids in different parts of Poria cocos from high to low were Poriae Cutis, rubra Poria, white Poria and Poria cum Radix Pini. The method is simple, rapid, and uses minimal solvent. The mobile phase of environment-friendly gas carbon dioxide has unique advantages in reducing environmental pollution, which can provide a basis for the development and standard formulation of Poria cocos and its related products.