ABSTRACT
This paper presents the investigations toward the direct use of bentonite clay (Al2H2O6Si) nanoparticles to act like a saturable absorber (SA) for the Q-switched pulse operation of an erbium-doped fiber laser (EDFL). The measured results reveal that with the incorporation of bentonite clay nanopowder as a SA, an EDFL is realized with a Q-switching mechanism starting at a pump power of 30.8 mW, and a Q-switched emission wavelength was noticed at 1562.94 nm at 142 mW pump power. With an increased pump from 30.8 mW to 278.96 mW, the temporal pulse parameters including minimum pulse duration and maximum pulse repetition rates were reported as 2.6 µs and 103.6 kHz, respectively. The highest peak power, signal-to-noise ratio, output power and pulse energy were noticed to be 16.56 mW, 51 dB, 4.6 mW, and 47 nJ, respectively, at a highest pump power of 278.96 mW. This study highlights the significance of bentonite clay (Al2H2O6Si) nanoparticles as a potential candidate for a saturable absorber for achieving nonlinear photonics applications.
ABSTRACT
This work is concerned with fabricating ferrite nanoparticles of nickel-zinc with the chemical formula: Ni0.55Zn0.45Fe2-xCexO4, 0 ≤ x ≤ 0.011 by co-deposition technique and modifying their electrical, microscopic, spectroscopic, optical, electrical and dielectric properties as advanced engineering materials through doping with the cerium (Ce) element. XRD patterns displayed that the samples have a monophasic Cerium-Nickel-zinc (CNZ) spinel structure without other impurities for cerium concentration (x) ≤ 0.066. Both values of crystallite size and lattice parameters decrease from 33.643 to 23.137 nm and from 8.385 to 8.353 nm, respectively, with the increasing Ce ions substitution content from 0 to 0.066. SEM images indicate that grains of the fabricated compounds are smaller, more perfect, more homogeneous, and less agglomeration than those of the un-doped Ni-Zn nano-ferrites. The maximum intensity of first-order Raman spectral peaks (Eg, F2g(2), A1g(2), and A1g(1)) of CNZ ferrite nanoparticles are observed at about (330, 475, 650, 695) cm-1, respectively, that confirms the CNZ samples have the cubic spinel structure. The direct and indirect optical energy bandgaps of CNZ samples have a wide spectrum of values from semiconductors to insulators according to cerium concentration. The results showed that the values of dielectric constant, dielectric loss factor, and Ac conductivity and the conductivity transition temperature are sensitive to cerium ions content. AC conductivity exhibited by the CNZ samples has the semiconductor materials behavior, where the AC conductivity increases due to temperature or doping concentration. The results indicate that Ni0.55Zn0.45Fe1.944Ce0.066O4 ferrite nanoparticles may be selected for optoelectronic devices, high-frequency circuits, and energy storage applications.
ABSTRACT
In the current twenty years, industrial applications of ionic liquids (ILs) have been of paramount attention due to their indisputable positive characteristics like negligible volatility and chemical/thermal stability. These brilliant advantages open new horizons towards environmentally friendly application of ILs in several industrial activities like membrane-based CO2 separation, electrolyte, bioprocessing, targeted drug delivery and solar panels. The principal intention of this article is to prepare a comprehensive review on the potential efficiency of IL-based absorbents to separate CO2 acidic contaminant from industrial gaseous streams compared to alkanolamine absorbents as the benchmark. For this purpose, a techno-economic evaluation is presented to compare the cost-effectiveness of ILs compared to alkanolamine absorbents. Finally, major environmental impacts of the ILs applications in industries are discussed and future perspectives towards solving the operational challenges are presented in detail.
Subject(s)
Ionic Liquids , Carbon DioxideABSTRACT
In the present study, the immediate detection of rare-earth elements (REEs) in phosphorite deposits has been reported using laser-induced breakdown spectroscopy (LIBS). Numerous emission lines corresponding to the REEs such as lanthanum (La), cerium (Ce), neodymium (Nd), samarium (Sm), and ytterbium (Yb), have been detected in the emission spectra of phosphorite-induced plasma plume. For the quantitative analysis, we employed the calibration-free LIBS (CF-LIBS), and Energy Dispersive X-ray (EDX) spectroscopy techniques. The results obtained using the CF-LIBS technique show excellent agreement with that obtained by EDX. Besides principal component analysis (PCA) was employed by incorporating the LIBS spectral data of rare earth phosphorite rocks samples containing La, Ce, Nd, Sm, and Yb emission lines. The first three PCs were observed using LIBS spectral data set showing a covariance (interpretation rate) up to 76.3%. This study suggests that LIBS yields a quick and very reliable qualitative and quantitative analysis of REEs in any geological ore sample.
