ABSTRACT
Cobalt-Prussian blue analogues are remarkable catalysts for the oxygen evolution reaction (water oxidation) under mild conditions such as neutral pH. Although there are extensive reports in the literature about the application of these catalysts in water oxidation (the limiting step for hydrogen evolution), some limitations must be overcome in terms of improving the turnover frequency, oxygen production, long term stability, and elucidation of the mechanism. Another important feature to consider is the industrial processability of electrolytic cells for water splitting. For these reasons, we have reported herein a comparison of the electrochemical and chemical properties of three catalysts produced from cobalt-Prussian blue. Co-Co PBA 60 refers to cobalt-Prussian blue heated up to 60 °C with a high content of water. Co-Co PBA 200 is the same starting material but heated up to 200 °C with a low water content. Finally, Co3O4 is a thermal decomposition product obtained from heating cobalt-Prussian blue up to 400 °C. Although Co-Co PBA 60 has a higher overpotential for water oxidation than Co-Co PBA 200, this catalyst is kinetically faster than Co PBA 200. It is suggested that the water coordinated to Co2+ in Co-Co PBA 60 can accelerate the reaction and that there is a balance between the thermodynamic and kinetic characteristics for determining the final properties of the catalyst at pH = 7. Another important observation is that the Co3O4 catalyst has the best performance among the considered catalysts with the highest TON and TOF. This suggests that the different mechanisms and surface effects demonstrated by the Co3O4 catalyst are more conducive to efficient water oxidation than those of Prussian blue. Further studies concerning the effect of water and surface on these catalysts under mild conditions are essential to gain a better understanding of the mechanism of water oxidation and to advance the development of new catalysts.
ABSTRACT
Three-dimensional printing techniques have been widely used in the fabrication of new materials applied to energy, sensing and electronics due to unique advantages, such as fast prototyping, reduced waste generation, and multiple fabrication designs. In this paper, the production of a conductive 3D-printing filament composed of Ni(OH)2 microparticles and graphene within a polylactic acid matrix (Ni-G-PLA) is reported. The nanocomposite was characterized by thermogravimetric, energy-dispersive X-ray spectroscopic, scanning electronic microscopic, Raman spectroscopic and electrochemical techniques. Characteristics such as printability (using fused deposition modelling), electrical conductivity and mechanical stability of the polymer nanocomposite were evaluated before and after 3D printing. The novel 3D-printed disposable electrode was applied for selective detection of glucose (enzyme-less sensor) with a detection limit of 2.4 µmol L-1, free from the interference of ascorbic acid, urea and uric acid, compounds typically found in biological samples. The sensor was assembled in a portable electrochemical system that enables fast (160 injection h-1), precise (RSD < 5%) and selective determination of glucose without the need of enzymes (electrocatalytic properties of the Ni-G-PLA nanocomposite). The obtained results showed that Ni-G-PLA is a promising material for the production of disposable sensors for selective detection of glucose using a simple and low-cost 3D-printer.
