ABSTRACT
Given their superior dynamics, microprobes represent promising probe candidates for high-speed roughness measurement applications. Their disadvantage, however, lies in the fact that the volume of the microprobe's silicon tip decreases dramatically during roughness measurement, and the unstable tip geometry leads to an increase in measurement uncertainty. To investigate the factors that influence tip geometry variation during roughness measurement, a rectangular-shaped tip characterizer was employed to characterize the tip geometry, and a method for reconstructing the tip geometry from the measured profile was introduced. Experiments were conducted to explore the ways in which the tip geometry is influenced by tip wear, probing force, and the relative movement of the tip with respect to the sample. The results indicate that tip fracture and not tip wear is the main reason for tip volume loss, and that the lateral dynamic load on the tip during scanning mode is responsible for more tip fracture than are other factors.
ABSTRACT
State of the art three-dimensional atomic force microscopes (3D-AFM) cannot measure three spatial dimensions separately from each other. A 3D-AFM-head with true 3D-probing capabilities is presented in this paper. It detects the so-called 3D-Nanoprobes CD-tip displacement with a differential interferometer and an optical lever. The 3D-Nanoprobe was specifically developed for tactile 3D-probing and is applied for critical dimension (CD) measurements. A calibrated 3D-Nanoprobe shows a selectivity ratio of 50:1 on average for each of the spatial directions x, y, and z. Typical stiffness values are kx = 1.722 ± 0.083 N/m, ky = 1.511 ± 0.034 N/m, and kz = 1.64 ± 0.16 N/m resulting in a quasi-isotropic ratio of the stiffness of 1.1:0.9:1.0 in x:y:z, respectively. The probing repeatability of the developed true 3D-AFM shows a standard deviation of 0.18 nm, 0.31 nm, and 0.83 nm for x, y, and z, respectively. Two CD-line samples type IVPS100-PTB, which were perpendicularly mounted to each other, were used to test the performance of the developed true 3D-AFM: repeatability, long-term stability, pitch, and line edge roughness and linewidth roughness (LER/LWR), showing promising results.
Subject(s)
Microscopy, Atomic ForceABSTRACT
During the past decade, piezo-resistive cantilever type silicon microprobes for high-speed roughness measurements inside high-aspect-ratio microstructures, like injection nozzles or critical gas nozzles have been developed. This article summarizes their metrological properties for fast roughness and shape measurements including noise, damping, tip form, tip wear, and probing forces and presents the first results on the measurement of mechanical surface parameters. Due to the small mass of the cantilever microprobes, roughness measurements at very high traverse speeds up to 15 mm/s are possible. At these high scanning speeds, considerable wear of the integrated silicon tips was observed in the past. In this paper, a new tip-testing artefact with rectangular grooves of different width was used to measure this wear and to measure the tip shape, which is needed for morphological filtering of the measured profiles and, thus, for accurate form measurements. To reduce tip wear, the integrated silicon tips were replaced by low-wear spherical diamond tips of a 2 µm radius. Currently, a compact microprobe device with an integrated feed-unit is being developed for high-speed roughness measurements on manufacturing machines. First measurements on sinusoidal artefacts were carried out successfully. Moreover, the first measurements of the elastic modulus of a polymer surface applying the contact resonance measurement principle are presented, which indicates the high potential of these microprobes for simultaneous high-speed roughness and mechanical parameter measurements.