ABSTRACT
Medication-induced weight gain can be frustrating to patients and health care providers. Drug-induced weight gain is a profound side effect of numerous commonly used medications. The present study aimed to investigate FAERS reports about drug-induced weight gain in the last ten years. Using the US FDA Adverse Event Reporting System (FAERS) between 2012 and 2021, a retrospective, descriptive analysis was conducted to analyze the major reported Adverse Events about weight gain. During the last ten years, 137370 reports were submitted to FAERS about drug-induced weight gain. The most common drugs that are reported by the patients and that are associated with weight gain were risperidone (11.55%), adalimumab (3.94%), pregabalin (3.86%), aripiprazole (3.1%), etanercept (2.72%), and prednisone (2.70%). In conclusion, the present study showed that drug-induced weight gain is a common side effect of several medications frequently used to treat chronic diseases. Healthcare providers should educate their patients about the medicines that may cause weight gain.
Subject(s)
Adverse Drug Reaction Reporting Systems , Drug-Related Side Effects and Adverse Reactions , United States , Humans , Aripiprazole , Pregabalin , Etanercept , Risperidone , Adalimumab , Retrospective Studies , Prednisone , Databases, Factual , Weight GainABSTRACT
Using the microwave-assisted method, novel Fe3O4/Zn-metal organic framework magnetic nanostructures were synthesized. The crystallinity, thermal stability, adsorption/desorption isotherms, morphology/size distribution, and magnetic hysteresis of synthesized Fe3O4/Zn-metal organic framework magnetic nanostructures were characterized by XRD patterns, TGA curve, BET adsorption/desorption technique, SEM image, and VSM curve, respectively. After confirming the Fe3O4/Zn-metal organic framework magnetic nanostructures, its antimicrobial properties against Gram-positive bacterial, Gram-negative bacterial, and fungal strains based on minimum inhibitory concentration (MIC), minimum bactericidal concentration (MBC), and minimum fungicidal concentration (MFC) values were studied. The MIC values in antimicrobial activity for Gram-positive and Gram-negative bacterial strains, between 16-128 µg/ml, and for fungal strain, 128 µg/ml were observed. The results showed that the high specific surface area of Fe3O4/Zn-metal organic framework magnetic nanostructures caused the antimicrobial power of nanoparticles to be high, and the observed antimicrobial effects were higher than some known commercial antimicrobial drugs. Another advantage of the specific surface area of Fe3O4/Zn-metal organic framework magnetic nanostructures was its high catalytic properties in the three-component reaction of isatin, malononitrile, and dimedone. New spiro [indoline-pyranopyrimidines] derivatives were synthesized with high efficiency. The catalytic activity results of Fe3O4/Zn-metal organic framework magnetic nanostructures showed that, in addition to recyclability, derivatives could be synthesized in less time than previously reported methods. The results of investigating the catalytic activity of Fe3O4/Zn-metal organic framework magnetic nanostructures showed that the spiro [indoline-pyranopyrimidines] derivatives were synthesized in the time range of 10-20 min with an efficiency of over 85%. As a final result, it can be concluded that the microwave synthesis method improves the unique properties of magnetic nanostructures, especially its specific surface area, and has increased its efficiency.
ABSTRACT
We show that femtosecond laser irradiation of polydimethylsiloxane (PDMS) enables selective and patterned cell growth by altering the wetting properties of the surface associated with chemical and/or topographical changes. In the low pulse energy regime, the surface becomes less hydrophobic and exhibits a low water contact angle compared to the pristine material. X-ray photoelectron spectroscopy (XPS) also reveals an increased oxygen content in the irradiated regions, to which the C2C12 cells and rabbit anti-mouse protein were found to attach preferentially. In the high pulse energy regime, the laser-modified regions exhibit superhydrophobicity and were found to inhibit cell adhesion, whereas cells were found to attach to the surrounding regions due to the presence of nanoscale debris generated by the ablation process.