The migration of helical blade and the tip apex distance value in cephalomedullary nail for geriatric intertrochanteric fractures / 中国修复重建外科杂志

Objective: To investigate the association between the tip apex distance (TAD) and migration of helical blade in the femoral head of geriatric intertrochanteric fractures. Methods: A retrospective study of intertrochanteric fractures treated with the proximal femoral nail antirotation (PFNA) between June 2015 and June 2018 was performed. There were 32 males and 55 females with an average age of 84.7 years (range, 80-101 years). All of them were unilateral fresh closed intertrochanteric fractures caused by low energy injury. According to AO/Orthopaedic Trauma Association (AO/OTA) classification, 33 cases belonged to type 31-A1, 35 cases to type 31-A2, and 19 cases to type 31-A3. The time interval from injury to operation was 1-16 days (mean, 3.7 days). The TAD was measured according to immediate postoperative X-ray films. The cases were divided into two groups: group A with TAD less than 20 mm and group B with TAD greater than 20 mm. The difference of fracture healing and migration of helical blade between the two groups were observed. Results: According to the TAD value immediately after operation, 49 patients in group A had TAD of 8.9-19.7 mm, with an average of 18.6 mm; 38 patients in group B had TAD of 20.1-41.4 mm, with an average of 27.7 mm. The 87 patients were followed up for an average of 11.7 months, ranging from 4 to 28 months. Three cases (all in group B) underwent screw blade cutting and displacement, which resulted in internal fixation failure, including 1 case with femoral head cut upward and 2 cases with femoral head penetrated inward. The remaining 84 cases had bone healing without internal fixation related complications such as fracture of internal fixator and fracture of femoral shaft. There was significant difference in the incidence of internal fixation failure between group A and group B ( P=0.049). Conclusion: Reducing the TAD value of helical blade appropriately (15-20 mm) in PFNA internal fixation for intertrochanteric fracture patients over 80 years old can increase initial stability without increasing the risk of helical blade migration.

Trochanteric Fixation Nail® with Helical Blade Compared with Femoral Neck Screw for Operative Treatment of Intertrochanteric Femoral Fractures / 대한고관절학회지

PURPOSE: This study was performed to compare outcomes of the Trochanteric Fixation Nail (TFN®) with a helical blade versus TFN® with a femoral neck screw for the treatment of intertrochanteric femoral fractures. MATERIALS AND METHODS: A single center, retrospective cohort study. Patients (>18 years of age) with an intertrochanteric femoral fracture, who were operated on between January 1, 2012 and December 31, 2016 were included. Primary and secondary outcome measures were cut-out rate and intervention variables, respectively. Data from X-ray examinations and patient medical files were collected and analyzed. The chi-square test or Student's t-test were used for statistical analysis. RESULTS: A total of 631 patients were surgically treated for an intertrochanteric femoral fracture. Of this group, 239 patients (37.9%) were treated with a TFN® with helical blade and 392 patients (62.1%) with a TFN® with femoral neck screw. There were no statistically significant differences between the baseline characteristics of both groups. A total of 17 (2.7%) cut-outs were recorded, with no statistically significant difference between the two groups (P=0.19). Additionally, there were no statistically significant differences in the secondary outcome measures between the two groups. CONCLUSION: There are no statistically significant differences in primary and secondary outcomes following treatment of intertrochanteric femur fracture with the TFN® helical blade or TFN® femoral neck screw. These findings suggest that the choice of collum implant for the surgical treatment of intertrochanteric femur fractures cannot be made based on the surgical outcomes of the two implants evaluated here.

