ABSTRACT
BACKGROUND: A previous injection algorithm termed the "Toxin Lift" was recently introduced and described volume increases in the midface following neuromodulator treatments of the jawline. Increase in midfacial volume due to soft tissue repositioning could also affect the severity of infraorbital hollows. OBJECTIVE: The objective is therefore to evaluate whether the severity of infraorbital hollows can be improved by injecting neuromodulators in the supra-mandibular segment of the platysma. MATERIALS AND METHODS: A total of 35 volunteers (11 males/24 females) with a mean age of 39.8 (9.6) years and a mean BMI of 25.2 (5.2) kg/m2 were investigated. Bilateral infraorbital regions were evaluated via clinical assessment and semi-quantitative 3D imaging. The applied injection technique targeted the platysma via four injection points administering 5 I.U. per injection point resulting in a total of 20 I.U. per facial side. RESULTS: Volume increase of the infraorbital region was 0.13 cc at 15 days (p = 0.001) and was 0.02 cc at 30 days (p = 0.452) whereas the skin displacement in cranial direction was 0.54 mm at 15 days (p < 0.001) and was 0.31 mm at 30 days (p < 0.001). Clinical evaluation revealed a highly statistically significant improvement of the tear trough, palpaebromalar groove, and of the lid-cheek junction when compared to baseline with all p < 0.001. CONCLUSION: The results of this clinical prospective interventional analysis revealed that the "Toxin Lift" injection technique is capable to improve the clinical appearance of infraorbital hollows. The effects can be explained by the concepts of facial biomechanics.
ABSTRACT
Bonding to different dental restorative materials is challenging. This study aimed to evaluate the effect of a 10-MDP-based dentin adhesive on the shear bond strength (SBS) of self-adhesive resin cement (RC) to implant abutment materials. One hundred and twenty specimens were obtained from zirconia (ZO), cobalt-chromium alloy (CoCr), and commercially pure titanium (Ti), which were treated as follows (n = 10): control group-non-treated (CG), 10-MDP-based dentin adhesive (SB), light-cured SB (SB-LC), and zirconia primer (ZP). Blocks of RC were buildup and, after 24 h, were tested for bond strength. Data of SBS (MPa) were submitted to two-way ANOVA and Tukey test (α = 0.05). There was no difference in SBS among materials for CG and ZP, higher SBS were recorded for Ti SB and Ti SB-LC compared to ZO upon the same surface treatments. For the comparisons among treatments, SB-LC showed the highest SBS for CoCr. For ZO and Ti, higher SBS were recorded with SB and SB-LC. No cohesive failures were observed. It was concluded that the surface treatment with 10-MDP-based materials increased the bond strength of the resin cement to abutment materials, which showed to be material dependent.
