Research progress on the effect mechanism of acupuncture-moxibustion for pressure injuries / 中国针灸

Evidence shows that acupuncture-moxibustion could promote the healing of pressure injuries (PI), but its action mechanism is not fully understood. This review summarizes the basic research literature of acupuncture-moxibustion for PI and identifies that the mechanism of acupuncture-moxibustion for PI is related with regulation of related signaling pathway target proteins, improvement of inflammatory response, modulation of vascular microenvironment, attenuation of oxidative stress damage, and inhibition of cell apoptosis. The review also points out the current limitations and future research directions. It emphasizes the need for further exploration of the upstream regulatory mechanism, specific cellular molecules, and the interactions among these molecules. A multi-level, multi-target, and multi-dimensional approach is required to fully understand the mechanism underlying the promotion of PI healing by acupuncture-moxibustion.

Analgesic mechanism of acupuncture on neuropathic pain / 中国针灸

The research progress of acupuncture analgesia in recent years is analyzed to summarize the analgesic mechanism of acupuncture on neuropathic pain. The analgesic mechanism of acupuncture on neuropathic pain is discussed from peripheral level and central level, including peripheral sensitization and immune inflammatory response, changes of ion channel, central sensitization, regulation of cell signal pathway, activation of spinal glial cells, etc. It is suggested that the focus of future research should include conducting in-vitro studies with the help of multi-omics technology to detect the changes of metabolic substances and signal pathway molecules in patients with neuropathic pain before and after acupuncture to further clarify the mechanism of acupuncture analgesia.

Effects of tension relaxation by small needle knife on muscle tension and nerve endings after compression of gracilis muscle in rats / 中国骨伤

<p><b>OBJECTIVE</b>To determine the effect of tension relaxation by small needle knife on the muscle tension and morphology changes of nerve terminals when sustained pressure was applied to muscular tissue.</p><p><b>METHODS</b>Rat gracilis muscles were exposed to pressure in vivo at 70 kPa for 2 hours. Sixty rats were divided into three groups: normal, control and experiment group respectively. In all rats except the six normal ones, the lower legs were considered as the control group, and the right left as experiment group. At day 1, 2 and 3, 9 rats from the two groups were randomly selected and sacrificed in order to determine the muscle tension change. At the same time, muscle histology and morphology changes of nerve terminals were observed.</p><p><b>RESULTS</b>Abnormal tension increased in muscles under compression of 70 kPa. At the 1st and 2nd days, there were no significant differences between the two groups. Compared with control group, the tension was lower in experiment group, and there was statistically significant difference (P < 0.01) between the two groups. Exposure of striated muscle tissue to intensive and prolonged compression may pathologically alter its microstructure. Histological evaluation showed that this stiffening accompanied extensive necrotic damage. The changes could not be found in the nerve terminals.</p><p><b>CONCLUSION</b>Deep muscle tissue that undergoes prolonged compression may significantly increase its stiffness during acute injury. Tension relaxation applied by small needle knife can effectively reduce the mechanical load which is harmful to the whole tissue.</p>

Effects of small needle knife on the substance P in the dorsal root ganglion and spinal cord of rats / 中国骨伤

<p><b>OBJECTIVE</b>To study the mechanism of synthesis of substance P (SP) in the dorsal root ganglion (DRG) and the release of it in the dorsal horn of the spinal cord of rats after compression of skeletal muscle, and to observe the influence of small needle knife.</p><p><b>METHODS</b>Sustained pressure of 70 kPa was applied to rats, muscular tissues for 2 hours. The rats were divided into three groups: normal, control and experiment group respectively. In all rats except the six normal ones, the lower legs were compressed once one day. The left leg was considered as the control group, the right left was experiment group, which were divided into the 1st day, the 2nd day and the 3rd day within the two groups. Experiment group was treated with small needle knife after the muscular tissue was compressed. After completing the stimulation, the DRG related to the muscle and part of spinal cord were removed for the qualification of SP-like immunoreactivity using immunohistochemistry. The dark brown stains on the DRG and on the REXed laminae I and II in the dorsal horn of the spinal cord were counted by Image-Pro Plus software.</p><p><b>RESULTS</b>SP-like immunoreactivity in the side treated by the small needle knife was enhanced comparing with the counterpart in DRG in normal group (P < 0.01). The integrated optical density of SP like immunoreactivity of the DRG in the experiment group were significantly reduced compared with the control group (P < 0.05). However, the release of SP from spinal cord in experiment group was lower than that in the control group at the 1st day and the 3rd day (P < 0.01), with the opposite result of the 2nd day.</p><p><b>CONCLUSION</b>Based on the fact that SP is a nociceptive neurotransmitter, the present study suggests that tension relaxation by small needle knife reduces expression of SP in the DRG, and shows no effects on the release of SP from the spinal cord in short-term (3 days).</p>

The influence of rotary manipulation on the internal pressure of cervical nucleus pulposus / 中国骨伤

