Passive sampler housing and sorbent type determine aquatic micropollutant adsorption and subsequent bioassay responses.

The combination of integrative passive sampling and bioassays is a promising approach for monitoring the toxicity of polar organic contaminants in aquatic environments. However, the design of integrative passive samplers can affect the accumulation of compounds and therewith the bioassay responses. The present study aimed to determine the effects of sampler housing and sorbent type on the number of chemical features accumulated in polar passive samplers and the subsequent bioassay responses to extracts of these samplers. To this end, four integrative passive sampler configurations, resulting from the combination of polar organic chemical integrative sampler (POCIS) and Speedisk housings with hydrophilic-lipophilic balance and hydrophilic divinylbenzene sorbents, were simultaneously exposed at reference and contaminated surface water locations. The passive sampler extracts were subjected to chemical non-target screening and a battery of five bioassays. Extracts from POCIS contained a higher number of chemical features and caused higher bioassay responses in 91% of cases, while the two sorbents accumulated similar numbers of features and caused equally frequent but different bioassay responses. Hence, the passive sampler design critically affected the number of accumulated polar organic contaminants as well as their toxicity, highlighting the importance of passive sampler design for effect-based water quality assessment.

Contribution of sediment contamination to multi-stress in lowland waters.

Water bodies in densely populated lowland areas are often impacted by multiple stressors. At these multi-stressed sites, it remains challenging to quantify the contribution of contaminated sediments. This study, therefore, aimed to elucidate the contribution of sediment contamination in 16 multi-stressed drainage ditches throughout the Netherlands. To this end an adjusted TRIAD framework was applied, where 1) contaminants and other variables in the sediment and the overlying water were measured, 2) whole-sediment laboratory bioassays were performed using larvae of the non-biting midge Chironomus riparius, and 3) the in situ benthic macroinvertebrate community composition was determined. It was hypothesized that the benthic macroinvertebrate community composition would respond to all jointly present stressors in both water and sediment, whereas the whole-sediment bioassays would only respond to the stressors present in the sediment. The benthic macroinvertebrate community composition was indeed related to multiple stressors in both water and sediment. Taxa richness was positively correlated with the presence of PO4-P in the water, macrophyte cover and some pesticides. Evenness, the number of Trichoptera families and the SPEARpesticides were positively correlated to the C:P ratios in the sediment, whilst negative correlations were observed with various contaminants in both the water and sediment. The whole-sediment bioassays with C. riparius positively related to the nutrient content of the sediment, whereas no negative relations to the sediment-associated contaminants were observed, even though the lowered SPEARpesticides index indicated contaminant effects in the field. Therefore, it was concluded that sediment contamination was identified as one of the various stressors that potentially drove the benthic macroinvertebrate community composition in the multi-stressed drainage ditches, but that nutrients may have masked the adverse effects caused by low and diverse sediment contaminants on C. riparius in the bioassays.

Advancements in effect-based surface water quality assessment.

Legally-prescribed chemical monitoring is unfit for determining the pollution status of surface waters, and there is a need for improved assessment methods that consider the aggregated risk of all bioavailable micropollutants present in the aquatic environment. Therefore, the present study aimed to advance effect-based water quality assessment by implementing methodological improvements and to gain insight into contamination source-specific bioanalytical responses. Passive sampling of non-polar and polar organic compounds and metals was applied at 14 surface water locations that were characterized by two major anthropogenic contamination sources, agriculture and wastewater treatment plant (WWTP) effluent, as well as reference locations with a low expected impact from micropollutants. Departing from the experience gained in previous studies, a battery of 20 in vivo and in vitro bioassays was composed and subsequently exposed to the passive sampler extracts. Next, the bioanalytical responses were divided by their respective effect-based trigger values to obtain effect-based risk quotients, which were summed per location. These cumulative ecotoxicological risks were lowest for reference locations (4.3-10.9), followed by agriculture locations (11.3-27.2) and the highest for WWTP locations (12.8-47.7), and were mainly driven by polar organic contaminants. The bioanalytical assessment of the joint risks of metals and (non-)polar organic compounds resulted in the successful identification of pollution source-specific ecotoxicological risk profiles: none of the bioassays were significantly associated with reference locations nor with multiple location types, while horticulture locations were significantly characterized by anti-AR and anti-PR activity and cytotoxicity, and WWTP sites by ERα activity and toxicity in the in vivo bioassays. It is concluded that the presently employed advanced effect-based methods can readily be applied in surface water quality assessment and that the integration of chemical- and effect-based monitoring approaches will foster future-proof water quality assessment strategies on the road to a non-toxic environment.

