ABSTRACT
This study investigated the color stability and microhardness of five composites exposed to four beverages with different pH values. Composite discs were produced (n=10); Filtek Z250 (3M ESPE) and Filtek P90 (3M ESPE) were applied in two layers (2 mm, 20 seconds), and Tetric N-Ceram Bulk Fill (TetricBF, Ivoclar Vivadent) and SonicFill (Kerr) were applied in bulk (4 mm) and then light cured (40 seconds, Ortholux-LED, 1600 mW/cm2). Indirect composite Sinfony (3M ESPE) was applied in two layers (2 mm) and cured (Visio system, 3M ESPE). The specimens were polished and tested for color stability; ΔE was calculated using spectrophotometer readings. Vickers microhardness (50 g, dwell time=45 seconds) was assessed on the top and bottom surfaces at baseline, 40 days of storage, subsequent repolishing, and 60 days of immersion in distilled water (pH=7.0), Coca-Cola (pH=2.3), orange juice (pH=3.75), or anise (pH=8.5) using scanning electron microscopy (SEM). The materials had similar ΔE values (40 days, p>0.05), but TetricBF had a significantly greater ΔE than P90 or SF (40 days). The ΔE was less for P90 and TetricBF than for Z250, SonicFill, and Sinfony (60 days). Repolishing and further immersion significantly affected the ΔE (p<0.05) except for P90. All composites had significantly different top vs bottom baseline microhardnesses. This was insignificant for the Z250/water, P90/orange juice (40 days), and Sinfony groups (40 and 60 days). Immersion produced variable time-dependent deterioration of microhardness in all groups. Multivariate repeated measures analysis of variance with post hoc Bonferroni tests were used to compare the results. ΔE and microhardness changes were significantly inversely correlated at 40 days, but this relationship was insignificant at 60 days (Pearson test). SEM showed degradation (40 days) that worsened (60 days). Bulk-fill composites differ regarding color-stability and top-to-bottom microhardness changes compared with those of other composites. P90 showed better surface degradation resistance. In conclusion, bulk-fill composites are not promising alternatives to incremental and indirect composites regarding biodegradation.
Subject(s)
Color , Composite Resins , Materials Testing , SpectrophotometryABSTRACT
The present study was designed to examine the effects of prenatal stress on the morphological development of sexually dimorphic structures in the anterior hypothalamus in male rats and to determine if there is a relationship between morphologic development of the brain and copulatory behavior in individual animals. Dams in the stress group were subjected to treatments of heat-light restraint during the third trimester of gestation (day 14 to parturition) three times daily for 45-min periods. At 90 days of age, prenatally stressed and control male offspring were tested during the dark cycle for spontaneous male sexual behavior. Volumes of the sexually dimorphic nucleus of the preoptic area (SDN-POA) and the anteroventral periventricular nucleus (AVPV) were measured. Comparisons were made between copulatory behavior and hypothalamic nuclear volumes. SDN-POA volumes were significantly reduced (feminized; males have a larger SDN-POA than females) in prenatally stressed males that did not copulate, whereas, SDN-POA volumes in prenatally stressed males that copulated were not altered. The few control males that did not copulate (sexually non-active) also had significantly reduced SDN-POA volumes compared to the control males that did copulate (sexually active). The volume of the AVPV was significantly increased (feminized; males have a smaller AVPV than females) in prenatally stressed males that were sexually non-active compared to AVPV volumes in sexually active males. The results obtained in this study provide a strong positive relationship between sexual behavior and the morphology of the two sexually dimorphic structures measured.
