Design and field application of an automated cartridge sampler for VOC concentration and flux measurements.

One of the major limitations in advancing the understanding of tropospheric ozone and aerosol generation and developing strategies for their control is the technical ability to accurately measure volatile organic compounds (VOCs). This paper describes the design of a constant flow VOC sampler. The versatile sampler can be used for fully automated concentration and flux measurements of VOCs. The sampler incorporates a microprocessor control unit and provides highly accurate mass flow control and significant ease of operation. Sampling sequences can be programmed directly or by remote control through a PC. All important operational parameters necessary for a complete sampling audit trail are logged. Compact weatherproof housings and low power consumption allow operation at remote sites and locations which are sensitive to disturbances or have restricted access. Inner wetted surfaces of the sampler are constructed from non-contaminating materials that do not sorb or emit VOC, and thus permit the collection of representative samples even in environments with very low VOC concentrations. The cartridge magazine provides a maximum of 20 sequential cartridge samples, which allows for long-term air quality assessments. In the dual channel mode, two samples can be collected simultaneously through two independent sample loops, providing ten sequential sample pairs. This design allows the parallel collection of (a) quality assurance backup samples, (b) samples on two different types of cartridges/sorbents to allow a variety of analyses, or (c) differential samples for flux measurements using enclosure, aerodynamic profile, or relaxed eddy accumulation (REA) methods. Field applications including airplane profile measurements above a tropical rainforest area, as well as gradient and REA measurements over a mid-latitude mixed forest stand are described, and demonstrate the validity and flexibility of the system. In particular, the application of the VOC sampler as an integrated part of a REA system is emphasized.

Laboratory-scale measurement of trace gas fluxes from landfarm soils.

Trace gas emissions from refinery and bioremediation landfarms were investigated in a mesocosm-scale simulator facility. Five simulators were constructed and integrated with a data acquisition system and trace gas analyzers, allowing automated real-time sampling and calculation of total hydrocarbon (THC), CO2, and water vapor fluxes. Experiments evaluating the influence of simulated cultivation and rainfall on trace gas fluxes from the soil surfaces were conducted. Results were compared with published field results. Results showed that cultivating dry or moderately wet soil resulted in brief enhancements of THC fluxes, up to a factor of 10, followed by a sharp decline. Cultivating dry soil did not enhance respiration. Cultivating wet soil did result in sustained elevated levels of respiration. Total hydrocarbon emissions were also briefly enhanced in wet soils, but to a lesser magnitude than in dry soil. Hydrocarbon fluxes from refinery landfarm soil were very low for the duration of the experiments. This lead to the conclusion that elevated THC fluxes would only be expected during waste application. An evaluation of the influence of simultaneous water vapor fluxes on other trace gas fluxes highlighted the importance in lab-scale experiments of correcting trace gas fluxes from soils. The results from this research can be used to guide management practices at landfarms and to provide data to aid in assessing the effect of landfarms.

Volatile hydrocarbon emissions from a diesel fuel-contaminated soil bioremediation facility.

Concerns have been expressed that emissions of volatile hydrocarbons (HCs) from bioremediation facilities containing soils contaminated with petroleum HCs may negatively impact regional air quality or human health. Little information is available regarding the emission of HCs from bioremediation sites, and few field studies have been performed during which the flux of HCs has been directly measured during bioremediation. To aid in answering questions about the impact of bioremediation facilities on the atmospheric environment, a two-part field study was conducted over summer 1996 at a remote landfarm in northern Ontario where diesel fuel-contaminated soil was undergoing bioremediation. Volatile total hydrocarbon (THC) atmospheric flux measurements were successfully taken over 18 days using a flux gradient micrometeorological technique incorporating a THC detector constructed in-house. Peak THC emissions reached 131 microg C/m2/sec shortly after implementation and tilling of the landfarm soil. The influence of soil temperature and tillage on THC emissions was examined. Off-site inhalation exposure was considered with the aid of an areal source model and results from speciated air samples collected on sorbent tubes and analyzed via gas chromatography/mass spectrometry (GCMS) techniques.