Effect-based nationwide surface water quality assessment to identify ecotoxicological risks.

A large portion of the toxic effects observed in surface waters cannot be attributed to compounds regularly measured by water authorities. Hence, there is an urgent need for an effect-based monitoring strategy that employs bioassays to identify environmental risks. The aim of the present study was to perform an effect-based nationwide water quality assessment to identify ecotoxicological risks in a wide variety of surface waters. At 45 locations silicone rubbers and polar organic chemical integrative samplers were exposed to surface water for 6 weeks. Alongside the passive samplers an in-situ daphnid test was performed. Subsequent to field exposure, accumulated compounds were extracted from the passive samplers after which a battery of in vivo and in vitro bioassays was exposed to the extracts. The bioassay battery was selected such that it could identify the risks posed by a wide range of chemical pollutants and their transformation products, while simultaneously allowing for targeted identification of groups of compounds that cause specific effects. Bioassay responses were compared to effect-based trigger values to identify potential ecotoxicological risks at the investigated locations. Responses were observed in all bioassays, and trigger values were exceeded in 9 out of the 21 applied assays, allowing for ranking of the investigated locations based on ecotoxicological risks. No relationship between land use and the identification of ecotoxicological risks was observed. Based on the results, considerations regarding future improvements of effect-based monitoring are given. It is concluded that effect-based water quality assessment allowed prioritization of sites based on ecotoxicological risks, identified the presence of hazardous compounds regardless of being listed as priority substances, and meanwhile could prevent costly chemical analysis at sites with low ecotoxicological risks.

Nationwide screening of surface water toxicity to algae.

According to the European Water Framework Directive (WFD), chemical water quality is assessed by monitoring 45 priority substances. However, observed toxic effects can often not be attributed to these priority substances, and therefore there is an urgent need for an effect-based monitoring strategy that employs bioassays to identify environmental risk. Algal photosynthesis is a sensitive process that can be applied to identify the presence of hazardous herbicides in surface water. Therefore, the aim of this study was to employ an algal photosynthesis bioassay to assess surface water toxicity to algae and to identify the compounds causing the observed effects. To this purpose, Raphidocelis subcapitata was exposed to surface water samples and after 4.5 h photosynthetic efficiency was determined using PAM fluorometry. In this rapid high throughput bioassay, algal photosynthesis was affected by surface water from only one of 39 locations. Single compounds toxicity confirmation elucidated that the observed effect could be solely attributed to the herbicide linuron, which occurred at 110 times the EQS concentration and which is not included in the WFD priority substances list. In conclusion, applying the algal photosynthesis bioassay enables more efficient and effective assessment of toxicity to primary producers because it: (i) identifies the presence of herbicides that would be overlooked by routine chemical WFD monitoring, and (ii) avoids redundant chemical analyses by focusing only on (non-)target screening in samples with demonstrated effects.

The relationship between disease pattern and disease burden by chest radiography, M. tuberculosis Load, and HIV status in patients with pulmonary tuberculosis in Addis Ababa.

BACKGROUND: We evaluated the impact of HIV coinfection on the chest radiographic pattern and extent of disease and its relation to the load of Mycobacterium tuberculosis in Ethiopian out-patients with pulmonary tuberculosis. PATIENTS AND METHODS: A total of 168 patients with cultureverified pulmonary tuberculosis had their chest X-rays (CXR) reviewed for the site, pattern, and extent of disease and the findings were correlated to (a) the mycobacterial culture count and bacillus load after sputum concentration and (b) the HIV status of the patients. RESULTS: HIV-positive patients were less likely to have cavitary disease (p < 0.001) and more likely to have pleural effusion (p = 0.08), miliary (p < 0.05), and interstitial (p < 0.01) patterns. A total of 15 (9.2%) patients had normal chest X-rays. HIV-infected patients had a CXR classified as normal or with minimal involvement (p = 0.059) and a reduced mycobacterial colony count (p = 0.002) compared to HIV-negative patients. Middle and lower lung involvement were more common in HIV-positive patients. CONCLUSION: CXR findings in the setting of an underlying HIV infection tend to be more atypical and could present as either normal or with minimal involvement. In general, HIV-positive patients had lower colony count of M. tuberculosis than HIV-negative patients. Of particular interest is the finding of a large number of normal chest X-rays in HIV-infected patients. With the rising incidence of both tuberculosis and HIV infection in Ethiopia, the finding of a normal chest X-ray and a negative smear poses a challenge for the diagnosis of pulmonary tuberculosis.