Mobility of crocidolite asbestos in sandy porous media mimicking aquifer systems.

Asbestos is widely recognized as being a carcinogen when dispersed in air, but very little is known about its exposure pathways in water and its subsequent effects on human health. Several studies have proved asbestos presence in groundwater but failed to assess its mobility in aquifer systems. This paper aims to fill this gap by studying the transport of crocidolite, an amphibole asbestos, through sandy porous media mimicking different aquifer systems. To this purpose, two sets of column test were performed varying the crocidolite suspension concentration, the quartz sand grain size distribution, and the physicochemical water parameters (i.e., pH). The results proved that crocidolite is mobile in quartz sand due to the repulsive interactions between fibres and porous media. The concentration of fibres at the outlet of the column were found to decrease when decreasing the grain size distribution of the porous medium, with a bigger impact on highly concentrated suspensions. In particular, 5-to-10-µm-long fibres were able to flow through all the tested sands while fibres longer than 10 µm were mobile only through the coarser medium. These results confirm that groundwater migration should be considered a potential exposure pathway while implementing human health risk assessment.

Waterborne asbestos: Good practices for surface waters analyses.

Asbestos occurrence has been mainly monitored in air so far and only limitedly considered in other matrices, such as water. Waterborne asbestos could originate from natural or anthropogenic sources, leading to non-conventional exposure scenarios. It could be a secondary source of airborne asbestos in case of water-to-air migration, particularly in case of surface moving water, such as in rivers and streams. The scarce attention dedicated to waterborne asbestos has led to a considerable fragmentation in regulatory approaches regarding the study of water samples possibly contaminated by mineral fibres. In this context, this study has been designed to test the reliability of an existing analytical method devoted to natural waters investigations. Following the operational protocol issued by the Piedmont (Italy) Environmental Protection Agency, Scanning Electron Microscopy analyses have been performed on a standard sample of waterborne chrysotile, mimicking stream water. The investigations have been performed by different operators and using different analytical setups, to verify whether the method applied has a good interlaboratory reproducibility and which could be the most error-prone analytical steps. Three data sets have been obtained on the same sample, showing a low reproducibility among each other. Possible reasons causing this discrepancy have been discussed in detail and good practices to perform reliable analyses on surface water samples containing asbestos have been proposed to help the regulatory organs to better define analytical protocols.

Chrysotile asbestos migration in air from contaminated water: An experimental simulation.

In Naturally Occurring Asbestos (NOA) rich areas, water flows through asbestos bearing rocks and soils and generates waterborne fibres that may migrate in air and become a risk for humans. Research on the migration and dispersion after water vaporisation has been so far only marginally evaluated. This study investigates the migration in air of asbestos from a set of suspensions contaminated by chrysotile from Balangero (Italy), under controlled laboratory conditions. We evaluated i) the morphological modifications that might occur to chrysotile during migration from water to air, and ii) the amount of airborne chrysotile mobilised from standardised suspensions. Morphological alteration of asbestos fibres occurred during water-air migration and impacted on the analytical response of electron microscopy. Waterborne asbestos concentration higher than 40 ∙ 106 f/L generates in air concentration higher than 1 fibre per litre [f/L], the alarm threshold limit set by World Health Organization for airborne asbestos. A possible correlation between the waterborne fibre concentration as mass or number of fibres per volume unit [µg/L or f/L] was observed.

Innovative unattended SEM-EDS analysis for asbestos fiber quantification.

Scanning electron microscopy with energy dispersive spectrometry (SEM-EDS) is the only affordable analytical technique that can discriminate both morphology and elemental composition of inorganic fibers. SEM-EDS is indeed required to quantify asbestos in confounding natural matrixes (e.g. ophiolites), but is also time-consuming, operator dependent, and strongly relies on the stochastic distribution of the fibers on the filter surface. The balance between analytical time/cost and the method sensibility allows only about 0.5% of the filter to be analyzed, strongly affecting the statistical significance of results. To improve sensitivity and precision and enhance productivity, an unattended quantitative measurement of the asbestos fibers by SEM-EDS is proposed. The method identifies the particle shape first and determines their chemical composition later, saving EDS analytical time. Our approach was tested on four asbestos standards and the relative error on replicated measurements was < 10%. The proposed unattended method quantifies asbestos in natural confounding matrix, also with a very low asbestos content.

New criteria for the characterization of traditional East Asian papers.

We report a pyrolysis-gas chromatography/mass spectrometry (Py-GC/MS) method capable of analyzing traditional East Asian papers. The method proposed is based on rapid and easy single step Py-GC/MS analysis that can be carried out with a minimum amount of matter, in the few microgram range. Three reference papers manufactured from kozo (Broussonetia kazinoki Siebold & Zucc.), mitsumata (Edgeworthia chrysantha Lindl.), and gampi (Wikstroemia sikokiana Franch. & Sav.) with the traditional hand paper making processes were examined. The method allows discrimination between terpenic and steroid compounds, which were revealed as chemical markers of origin of the plant fibers. Each paper investigated was found to have characteristic pyrolysis fingerprints that were unique to the traditional handmade paper, demonstrating the potential for differentiation of these biochemical components of fiber plants on East Asian papers towards identification and conservation of cultural heritage. The investigation on Py-GC/MS was extended to liquid extraction followed by GC/MS analysis to characterize the biochemical components of fiber plants. The main contribution of this study is to provide molecular criteria for discriminating plant species used for traditional East Asian hand papermaking. Py-GC/MS complements efficiently microscope identification especially for adverse cases. A case study of archaeological Chinese paper painting artefacts was thereafter successfully investigated to address informative potential and efficiency of the criteria of identification on ancient and degraded East Asian paperworks.