Quantifying Decay Due to Wet Atmospheric Deposition on Basalt.

The study of building materials is important for a better conservation of built heritage. Worldwide, volcanic stones (including basalt, andesite and dacite) are among the least studied building materials. In this research, the decay of a red basalt due to wet atmospheric deposition was studied. Red basalt was exposed to artificial rain solutions, prepared from rain samples collected weekly from 2014-2019. In this research, the decay of stone-built heritage was indirectly studied emulating wet atmospheric accelerated weathering under three different volume weighted mean (VWM) compositions: global, acid and no-acid categories. Lixiviates were analyzed to better understand the deterioration mechanisms taking place inside the material. Decay was quantified as mass difference, water absorption capacity (WAC) and open porosity (OP) changes. Results show that the methodology used is suitable to research the decay of built heritage. The studied basalt is indeed prone to decay by wet atmospheric deposition. The main decay mechanisms are the washing of insoluble compounds, dissolution of minerals, salt crystallization and cation exchange. WAC and OP showed promising results of their appropriateness as monitoring variables of decay in situ. Acid conditions produce the most severe decay, but Ph effect is not as important as precipitation volume. Non-linear equations relating volume of precipitation with mass difference in red basalt are presented.

Sulfur and nitrogen compounds in wet atmospheric deposition on the coast of the Gulf of Mexico from 2003 to 2015.

The Gulf of Mexico region has important sources of acid rain precursors, located in all of the countries; U.S., Mexico and Cuba, and so it is very important to study the chemical composition of the wet atmospheric deposition in all coastal areas. For many years along the U.S. Gulf Coast, acidic precipitation has been measured. Measurements along the Mexican Gulf Coast were begun in 2003. The aim of this study was to evaluate pH, sulfate, nitrate and ammonium concentrations in wet atmospheric deposition, collected daily from 2003 to 2015 at La Mancha (LM), Veracruz and compare the values with the National Atmospheric Deposition Program (NADP) sampling sites located along the U.S. coast of the Gulf of Mexico. The annual Volume Weighted Mean (VWM) pH in wet deposition at La Mancha site ranged from 4.81 to 5.40, which is similar to the U.S. Gulf sites. Additionally, the annual VWM SO42- concentration was from 15 to 31 µeq/L, which is higher than the U.S. sites. Annual VWM NO3- concentrations were from of 3.5 to 15 µeq/L, which is lower than all the U.S. sites. At the Mexican site, the SO42-/NO3- ratio was 4.90 and higher than all of the U.S. sites, which were between 1.03 and 2.38. For LM, the median NH4+/NO3- ratio was 0.77, similar to the Florida sites (0.53-0.91), and below the values measured for Louisiana and Texas (1.07-1.5). The Hybrid Single Particle Lagrangian Integrated Trajectory Model (HYSPLIT) was applied in order to identify the emission sources for the pollutants seen at LM. Trajectories showed an important transport to LM from the East (open water) during the rainy season. The region located East of La Mancha shows offshore petroleum operations as sources of acid rain precursors and deposition of acidifying and nitrogen containing compounds. It is important to consider the sulfur dioxide emission sources in the Mexico Gulf region, and to extend the atmospheric deposition sampling to other sites along the Mexican Gulf coast and Cuba.

Dynamic control of osmolality and ionic composition of the xylem sap in two mangrove species.

• Premise of the study: Xylem sap osmolality and salinity is a critical unresolved issue in plant function with impacts on transport efficiency, pressure gradients, and living cell turgor pressure, especially for halophytes such as mangrove trees.• Methods: We collected successive xylem vessel sap samples from stems and shoots of Avicennia germinans and Laguncularia racemosa using vacuum and pressure extraction and measured their osmolality. Following a series of extractions with the pressure chamber, we depressurized the shoot and pressurized again after various equilibration periods (minutes to hours) to test for dynamic control of osmolality. Transpiration and final sap osmolality were measured in shoots perfused with deionized water or different seawater dilutions.• Key results: For both species, the sap osmolality values of consecutive samples collected by vacuum extraction were stable and matched those of the initial samples extracted with the pressure chamber. Further extraction of samples with the pressure chamber decreased sap osmolality, suggesting reverse osmosis occurred. However, sap osmolalities increased when longer equilibration periods after sap extraction were allowed. Analysis of expressed sap with HPLC indicated a 1:1 relation between measured osmolality and the osmolality of the inorganic ions in the sap (mainly Na+, K+, and Cl-), suggesting no contamination by organic compounds. In stems perfused with deionized water, the sap osmolality increased to mimic the native sap osmolality.• Conclusions: Xylem sap osmolality and ionic contents are dynamically adjusted by mangroves and may help modulate turgor pressure, hydraulic conductivity, and water potential, thus being important for mangrove physiology, survival, and distribution.

Optimization of carbohydrate silylation for gas chromatography.

We developed and optimized a new carbohydrate mono- and disaccharides silylation reaction, replacing pyridine and requiring lower reaction temperature and less time. Our method consists of three basic steps. The first one is oxime formation, the second one silylate derivative and the last one gas chromatography separation and quantification with an internal standard. We evaluated several solvents, including acetonitrile, hydroxylamine and aniline. We found aniline to be the best reaction media for oxime formation with hydroxylamine hydrochloride. Among silylation agents we found N,O-bis(trimethyl)trifluoroacetamide (BSTFA) was the most efficient. Together these reagents favored both a short analysis time and fewer by-products. We evaluated the method with model solutions containing: arabinose and co-eluting xylose, fructose, glucose, sucrose and salicin (internal standard) and found it suitable for processed food analysis.