Nanomechanical properties of reversed surfactant bilayers formed in micrometre-sized holes.

Nanomechanical properties of free-standing reversed surfactant bilayers, dried foam films (DFFs), were examined via AFM by fitting local force-indentation curves with a Hertzian model. The Young's moduli of four kinds of bilayers were in a range of 10-30 MPa.

Distribution of olfactory marker protein on a tissue section of vomeronasal organ measured by AFM.

Distribution of olfactory marker protein (OMP) on a tissue section of vomeronasal organ (VNO) was successfully measured by atomic force microscopy (AFM). Anti-OMP antibodies were covalently crosslinked with the tip of the AFM and were used as a probe to observe the distribution of OMP on a tissue section. First, force measurements were performed using a glass surface on which OMP was covalently immobilized to verify the success of tip modification. Clear differences of interaction forces were observed between a specific pair and the control experiments, indicating that the tip preparation succeeded. Next, distributions of OMP on the tissue section were observed by AFM and were compared with immunohistochemical observations. For large scale observation, a microbead was used as a probe in the AFM measurements. The results of the AFM measurements were well overlapped with that of immunohistochemistry, confirming the reliability of our method. A mapping of the AFM measurement with high resolution was also successfully obtained, which showed an advantage of the application of the AFM measurement in analysis of proteins on the tissue section.

Quantification of the number of EP3 receptors on a living CHO cell surface by the AFM.

The distribution of EP3 receptors on a living cell surface was quantitatively studied by atomic force microscopy (AFM). Green fluorescent protein (GFP) was introduced to the extracellular region of the EP3 receptor on a CHO cell. A microbead was used as a probe to ensure certain contact area, whose surface was coated with anti-GFP antibody. The interactions between the antibodies and GFP molecules on the cell surface were recorded to observe the distribution of the receptors. The result indicated that EP3 receptors were distributed on the CHO cell surface not uniformly but in small patches coincident with immunohistochemical observation. Repeated measurements on the same area of cell surface gave confirmation that it was unlikely that the receptors were extracted from the cell membrane during the experiments. The measurement of single molecular interaction between GFP and the anti-GFP antibody was succeeded on the cell surface using compression-free force spectroscopy. The value of separation work required to break a single molecular pair was estimated to be about 1.5 x 10(-18)J. The number of EP3 receptor on the CHO cell surface was estimated using this value to be about 1 x 10(4) under the assumption that the area of the cell surface was about 5,000 microm(2). These results indicated that the number of receptors on a living cell surface could be quantified through the force measurement by the AFM.

AFM observation of immobilized self-oscillating polymer.

Various types of nanocomponents have been developed to construct a nanodevice or nanomachine. Here, we add a new nanocomponent that has the function of self-oscillation. A thermoresponsive polymer carrying a Ru complex, a catalyst of the Belousov-Zhabotinsky reaction, was synthesized and immobilized on a glass plate. Periodic turbidity changes in the aqueous solution of the polymer were observed, and nanoscale self-oscillation of the immobilized polymer was observed by a scanning probe microscope.

Origin of mechanical strength of bovine carbonic anhydrase studied by molecular dynamics simulation.

The forced unfolding process of bovine carbonic anhydrase II (BCA II) was examined at the atomic level by the molecular dynamics (MD) simulation. By force spectroscopy, experimentally obtained force-extension curves (F-E curves) showed a prominent force peak after 50 nm extension. F-E curves obtained from our simulation had three force peaks appearing after extensions of 10-17 nm, 40 nm, and 53 nm, each signifying a brittle fracture of a specific local structure. Upon undergoing the final fracture at 53 nm of extension, the entire molecule became a single flexible chain and was further extended to its full theoretical length, almost as a random coil. This feature of the 53-nm peak strongly suggested its close correspondence to the experimentally observed force peak at approximately 60-nm extension. The 53-nm peak in the molecular dynamics simulation corresponded to the unfolding process of the beta-sheeted core that includes zinc-coordinating histidine residues. These results suggest that the structural change occurring at 50-60 nm in atomic force microscopy experiments corresponded to the destruction of the zinc coordination site.

High sensitivity detection of protein molecules picked up on a probe of atomic force microscope based on the fluorescence detection by a total internal reflection fluorescence microscope.

We developed a method to detect and identify proteins on a probe of the atomic force microscope (AFM) with a high sensitivity. Due to a low background noise of the total internal reflection fluorescence microscope employed as a detecting system, we were able to achieve a high enough sensitivity to detect zeptomole orders of protein molecules immobilized on the tip. Several different methods to immobilize protein molecules to AFM-probes were tested, meant for a wide range of applications of this method. Furthermore, we demonstrated that different proteins were clearly distinguished by immunofluorescence microscopy on the probe using their specific antibodies.