<p><b>OBJECTIVE</b>To measure the pressure changes inside the cervical nucleus pulposus in fresh human cervical specimen by imitating different rotary manipulations.</p><p><b>METHODS</b>The load of 100 N was applied for 5 second on the six fresh male cervical samples by using material test system, which imitated the human head weigh and the strength of cervical extensor muscle. After that, traction, rotation and pulling on the samples were performed in different sequence under the force of 150, 200, 300 N respectively. Three states were included in adding the load state A: samples were loaded with traction and then rotation to the biggest angle, pulling backward for 15 degrees; state B: samples were loaded with rotary stress to the biggest angle and then loaded with traction, pulling backward for 15 degrees; state C: samples were loaded simultaneously with traction and rotary stress to the biggest angle, pulling backward for 15 degrees. The internal pressure of cervical nucleus pulposus at segment of C(3,4), C(4,5), C(5,6), and C7 was measurred by micro-pressure sensors for state A, B, C and for the imitation of head weight and the strength of cervical extensor muscle.</p><p><b>RESULTS</b>The pressure inside the cervical nucleus pulposus at segments C(5,6), C(6,7) was higher than that at segments C(3,4) and C(4,5) (P < 0.05) by loading stress with 100 N for 5 seconds. The internal pressure of the nucleus pulposus decreased with the increase of traction (P < 0.05), and increased when traction and rotary force were loaded. State A, the value of increased pressure within the nucleus pulposus became smaller and smaller while increasing of the traction force loaded (P < 0.05). State B, the increase of internal pressure in nucleus pulposus became obvious as loading pressure increased (P < 0.05). State C, the internal pressure in nucleus pulposus was not increased obviously (P > 0.05). There was a transitional pressure raise inside all cervical nucleus pulposus when pulling added after different sepuence traction and rotary strength was applied, however, the internal pressure of state A was significantly higher than that of state B or C (P < 0.05). There was also a transitional pressure raise inside all cervical nucleus pulposus when pulling added in different strength (P < 0.05),the internal pressure by pulling with 150 N was obviously higher than that with 200 N and 300 N (P < 0.05).</p><p><b>CONCLUSION</b>The order of rotation first and traction second should be avoided when practice of rotary manupuplation in case protrusion of the nucleus pulposus. Meanwhile, proper traction should be applied along with rotary manipulation in order to increase its safety.</p>

Randomized control clinical study on third lumbar transverse process syndrome treated by knife needle / 中国骨伤

<p><b>OBJECTIVE</b>To evaluate the therapeutic effects of knife needle on third lumbar transverse process syndrome.</p><p><b>METHODS</b>From 2007.3 to 2007.12, patients were divided into treatment group and control group according to the random digits table, 34 and 35 patients respectively. Patients in both groups were separately treated for 3 weeks, with knife needle in treatment group and electroacupuncture in control group. In treatment group, 12 patients were male and 22 patients were female, the average age was (42.33 +/- 7.86) years. In control group, 16 patients were male and 19 patients were female, the average age was (44.73 +/- 10.34) years. The changes of biomechanics, local tension and tenderness index were observed and recorded respectively before and after the therapy, and the results obtained from two groups were then compared with each other. The JOA score was used to evaluate the clinical effect.</p><p><b>RESULTS</b>Sixty patients finished the clinical observation. The treatment efficacy was evaluated according to the JOA score in 60 cases. The soft tissue tension in treatment group was lower than that in the control group (P=0.00004). Excellent result was found in 18 cases, good in 9 cases, fair in 3 cases and poor in 0 case.</p><p><b>CONCLUSION</b>Tension relaxation by needle knife can effectively improve the clinical symptoms and signs of third lumbar transverse process syndrome.</p>

Application of ultrasonic microscopy in biomechanical properties measurement of cancellous bone / 中国骨伤

<p><b>OBJECTIVE</b>Ultrasound scanning can provide the information of acoustic impedance through the ultrasonic reflection theory. This study tries to introduce the application of the ultrasonic technique in predicting biomechanical properties of cancellous bone.</p><p><b>METHODS</b>The rat femoral head embedded in plexiglass was used as the bone specimens for ultrasound scanning and the gray scale images scanned by ultrasound microscope were collected and analyzed.</p><p><b>RESULTS</b>The value of acoustic impedance was calculated by analyzing the gray scale image.</p><p><b>CONCLUSION</b>The application of ultrasonic microscopy can show more value about the microstructure of biomechanical properties of bone tissue.</p>

Factors of influence on quality evaluation of adhesive property on cataplasma / 中国中药杂志

<p><b>OBJECTIVE</b>To provide experimental proof for establishing a standard quality evaluation method of adhesive property on Cataplasma by studying the factors of effect on evaluation of adhesive quality on Cataplasma.</p><p><b>METHOD</b>With 180 degrees peel off test, tensile shear and adhesive force test, the influence caused by the square of samples, texture of fabric base and the moisture loss was tested with multifunctional material tester and first stickiness tester.</p><p><b>RESULT</b>The peel off strength of 40 mm wide sample is 26% lower than that of the 20 mm wide sample (P < 0.05), and tensile shear strength had no significant difference. The peel off strength of transverse fabric base was higher than that of lengthways fabric base (P < 0.01). The tensile shear strength of transverse fabric base was lower than that of lengthways fabric base (P < 0.05). The sample with 35% moisture lost had a maximum tensile shear strength and the sample which lost 30% moisture lost had a maximum peel off strength; The sample which lost 20% moisture lost had a maximum first adhesive force.</p><p><b>CONCLUSION</b>The square of samples, the texture of fabric base and the moisture loss of samples can all affect the evaluation of adhesive quality on Cataplasma.</p>