RESUMO
[Objective]The purpose of this study was to gain a clear understanding of adverse events associated with acupuncture (Acp) and moxibustion (Mox) therapies. Thus, we administered questionnaires to orthopedists in order to understand the clinical experience of patients who suffered adverse events.<BR>[Materials and Methods]For this study, 6,000 orthopedic hospitals and clinics were randomly selected from 13,225 hospitals and clinics listed in the telephone directory iTown Page (http://itp.ne.jp). In October 2011 and July 2012, 3,500 and 2,500 questionnaires, respectively, were sent by mail. The questions addressed the following:(1) the respondent's profile (e.g., years of experience as a licensed orthopedist);(2) adverse events associated with Acp, including electroacupuncture;(3) adverse events associated with Mox;(4) use of Acp and Mox therapies in the orthopedist's hospital or clinic;(5) comments on the safety of Acp and Mox therapies. The identity of respondents remained secret.<BR>[Results]The questionnaire response rate was 10.7%. The respondents were licensed orthopedists for 30 ± 11 years (mean ±standard deviation). Adverse events associated with Acp included retained needles and needle breakage (n ≥148), hemorrhages (n ≥ 64), infections (n ≥ 40), organ injuries (n = 28), and so on. Retained needles (≥ 145 out of 148), subcutaneous hemorrhages (63out of 64), arthritis (17 out of 40), and pneumothorax injuries (27 out of 28) occurred most frequently. The adverse events associated with Mox were burn injuries (n ≥ 121), infections (n ≥ 16), and other adverse events (n = 2). Second-degree burn injuries (n ≥ 48 out of 121) and suppuration infections (11 out of 16) occurred most frequently. These were the most common adverse events associated with Acp and Mox. The usage rate of Acp and Mox therapies in the orthopaedist's hospital or clinic was 18.6%. There were many comments on infection control by acupuncturists (n = 27), education and technical levels of Acp and Mox (n = 13), and retained needles and needle breakages (n = 13). <BR>[Conclusion]These survey results reveal that the occurrence of severe adverse events associated with Acp and Mox was higher than our expectation. In order to improve the safety of Acp and Mox therapies, various educational activities to disseminate information about existing safety measures to acupuncturists are needed. Further studies on new preventive measures, continuous surveys, and feedback to acupuncturists are also required.
RESUMO
[Objective]The aim of this study was to prevent accidental burns caused by touching a heated needle shaft or by a burning moxa ball falling from a moxa needle. Therefore, we measured the central temperature (Tc) of a burning moxa ball and the temperature at the landing point (Td) of a falling moxa ball.<BR>[Methods]Stainless steel acupuncture needles and unrefined moxa for moxa needles were used. The moxa balls weighed 0.15 g (diameter, 13± 1mm), 0.30 g (diameter, 16 ± 1mm), and 0.60 g (diameter, 24 ± 1mm). To measure the Tc of a moxa ball, a K-type thermocouple temperature probe was inserted into the centre of the ball. The Td of a moxa ball was measured by placing the probe 2 mm directly below the moxa ball. At each point in time, the moxa ball was forced to drop after ignition. Each measurement was repeated 5 times. The data were expressed as mean ±standard deviation.<BR>[Results]The maximum Tc of the 0.15, 0.30, and 0.60 g moxa balls was 569 ± 26°C at 72 ± 8s after ignition, 606 ± 26°C at 109 ± 4s, and 624 ± 48°C at 167 ± 14 s, respectively. Tc of each ball decreased to less than 45°C at 180 ± 8s, 225 ± 4s, and 345 ± 13s after ignition, respectively. When a 0.15 g moxa ball was dropped 30 s after ignition, Td measured 1, 5, and 10 s after the drop was 60 ± 6°C, 97 ± 7°C, and 137 ± 31°C, respectively. Td was less than 45 degrees 120 seconds after ignition. When a 0.30 g moxa ball was dropped 120 s after ignition, Td measured 1, 5, and 10 s after the drop was 66 ± 7°C, 96 ± 6°C, and 129 ± 2°C, respectively. Td was less than 40 degrees 120 seconds after ignition. Td was less than 45 degrees 180 seconds after ignition. When a 0.60 g moxa ball was dropped 180 s after ignition, Td measured 1, 5, and 10 s after the drop was 69 ± 3°C, 96 ± 14°C, and 135 ± 20°C, respectively. Td was less than 45 degrees 270 seconds after ignition.<BR>[Conclusion]For 0.15, 0.30, and 0.60 g moxa balls, if Tc, that is the temperature of the probe, is considered to be the temperature of the needle shaft, burns may be caused by touching the heated shaft up until about 180, 240, and 360 s after ignition, respectively. Furthermore, there is a risk of burns caused by dropping a burning 0.15, 0.30, or 0.60 g moxa ball before 120, 180, or 270 s after ignition, respectively.