Quantitative analysis of the number of antigens immobilized on a glass surface by AFM.

To develop force measurements using an atomic force microscope (AFM) in a quantitative manner, it is necessary to estimate the number density of target molecules on a sample surface, and for this, the sensitivity of detection should be known. In this study, the AFM was used as a mechanical detector and an antigen and its antibody were used as a model to evaluate the sensitivity of detection. Antigens were immobilized on a glass surface and number density was estimated by monitoring optical absorbance due to product formation by the reaction of crosslinkers. The concentration of antigen was controlled by mixing control peptides. A microbead was used as a probe and antibodies were immobilized on the bead. AFM force measurements were then made for a range of number densities in the order of 10-10(6) antigen molecules per square micrometer of surface and were compared to evaluate the sensitivity of detection. Our result establishes the reliability of estimating a number of molecules like receptors on the cell surface, and indicates that the AFM is useful as a mechanical detector with high sensitivity.

Dynamics of a partially stretched protein molecule studied using an atomic force microscope.

The dynamics of a single protein molecule subjected to forced mechanical unfolding was investigated in a millisecond time domain using a custom-made atomic force microscope (AFM) apparatus, which allows simultaneous measurements of an average tensile force applied to a single molecule and its mechanical response with respect to an external oscillation. Our target protein was genetically engineered bovine carbonic anhydrase II (BCA) which is a monomeric globular protein, and it has been shown that the as-expressed BCA from Escherichia coli contains two conformational isomers, one with enzymatic activity (type I) and the other without (type II). An interesting feature observed from the dynamic measurements was that when the type I BCA conformer was extended, it often exhibited a clear out-of-phase response against an external oscillation. The type II BCA conformer, however, always exhibited an in-phase response to the external oscillation. This relationship between different types of BCA and their dynamical behaviors was evidently observed around the discontinuous transition point from type I to II.

Unfolding mechanics of multiple OspA substructures investigated with single molecule force spectroscopy.

We investigated mechanical unfolding of Borrelia burgdorferi outer surface protein A (OspA), a Lyme disease antigen containing a unique single-layer beta-sheet, with atomic force microscopy (AFM). We mechanically stretched a monomeric unit, rather than a tandem repeat, by pulling it from its N and C-terminal residues without using intervening polymer as a spacer. We detected two peaks in the force-extension profile before the final rupture of a fully extended polypeptide, which we interpreted as unfolding of multiple substructures in OspA. The double-peaked unfolding curves are consistent with results of previous thermodynamic studies showing two cooperative units in OspA. The mechanical unfolding processes were reversible, and the two substructures refolded within one second. Mutations near the boundary of the two thermodynamic cooperative units reduced the height of the first unfolding peak to undetectable levels and marginally affected the second one, indicating that the boundary between the two mechanical substructures is related to that previously assigned between the thermodynamic cooperative units. Based on a "worm-like chain" analysis of our AFM data, we propose a model for mechanical unfolding of OspA, where nearly a half of the chain is stretched with minimal resistive force, followed by sequential breakdown of C-terminal and N-terminal substructures. Based on these results, we discuss similarities and differences between mechanical and thermodynamic unfolding reactions of OspA. This work demonstrates that AFM study of monomeric proteins can elucidate details of the intramolecular mechanics of protein substructures.

Inhibition of human pepsin and gastricsin by alpha2-macroglobulin.

The inhibitory effects of human alpha2-macroglobulin (alpha2-M), a major plasma proteinase inhibitor, on human pepsin and gastricsin were investigated. The activities of pepsin and gastricsin towards a protein substrate (reduced and carboxymethylated ribonuclease A) were significantly inhibited by alpha2-M at pH 5.5, whereas those towards a peptide substrate (oxidized insulin B-chain) were scarcely inhibited. Under these conditions at pH 5.5, pepsin and gastricsin cleaved alpha2-M mainly at the His694-Ala695 bond and Leu697-Val698 bond, respectively, in the bait regions sequence of alpha2-M. The conformation of alpha2-M was also shown to be markedly altered upon inhibition of these enzymes as examined by native polyacrylamide gel electrophoresis and electron microscopy. These results show the entrapment and concomitant inhibition of those proteinases by alpha2-M.

Extraction of membrane proteins from a living cell surface using the atomic force microscope and covalent crosslinkers.

