ABSTRACT
Linewidth measurements of a distributed feedback (DFB) fibre laser are made using delayed self heterodyne interferometry (DHSI) with both Mach-Zehnder and Michelson interferometer configurations. Voigt fitting is used to extract and compare the Lorentzian and Gaussian linewidths and associated sources of noise. The respective measurements are w(L) (MZI) = (1.6 ± 0.2) kHz and w(L) (MI) = (1.4 ± 0.1) kHz. The Michelson with Faraday rotator mirrors gives a slightly narrower linewidth with significantly reduced error. This is explained by the unscrambling of polarisation drift using the Faraday rotator mirrors, confirmed by comparing with non-rotating standard gold coated fibre end mirrors.
Subject(s)
Interferometry/instrumentation , Lasers , Feedback , Normal Distribution , Optics and Photonics , Oscillometry , Time FactorsABSTRACT
We constructed a type of sensor by depositing a solgel layer within the interior holes of a silica-structured fiber and, subsequently, coating this with an acid-responsive porphyrin. Protonation of the porphyrin by an acidic gas (HCl in this case), is detected by a large change in the visible spectrum. Compared to previous work on a liquid-core sensor in a structured optical fiber, the signal-to-noise ratio of this gas sensor shows a reduced signal strength, but the detection rate is increased about fortyfold.
ABSTRACT
An optical fiber acid-sensor based on protonation of a porphyrin solution within a single-hole structured optical fiber is proposed and demonstrated. The liquid-core fiber acts as a microcell reactor, and changes in the spectral signature with acidification are detected. Challenges and limitations in the practical deployment of such sensors are evaluated. An effective chemical sensor is demonstrated, but issues such as diffusion limit its full utilization. Some solutions are discussed.
ABSTRACT
The thermal stability of Type I gratings is increased by postthermal tuning of the grating. Optimization of the procedure leads to gratings that can withstand temperatures as high as 600 degrees C. Aging tests lead to lifetime predictions as high as 25 years with <3 dB reduction at 400 degrees C. Single exponential relaxation is observed. Above 800 degrees C regeneration is obtained.
ABSTRACT
Fibre Bragg gratings inscribed with the point-by-point method using a Ti-sapphire femtosecond laser operating at 800 nm are shown to display strong increasing attenuation towards shorter wavelengths with a large and spectrally sharp recovery observed below 400 nm. The origin of this loss is shown to be Mie scattering, and the sharp recovery in the transmission results from wavelength dependent scattering within the numerical aperture of the core. The permanent losses from these Type II gratings have implications for high temperature sensors and fibre lasers.