Predictors of failure following fixation of intertrochanteric fractures with proximal femoral nail antirotation

INTRODUCTION@#This retrospective matched case-control study aimed to identify predictors of cut-out following intramedullary nailing of intertrochanteric fractures with the 200-mm Synthes proximal femoral nail antirotation (PFNA).@*METHODS@#609 patients underwent intramedullary nailing for intertrochanteric fractures at our institution between January 2011 and December 2014. 370 patients satisfied the inclusion criteria. There were 20 cases of implant cut-out. Cases and controls were matched using a propensity score-matching method with an m:n ratio, matching the criteria of gender, age and side of operation. Radiographs were assessed to determine fracture classification, fracture reduction quality, tip-apex distance, calcar referenced tip-apex distance (CalTAD), anteroposterior (AP) Parker's ratio index, lateral Parker's ratio index and cervical angle difference. Conditional logistic regression analysis was performed to determine any association between potential predictors and cut-outs.@*RESULTS@#The cut-out incidence was 5.4%. Of the 20 cut-outs, 16 were superior and four were cut-throughs. Univariate analysis only showed a significant association between unsatisfactory fracture reduction quality and cut-outs (odds ratio [OR] 10.1, 95% confidence interval [CI] 1.31-77.6, p = 0.027). This association remained significant with multivariate logistic regression analysis (OR 16.4, 95% CI 1.9-140.4, p = 0.011). Cut-throughs had significantly lower CalTAD (16.2 vs. 27.5, p = 0.016) and AP Parker's ratio index values (38.7 vs. 50.7, p = 0.007) than superior cut-outs.@*CONCLUSION@#Unsatisfactory fracture reduction quality was a significant predictor of cut-out in intertrochanteric fractures treated with the 200-mm PFNA. Cut-outs had two distinct modes, with cut-throughs having a deeper and more inferior helical blade position in the femoral head compared to superior cut-outs.

A New Technique for Solving Tightrope Cutout during Acromioclavicular Joint Fixation: A Case Report

Acromioclavicular joint (ACJ) dissociation is one of the common injuries affecting adults. The stability of ACJ largely depends on the integrity of acromioclavicular ligament, coracoclavicular ligament, capsule, trapezius muscle and deltoid muscle. The injury has been classified by Rockwood into six types and treatment options can be guided by the classification. TightRope fixation is one of the many surgical procedures available to address acromioclavicular joint separation. It consists of tensioning of a no. 5 Fibrewire suture secured at both ends to lowprofile metallic buttons. Despite various advantages of using this technique, complications such as suture cut-out, clavicle fracture and suture failure have been documented. The author presents a case of a type III acromioclavicular joint dissociation treated with TightRope which suture cutout was noted intra-operatively. Decision to amend the fixation using a cut one-third tubular plate as an additional anchor for the metallic button on the clavicle was made. Patient’s progress was evaluated using the University of California at Los Angeles Shoulder Score (UCLA Shoulder Score) and significant improvement was noted six months post operatively. We propose this technique as a solution to the encountered problem.

Intertrochanteric fracture fixation with Dynamic Hip Screw: Is tip-apex distance measurement useful for predicting fixation failure?

Introduction: Application of dynamic hip screw (DHS) implant for the treatment of unstable intertrochanteric fractures continues to raise concern related to risk of lag screw cut-out with or without subsequent damage to the acetabulum. Measurement of tip-apex distances (TAD) has been recommended to guide the optimal placement of lag screw and to predict subsequent risk of screw cut-out. In this study, the value of TAD was evaluated to verify its usefulness. Methods: This is a retrospective study of 33 consecutive patients with intertrochanteric fracture treated with DHS. Demographic data of the patients were traced from their case notes. Post-operative radiographs were reviewed by focusing on measurement of TAD on anteroposterior and lateral radiographs. Radiographs at one year follow-up were reviewed to depict any fixation-related failure or complication. Results: Fifty two percent of patients did not achieved the recommended TAD of ≤ 25mm. The mean post-operative TAD was 25.9mm and elderly patients were likely to achieve TAD of ≤ 25mm. The overall complication rate of 6% was attributed to screw cut-out in two cases. The unstable left-sided fracture was identified to be a potential risk for screw cut-out or migration. Conclusion: TAD is a valuable measurement to guide optimal placement of lag screw during DHS fixation of intertrochanteric fracture.

