RESUMO
Oral squamous cell carcinoma (OSCC) is one of the most debilitating cancers in the world and while its causes have been heavily researched, the outcome remains grim. Most of these cancers are identified in the late stage and as a result treatment options are limited. Therefore, researchers have focused their efforts on recognizing and identifying dysplastic tissue that has an increased chance of progressing to cancer. Research has begun to look at cell cycle dysfunctions and in particular, aberrant protein functions as a way of identifying the cellular mechanism at fault. The overexpression of a group of regulatory proteins called cyclins has been demonstrated in many types of dysplasia and carcinomas. Although researchers have identified several different types of cyclins as potential culprits, we chose to focus our study primarily on the overexpression of cyclin A. While most research on oral dysplasia and OSCC has been focused on cyclin D, studies have been done on cyclin A. While the etiology of oral dysplasia/SCC appears to be multifactorial, we chose to compare our results with those of similar studies performed across the globe. The social factors, such as the increased use of tobacco that may have contributed to our results, were compared with similar studies performed in Europe and Asia. While our results were remarkably similar and demonstrated a link between the overexpression of cyclin A in oral dysplasia, there exists some differences and thus may require a multicenter, longitudinal study.
RESUMO
Purpose: The aim of this study is to investigate the presence and the extent of a possible marginal gap after the interposition of a flowable composite between the composite restoration and the dental structures (enamel and cementum). This technique is also used to eliminate the infiltration in a zone of the cavity preparation that is frequently at a risk of secondary decay. Materials and Methods: Fifteen human premolars extracted for orthodontic reasons were used for the study. A cavity with mesial and distal margin in enamel and cementum was realized in every tooth. The cavities were then restored with an adhesive system (ScotchBond 3MÔ) and composite (Filtek Supreme 3MÔ); and, a fine layer of flowable composite was applied in the distal margin of each cavity. Scanning electron microscopy (SEM) in secondary electron imaging (S.E.I.) modality was used for the study and identifying the marginal gaps in the composite restorations. Data was investigated on the mesial and distal margin of each cavity at the restoration-enamel interface, and at the restoration-cementum interface. The interfaces were divided in four groups: Group A (enamel/composite); Group B (enamel/flow/composite); Group C (cementum/composite); and, Group D (cementum/flow/composite). Results: By the comparison of the gap's average width found in each group, it is evidenced that the average width of the gap increases when the interface moves from the coronal to the radicular end (Group A 0,1 ± 0,4 μm Vs Group C 12,3 ± 11,6 μm; Group B 0,2 ± 0,8 μm Vs Group D 2,8 ± 6,6 μm). Correlating the measurements of the marginal gap's average width among the Group A and Group B, no significant variations were obtained; and instead, on comparing Group C with Group D, the gap's average width decreases. Conclusion: The interposition of a low elastic modulus composite between the adhesive layer and the composite resin allows an improvement of the cementum-restoration interface by the means of a lower shrinkage stress during polymerization.