A high-throughput headspace gas chromatographic technique for the determination of nitrite content in water samples.

This paper reports on a high-throughput headspace gas chromatographic method (HS-GC) for the determination of nitrite content in water sample, based on GC measurement of cyclohexene produced from the reaction between nitrite and cyclamate in a closed vial. The method has a relative standard deviation of <3.5%; The differences between the results of the nitrite measurements obtained by this method and those of a reference method were less than 5.8% and the recoveries of the method were in the range of 94.8-102% (for a spiked nitrite content range from 0.002 to 0.03 mg/L). The limit of detection of the method was 0.46 µg L-1. Due to an overlapping mode in the headspace auto-sampler system, the method can provide an automated and high-throughput nitrite analysis for the surface water samples. In short, the present HS-GC method is simple, accurate, and sensitive, and it is very suitable to be used in the batch sample testing.

Efficient Determination of Specific Surface Area of Shale Samples Using a Tracer-Based Headspace Gas Chromatographic Technique.

This paper reports on a novel method for determining the specific surface area (SSA) of shale via headspace gas chromatography (HS-GC). The method is based on the water adsorption on the surface of shale sample after achieving phase equilibrium at an elevated temperature (i.e., heating at 125 °C for 48 h). A mathematical model shows that the SSA can be determined from the signal of the vapor water released during HS-GC analysis. The results obtained by this method correlated well (R2 = 0.992) with data obtained by the reference BET method. Because the phase equilibrium step for multiple samples can be conducted simultaneously, and because the phase re-equilibrium step is much faster in the HS-GC measurement, the present method is more efficient for batch sample testing.

Determination of the solubility of low volatility liquid organic compounds in water using volatile-tracer assisted headspace gas chromatography.

This study reports a new headspace gas chromatographic method (HS-GC) for the determination of water solubility of low volatility liquid organic compounds (LVLOs). The HS-GC analysis was performed on a set of aqueous solutions containing a range of concentrations of toluene-spiked (as a tracer) LVLOs, from under-saturation to over-saturation. A plot of the toluene tracer GC signal vs. the concentration of the LVLO results in two lines of different slopes that intersect at the concentration corresponding to the compound's solubility in water. The results showed that the HS-GC method has good precision (RSD <6.3%) and good accuracy, in which the relative deference between the data measured by the HS-GC method and the reference method were within 6.0%. The HS-GC method is simple and particularly suitable for measuring the solubility of LVLOs at elevated temperatures. This approach should be of special interest to those concerned about the impact of the presence of low-volatility organic liquids in waters of environmental and biological systems.

A rapid method for simultaneously determining ethanol and methanol content in wines by full evaporation headspace gas chromatography.

This work reports on a full evaporation headspace gas chromatographic (FE HS-GC) method for simultaneously determining the ethanol (EtOH) and methanol (MeOH) content in wines. A small sample (10µL) was placed in a headspace sample vial, and a near-complete mass transfer of ethanol and methanol from the liquid sample to the vapor phase was obtained within three minutes at a temperature of 105°C, which allowed the measurement of the EtOH and MeOH content in the sample by GC. The results showed excellent precision and accuracy, as shown by the reproducibilities of 1.02% and 2.11% for EtOH and MeOH, respectively, and recoveries that ranged from 96.1% to 104% for both alcohols. The method is efficient, accurate and suitable for the determination of EtOH and MeOH in wine production and quality control.

A novel method for rapid determination of total solid content in viscous liquids by multiple headspace extraction gas chromatography.

This work demonstrates a novel method for rapid determination of total solid content in viscous liquid (polymer-enriched) samples. The method is based multiple headspace extraction gas chromatography (MHE-GC) on a headspace vial at a temperature above boiling point of water. Thus, the trend of water loss from the tested liquid due to evaporation can be followed. With the limited MHE-GC testing (e.g., 5 extractions) and a one-point calibration procedure (i.e., recording the weight difference before and after analysis), the total amount of water in the sample can be determined, from which the total solid contents in the liquid can be calculated. A number of black liquors were analyzed by the new method which yielded results that closely matched those of the reference method; i.e., the results of these two methods differed by no more than 2.3%. Compared with the reference method, the MHE-GC method is much simpler and more practical. Therefore, it is suitable for the rapid determination of the solid content in many polymer-containing liquid samples.

Rapid determination of methanol content in paper materials by alkaline extraction, coupled with headspace analysis.

This study reports on a rapid method for the determination of methanol in paper-based materials by alkaline extraction, coupled with headspace analysis. Methanol partition equilibria between solid-liquid phases and vapor-liquid phases were conducted in two separate containers, from which an equation for calculating the total methanol content in the original paper sample was derived. It was found that the extraction equilibrium of methanol from solid sample could be achieved within 5min at room temperature using a high-speed disintegrator, and a subsequent neutralization step is an effective way to prevent methanol from being regenerated at high temperature during headspace equilibration. The results showed that the relative standard deviations for reproducibility tests were in the range of 1.86-6.03%, and the recoveries were in the range of 92.3-107%. The present method is simple and practical; it can be an efficient tool for quantifying the methanol content in paper-based materials and thus play an important role in the investigation of methanol migration behavior in food and beverage packaging.

A new headspace gas chromatographic method for the determination of methanol content in paper materials used for food and drink packaging.

This study reports on a method for determination of methanol in paper products by headspace gas chromatography (HS-GC). The method is based on the hydrolysis of the pulp or paper matrix, using a phosphoric acid solution (42.5%) as the medium at 120 °C in 5 h (excluding air contact) in order to release matrix-entrapped methanol, which is then determined by HS-GC. Data show that, under the given conditions of hydrolysis, no methanol was formed from the methoxyl groups in the material. Reproducibility tests of the method generated a relative standard deviation of <3.5%, with recovery in the range of 93.4-102%. The present method is reliable, accurate, and suitable for use in batch testing of the methanol content in paper-related materials. The method can play an important role in addressing food safety concerns that may be raised regarding the use of paper materials in food and beverage packaging.

A new method for the determination of biological oxygen demand in domestic wastewater by headspace gas chromatography.

A headspace gas chromatographic method (HS-GC) has been developed for the determination of biological oxygen demand (BOD) in the water samples from domestic wastewater treatment plants. The method is based on measuring the remaining oxygen in the headspace of the sample (that has been seeded with microorganisms) in a closed container after a period of incubation. The relative standard deviation of the method in replicate testing was <4.9%. Further, the results differed by less than 6% when compared with the widely used reference method (the ISO standard) for determining BOD5. The limit of quantification in BODn testing was about 1.8 mg/L. The new method is simple and suitable for use in the batch sample testing for BODn measurement.