ABSTRACT
Hydrogen-fluorine exchange in the NaBH4-NaBF4 system is investigated using a range of experimental methods combined with DFT calculations and a possible mechanism for the reactions is proposed. Fluorine substitution is observed using in situ synchrotron radiation powder X-ray diffraction (SR-PXD) as a new Rock salt type compound with idealized composition NaBF2H2 in the temperature range T = 200 to 215 °C. Combined use of solid-state (19)F MAS NMR, FT-IR and DFT calculations supports the formation of a BF2H2(-) complex ion, reproducing the observation of a (19)F chemical shift at -144.2 ppm, which is different from that of NaBF4 at -159.2 ppm, along with the new absorption bands observed in the IR spectra. After further heating, the fluorine substituted compound becomes X-ray amorphous and decomposes to NaF at ~310 °C. This work shows that fluorine-substituted borohydrides tend to decompose to more stable compounds, e.g. NaF and BF3 or amorphous products such as closo-boranes, e.g. Na2B12H12. The NaBH4-NaBF4 composite decomposes at lower temperatures (300 °C) compared to NaBH4 (476 °C), as observed by thermogravimetric analysis. NaBH4-NaBF4 (1:0.5) preserves 30% of the hydrogen storage capacity after three hydrogen release and uptake cycles compared to 8% for NaBH4 as measured using Sievert's method under identical conditions, but more than 50% using prolonged hydrogen absorption time. The reversible hydrogen storage capacity tends to decrease possibly due to the formation of NaF and Na2B12H12. On the other hand, the additive sodium fluoride appears to facilitate hydrogen uptake, prevent foaming, phase segregation and loss of material from the sample container for samples of NaBH4-NaF.
ABSTRACT
The microstructure of Cu(80)Fe(10)Ni(10) (at%) granular ribbon was investigated by means of atom probe tomography (APT). A granular system is composed of magnetic precipitates embedded in a non-magnetic matrix. In this ribbon, the magnetic precipitates have a diameter smaller than 5nm in the as-spun state, and their crystallographic structure is very similar to the one of the matrix, which makes it difficult to characterize them using conventional techniques. Those data are of great importance to understand the magnetic and the transport behaviour of these ribbons. Using atom probe tomography, a 3D reconstruction of the microstructure of the as-spun and annealed ribbons was achieved and a precise characterization of the compositions of the two phases and of the composition profile at interfaces was carried out. In the as-spun state the composition of the matrix is Cu(89)Fe(3)Ni(8), the one of the precipitates is Cu(30)Fe(40)Ni(30). Upon annealing, the precipitates get enriched in iron. After annealing at 600 degrees C for 24h, the measured compositions are close to the one predicted by Thermocalc, with Cu(94)Fe(1)Ni(5) for the matrix and Cu(5)Fe(64)Ni(31) for the precipitates.
ABSTRACT
A relationship between electrocatalytic activity for the hydrogen evolution reaction and the surface composition of the electrode was established for Ni-Zr crystalline and amorphous alloys by means of secondary ion mass spectrometry (SIMS). Electrocatalytic activity was tested by means of cathodic polarization in 1 M KOH at 25 degrees C and the resulting exchange current density has been taken as a measure of catalytic efficiency. Surface activation treatment involved chemical etching in HF solutions; the consequent morphological and compositional surface changes were studied by differential scanning calorimetry (DSC), X-ray diffraction (XRD) and scanning electron microscopy (SEM). The electrochemical behavior of the pure elements (Ni and Zr) was also considered for comparison. All samples submitted to chemical etching in HF solutions showed an increase in electrocatalytic activity, particularly the alloy with the highest Ni content. The beneficial effect of chemical etching is due to dissolution of the zirconium oxide layer and to the formation of nanocrystalline Ni on the surfaces.