Fixation Strategies to Prevent Screw Cut-Out and Malreduction in Proximal Humeral Fracture Fixation

Fixation of proximal humerus fractures with precontoured, fixed angle devices has improved operative management of these difficult injuries, particularly in patients with osteoporosis. However, recent data has revealed that fixation with these constructs is not without complications, particularly screw cut-out and loss of reduction. Multiple strategies have been developed to decrease the number of complications. We offer a surgical technique combining suture augmentation of the proximal humerus with locked plate fixation utilizing short screws.

The association between the“Tip-Apex Distance”value and cut-out of the lag screw from the femoral head:a clinical retrospective study / 中华创伤骨科杂志

Objective To confirm the association between the“Tip-Apex Distance (TAD)”and cut-out of the lag screw from the femoral head.and to analyze other factors leading to the cut-out.Methods The complete radiographic and clinical data of 106 patients with femoral intertrochanteric fractures were available for this study. They were 65 men and 41 women,with an average age of 52.4 years (range,20 to 83 years).According to Evans classification.19 cases belonged to typeⅡ.25 to typeⅢ,32 to typeⅣ,29 to typeⅤ,and one to type R.The bone quality was classified by Singh rating system:44 cases were rated as typeⅥ.34 as typeⅤ,23 as typeⅣand five as typeⅢ.They were treated with open reduction and fixation with 135?dynamic hip screw (DHS).According to the finding of Baumgaertner that“TAD”beyond 25 mm would grcatly increase the risk of cut-out,the patients could be divided into two groups:59 cases with“TAD”less than 25 mm and 47 greater than 25 mm.Results The mean duration of follow-ups was 14.45 months (range,4.5 to 28.0 months).Of the 15 cases whose“TAD”was more than 30 mm,one had the cut-out.Of the seven cases whose“TAD”was more than 40 mm,two had the cut-out (P=0.000). The average age of the three patients was 78.7 years (range:75 to 83 years) and 27.1 years older than that of the 103 patients whose fracture healed (P=0.000).They belonged to the unstable intertrochanteric fracture of the femur (two to Evans type V and one to type R).The reduction was assessed as excellent in 43 cases,good in 47 cases,fair in nine cases (of whom one had the cut-out),poor in seven cases (of whom two had the cut-out). Conclusions The cut-out of the lag screw from the femoral head can be caused by age,fracture type and stability of reduction and“TAD”.The greater the“TAD”value,the greater possibility of cut-out.

The Value of the Tip - Apex Distance in Predicting Failure of Fixation of Intertrochanteric Fractures of the Hip / 대한정형외과학회잡지

Failure of fixation of intertrochanteric fractures that have been treated with a fixed-angle sliding hip-screw device is frequently related to the position of the lag screw in the femoral head. The purpose of this study is to introduce the concept of the tip-apex distance and to demonstrate its clinical usefulness as a predictor of cutout of the screw used for fixation of the intertrochanteric fractures of the hip. The tip-apex distance is the sum of the distance from the tip of the lag screw to the apex of femoral head on an anteroposterior radiograph and this distance on a lateral radiograph after controlling for magnification. To determine the value of tip-apex distance in the prediction of cutout of the lag screw, 67 intertrochanteric fractures that have been treated with a fixed-angle sliding hip screw device were studied. The minimum duration of follow-up was three months during which period all of the fractures either healed or had failure of the fixation. The average tip-apex distance was 21mm (range,22.8-65.8mm) for the successfully treated fractures compared with 35mm (range,8.4-65.8mm) for those in which the screw cutout. There was strong statistical relationship between an increasing tip-apex distance and the rate of cutout. An unstable fracture, a poor reduction were also associated with a significantly increased risk of failure due to cutout.