The force curve mode of the atomic force microscope (AFM) was applied to extract intrinsic membrane proteins from the surface of live cells using AFM tips modified by amino reactive bifunctional covalent crosslinkers. The modified AFM tips were individually brought into brief contact with the living cell surface to form covalent bonds with cell surface molecules. The force curves recorded during the detachment process from the cell surface were often characterized by an extension of a few hundred nanometers followed mostly by a single step jump to the zero force level. Collection and analysis of the final rupture force revealed that the most frequent force values (of the force) were in the range of 0.4-0.6 nN. The observed rupture force most likely represented extraction events of intrinsic membrane proteins from the cell membrane because the rupture force of a covalent crosslinking system was expected to be significantly larger than 1.0 nN, and the separation force of noncovalent ligand-receptor pairs to be less than 0.2 nN, under similar experimental conditions. The transfer of cell surface proteins to the AFM tip was verified by recording characteristic force curves of protein stretching between the AFM tips used on the cell surface and a silicon surface modified with amino reactive bifunctional crosslinkers. This method will be a useful addition to bionanotechnological research for the application of AFM.

Specific interaction between GroEL and denatured protein measured by compression-free force spectroscopy.

We investigated the interaction between GroEL and a denatured protein from a mechanical point of view using an atomic force microscope. Pepsin was bound to an atomic force microscope probe and used at a neutral pH as an example of denatured proteins. To measure a specific and delicate interaction force, we obtained force curves without pressing the probe onto GroEL molecules spread on a mica surface. Approximately 40 pN of tensile force was observed for approximately 10 nm while pepsin was pulled away from the chaperonin after a brief contact. This length of force duration corresponding to the circumference of GroEL's interior cavity was shortened by the addition of ATP. The relation between the observed mechanical parameters and the chaperonin's refolding function is discussed.

Quantification of cell adhesion force with AFM: distribution of vitronectin receptors on a living MC3T3-E1 cell.

Distribution of vitronectin (VN) receptors on a living murine osteoblastic cell was successfully measured by atomic force microscopy (AFM). First, the distribution of the integrin beta(5) subunit which constitutes a part of the VN receptor on the cell was confirmed by conventional immunohistochemistry after fixing the cell. To visualize the distribution of the receptor on a living cell by an independent and potentially a more quantitative method, the AFM was used with a microbead attached to the cantilever tip to increase the area of contact and VN was immobilized on the microbead. Force measurements were then performed over a large area of a living murine osteoblastic cell using the microbead covered with VN.

Reversible stretching of a monomeric unit in a dimeric bovine carbonic anhydrase B with the atomic force microscope.

We have previously shown that a full stretching of native carbonic anhydrase B (CAB) using the atomic force microscope could not be achieved, presumably due to the presence of a 'knot' in the C-terminal region of the protein. When we used an engineered dimer of CAB, where the N-terminal monomeric unit (unit I) was expected to be 'knotless', we successfully recorded extension of the protein up to 110 nm which was long enough to account for the full extension of unit I monomer. In this paper we report that, by limiting the maximum length of extension to 90 nm extensions (corresponding to about 80 nm extension of the dimer and 70 nm of unit I), retractions of the polypeptide chain can be repeated cyclically without breaking the covalent crosslinking system. The force-extension curves obtained from the forward and reverse cycles of such experiments were almost perfectly superimposable with each other and with the corresponding part of the curves obtained from full extension experiments suggesting that the structure of unit I in the dimer was reversibly stretched and contracted. During the stretching of unit I of the dimer in either type of the experiments mentioned above, we occasionally observed a force peak having the force of about 0.5-0.7 nN when extension length reached 40-50 nm. We interpreted the appearance of such force peaks as an indication of formation of a tightly folded domain structure in unit I of CAB dimer.

Use of AFM for imaging and measurement of the mechanical properties of light-convertible organelles in plants.

We obtained topographic images of etioplasts and chloroplasts and measured their elasticity in a physiological buffer using an atomic force microscope (AFM) and found a possible correlation between the morphological and mechanical properties during the light conversion of etioplasts to chloroplasts. Alcian blue 8GX dye was found to be effective for immobilizing the plant organelles stably on a glass surface for AFM experiments. We employed the tapping-mode AFM with a cantilever soft enough to measure the elasticity of the organelles in a liquid solution. The best images of soft, spherical organelles were obtained using the tapping-mode AFM with oscillation at the thermal vibration frequency of the cantilever of around 3 kHz. Whereas etioplasts were found to be smooth-surfaced and stiff against compression by the AFM tip, before light conversion to chloroplasts, they became rough-surfaced and mechanically soft after exposure to light. The elasticity of etioplasts was 20 times higher than that of chloroplasts, probably reflecting changes in their inner structures.