ABSTRACT
Chemical fixation of CO2 to produce cyclic carbonates can be a green and atomic efficient process. In this work, a series of porphyrazines (Pzs) containing electron-withdrawing groups and central MII ions (where M = Mg, Zn, Cu, and Co) were synthesized and investigated as catalysts for the cycloaddition of CO2 to epoxides. Then, the efficiency of the Pzs was tested by varying cocatalyst type and concentration, epoxide, temperature, and pressure. MgIIPz bearing trifluoromethyl groups (1) showed the best conversion, producing, selectively, 78% of propylene cyclic carbonate (PCC), indicating that a harder and stronger Lewis acid is more effective for epoxide activation. Moreover, cocatalyst variation showed a notable effect on the reaction yields. Spectrophotometric titrations, MALDI-TOF mass spectra, and theoretical calculations suggest poisoning of the catalyst when tetrabutylammonium chloride (TBAC) and large amounts of tetrabutylammonium bromide (TBAB) were used in the system. The same was not observed for tetrabutylammonium iodide (TBAI), indicating that the metal-cocatalyst interaction may govern the reaction rate. In addition, two rare examples of crystalline structures were obtained, proving the distorted square pyramidal geometry with water molecule as axial ligand. This is one of the first studies reporting Pzs as catalysts for the chemical fixation of CO2, and we believe that the intricate balance between cocatalyst concentration and conversion efficiency shown here may aid future studies in the area.
ABSTRACT
Photostability is considered a key asset for photosensitizers (PS) used in medical applications as well as for those used in energy conversion devices. In light-mediated medical treatments, which are based on PS-induced harm to diseased tissues, the photoinduced cycle of singlet oxygen generation has always been considered to correlate with PS efficiency. However, recent evidence points to the fundamental role of contact-dependent reactions, which usually cause PS photobleaching. Therefore, it seems reasonable to challenge the paradigm of photostability versus PS efficiency in medical applications. We have prepared a series of Mg(II) porphyrazines (MgPzs) having similar singlet oxygen quantum yields and side groups with different electron-withdrawing strengths that fine-tune their redox properties. A detailed investigation of the photobleaching mechanism of these porphyrazines revealed that it is independent of singlet oxygen, occurring mainly via photoinduced electron abstraction of surrounding electron rich molecules (solvents or lipids), as revealed by the formation of an air-stable radical anion intermediate. When incorporated into phospholipid membranes, photobleaching of MgPzs correlates with the degree of lipid unsaturation, indicating that it is caused by an electron abstraction from the lipid double bond. Interestingly, upon comparing the efficiency of membrane photodamage between two of these MgPzs (with the highest and the lowest photobleaching efficiencies), we found that the higher the rate of PS photobleaching the faster the leakage induced in the membranes. Our results therefore indicate that photobleaching is a necessary step toward inflicting irreversible biological damage. We propose that the design of more efficient PS for medical applications should contemplate contact-dependent reactions as well as strategies for PS regeneration.
ABSTRACT
Phthalocyanines, porphyrins, and chlorins have been widely studied as photosensitizers. Both experimental and computational strategies are employed in order to propose new and more active molecules derived from those macrocycles. In this context, there are two main strategies used: (i) the addition of different substituents and (ii) the complexation of the macrocycle with different metallic ions. In this work, we present selected descriptors based on quantum chemistry calculations for forty macrocycles, including some approved drugs. We have found that density functional theory is a suitable methodology to study the large sets of molecules when applying the B3LYP/LanL2DZ methodology for geometry optimization and TD-OLYP/6-31G(d) for absorption spectrum. The inclusion of solvent effects by means of continuum model is important in order to obtain the accurate electronic data. We have verified that by bonding charged or polar substituents to the macrocycle, it is possible to enhance water solvation as well as to improve spectroscopic properties because molecular orbital contributions for Q band can be affected by some substituents. Selected descriptors, electronic and steric, were pointed out as important to propose the new photosensitizers.
