Spin injection enhancement in CW VECSEL at room temperature using push-pull optical pumping.

We report the enhancement of spin injection efficiency in an external-cavity VCSEL based on a non-resonant pumping coupled with a polarized optical resonant illumination. This double pumping scheme allows both the injection of spin polarized electrons in the conduction band and the selection of the spin orientation for the electron/hole recombination laser process. Experimentally, a flip of the polarization state of the laser is achieved with an ellipticity of +31° (spin down) and -33° (spin up), so an increase of about 50% of the ellipticity is achieved in comparison to an optical non-resonant pumping alone.

Fully-correlated multi-mode pumping for low-noise dual-frequency VECSELs.

We report a fully-correlated multi-mode pumping architecture optimized for dramatic noise reduction of a class-A dual-frequency Vertical External Cavity Surface Emitting Laser (VECSEL). Thanks to amplitude division of a laser diode, the two orthogonally polarized modes emitted by the VECSEL oscillating at 852 nm are separately pumped by two beams exhibiting fully in-phase correlated intensity noises. This is shown to lead to very strong and in-phase correlations between the two lasing modes intensities. As a result, the phase noise power spectral density of the RF beat note generated by the two modes undergoes a drastic reduction of about 10 to 20 dB throughout the whole frequency range from 10 kHz to 20 MHz and falls below the detection floor above a few MHz. A good agreement is found with a model which uses the framework of rate equations coupled by cross-saturation. The remaining phase noise is attributed to thermal effects and additional technical noises and lies mainly within the bandwidth of a phase-locked-loop.

Ultra-low noise dual-frequency VECSEL at telecom wavelength using fully correlated pumping.

An ultra-low intensity and beatnote phase noise dual-frequency vertical-external-cavity surface-emitting laser is built at telecom wavelength. The pump laser is realized by polarization combining two single-mode fibered laser diodes in a single-mode fiber, leading to a 100% in-phase correlation of the pump noises for the two modes. The relative intensity noise is lower than -140 dB/Hz, and the beatnote phase noise is suppressed by 30 dB, getting close to the spontaneous emission limit. The role of the imperfect cancellation of the thermal effect resulting from unbalanced pumping of the two modes in the residual phase noise is evidenced.

VSPIN: a new model relying on the vectorial description of the laser field for predicting the polarization dynamics of spin-injected V(e)CSELs.

A new vectorial model (VSPIN) based on the Jones formalism is proposed to describe the polarization dynamics of spin injected V(e)CSELs. This general modelling framework accounts for spin injection effects as a gain circular dichroism in the active medium and provides guidelines for developing functional spin-controlled lasers. We investigate the detrimental role of phase anisotropy on polarization switching and show that it can be overcome by preparing the laser cavity to achieve efficient polarization switching under low effective spin injection. The VSPIN model predictions have been confirmed experimentally and explain the polarization behavior of spin-VCSELs reported in the literature.

Compensation of the residual linear anisotropy of phase in a vertical-external-cavity-surface-emitting laser for spin injection.

We report on the compensation of the linear anisotropy of phase in a vertical-external-cavity surface-emitting laser from 21 to 0.5 mrad with an intracavity PLZT electro-optical ceramic. It allows dynamic and accurate control of the laser linear anisotropy, as well as dynamic control of the laser polarization eigenstates. At the birefringence compensation point, we observe an elliptical polarization state with 41° of ellipticity, rotated from its initial position of 32°. The experimental observations are in close agreement with the theoretical predictions. Finally, we are able to demonstrate control of the polarization state with spin injection.

Reduction of residual excess noise in class-A lasers using two-photon absorption.

We demonstrate experimentally a significant reduction of the remaining excess intensity noise in a class-A semi-conductor laser. This is obtained by inserting into the laser cavity a buffer reservoir mechanism based on two-photon absorption in GaAs. The excess noise peaks at the laser-free spectral range, induced by the beating between the lasing mode and the amplified spontaneous emission in the adjacent non-oscillating modes, is reduced by 20 dB, while preserving the class-A dynamical behavior of the laser cavity.

Accurate measurement of the residual birefringence in VECSEL: Towards understanding of the polarization behavior under spin-polarized pumping.

