Design of an Integrated Micro-Viscometer for Monitoring Engine Oil.

This paper proposes a novel integrated micro-viscometer for engine-oil monitoring. The final solution consists of a capacitive micromachined ultrasonic transducer (CMUT) and an application-specific integrated circuit (ASIC). The CMUT is used to generate and capture acoustic waves while immersed in engine oil. The low power transceiver ASIC is interfaced with the CMUT structure for actuation and reception. An integrated charge pump boosts the supply voltage from 3.3 to 22 V to generate the DC polarization voltage of the CMUT. The receiver has a power consumption of 72 µW with an input-referred noise current of 3.2pAHz and a bandwidth of 7 MHz. The CMUT array occupies an area of 3.5 × 1 mm, whereas the ASIC has a chip area of 1 × 1 mm. The system was tested using engine oils of different types and ages at different temperatures. Measurement results show a significant frequency shift due to the dynamic viscosity change that occurs as oil ages. A shift of -1.9 kHz/cP was measured, which corresponds to a shift of 33 Hz/mile. This work paves the way for high accuracy-integrated solutions for oil condition monitoring and is expected to play a significant role in a more economic and environmentally friendly usage of oil.

Dual-Level Capacitive Micromachined Uncooled Thermal Detector.

This paper presents a novel dual-level capacitive microcantilever-based thermal detector that is implemented in the commercial surface micromachined PolyMUMPs technology. The proposed design is implemented side-by-side with four different single-level designs to enable a design-to-design performance comparison. The dual-level design exhibits a rate of capacitance change per degree Celsius that is over three times higher than that of the single-level designs and has a base capacitance that is more than twice as large. These improvements are achieved because the dual-level architecture allows a 100% electrode-to-detector area, while single-level designs are shown to suffer from an inherent trade-off between sensitivity and base capacitance. In single-level designs, either the number of the bimorph beams or the capacitance electrode can be increased for a given sensor area. The former is needed for a longer effective length of the bimorph for higher thermomechanical sensitivity (i.e., larger tilting angels per degree Celsius), while the latter is desired to relax the read-out integrated-circuits requirements. This thermomechanical response-to-initial capacitance trade-off is mitigated by the dual-level design, which dedicates one structural layer to serve as the upper electrode of the detector, while the other layer contains as many bimorph beams as desired, independently of the former's area.