In this paper we report birefringence measurements of an optically pumped (100)-oriented InGaAs/GaAsP multiple quantum well (MQWs) Vertical External Cavity Surface Emitting Laser (VECSEL) in oscillating conditions. The proposed technique relies on the measurement in the microwave domain of the beatnote between the oscillating mode and the amplified spontaneous emission of the cross-polarized non-lasing field lying in the following longitudinal mode. This technique is shown to offer extremely high sensitivity and accuracy enabling to track the amount of residual birefringence according to the laser operation conditions. The experience fits within the broader framework of polarization selection in spin-injected lasers.

Class-A dual-frequency VECSEL at telecom wavelength.

We report class-A dual-frequency oscillation at 1.55 µm in a vertical external cavity surface emitting laser with more than 100 mW optical power. The two orthogonal linear polarizations of different frequencies oscillate simultaneously as their nonlinear coupling is reduced below unity by spatially separating them inside the active medium. The spectral behavior of the radio frequency beatnote obtained by optically mixing two polarizations and the phase noise of the beatnote have been explored for different coupling strengths between the lasing modes.

Experimental demonstration of a tunable dual-frequency semiconductor laser free of relaxation oscillations.

Tunable dual-frequency oscillation is demonstrated in a vertical external-cavity surface-emitting laser. Simultaneous and robust oscillation of the two orthogonally polarized eigenstates is achieved by reducing their overlap in the optical active medium. The class-A dynamics of this laser, free of relaxation oscillations, enables one to suppress the electrical phase noise in excess that is usually observed in the vicinity of the beat note.

Experimental investigation of relative intensity noise in Brillouin fiber ring lasers for microwave photonics applications.

Intensity noise characteristics of a single-mode Brillouin fiber ring laser are experimentally analyzed from 100 kHz up to 18 GHz. The Stokes wave is shown to be shot-noise limited to -155 dB/Hz for a 1 mA detected photocurrent over the whole spectral range 100 MHz-18 GHz. The pump-to-Stokes noise filtering efficiency is evaluated by artificially increasing the pump intensity noise. It evidences that a shot-noise-limited Brillouin laser could be realized by using a narrow-linewidth semiconductor laser pump, for stringent microwave photonics applications.

Evidence of ultra low microwave additive phase noise for an optical RF link based on a class--a semiconductor laser.

The additive RF phase noise of a microwave photonics link is measured using, as the optical source, a semiconductor laser operating in the class-A regime. The relative intensity noise of this laser being below the shot noise relative level, the phase noise floor of the link is shown to be shot noise limited, -152 dBc/Hz in our experimental conditions. As a result, the phase noise floor evolves as the inverse of the detected photocurrent, pushing the limits of performance to the availability of high power photo-detectors. Below 6 kHz from the carrier frequency at 3GHz, some noise, in excess with respect to the shot noise limit, is observed but remains lower than -110 dBc/Hz at 100 Hz offset frequency. This residual noise originates mainly from environmental noise and can be reduced by isolating the laser from acoustic/electromagnetic perturbations.

Shot-noise-limited operation of a monomode high-cavity-finesse semiconductor laser for microwave photonics applications.

Shot-noise-limited laser operation over a wide spectral bandwidth is demonstrated by using a semiconductor active medium inserted into a high-Q external cavity. This approach ensures, with a compact design, a sufficiently long photon lifetime to reach the oscillation-relaxation-free class A regime. The laser relative intensity noise is limited to the shot-noise relative floor, -156 dB/Hz for a 1 mA detected photocurrent, over the 100 MHz to 18 GHz bandwidth. The optimization of the laser cavity is discussed, and convenient shot-noise-limited operation is shown to be a trade-off between the cavity length and laser mode filtering.

Broad-bandwidth shot-noise-limited class-A operation of a monomode semiconductor fiber-based ring laser.

We demonstrate the operation of a monomode semiconductor laser with a relative intensity noise limited by the shot-noise floor, -156 dB/Hz for a typical detected photocurrent of 1 mA, over a large frequency range from 50 MHz to 18 GHz. We achieve direct control of photon lifetime to turn an initially class-B laser into a relaxation-oscillation-free class-A one while preserving strict single-mode operation. Finally, we confirm experimentally that the laser operation in the desired class-A regime allows a dramatic filtering out of the relative intensity noise.