ABSTRACT
(1) Background: Occupational fatigue is a primary factor leading to work-related musculoskeletal disorders (WRMSDs). Kinematic and kinetic experimental studies have been able to identify indicators of WRMSD, but research addressing real-world workplace scenarios is lacking. Hence, the authors of this study aimed to assess the influence of physical strain on the Borg CR-10 body map, ergonomic risk scores, and foot pressure in a real-world setting. (2) Methods: Twenty-four participants (seventeen men and seven women) were included in this field study. Inertial measurement units (IMUs) (n = 24) and in-shoe plantar pressure measurements (n = 18) captured the workload of production and office workers at the beginning of their work shift and three hours later, working without any break. In addition to the two 12 min motion capture processes, a Borg CR-10 body map and fatigue visual analog scale (VAS) were applied twice. Kinematic and kinetic data were processed using MATLAB and SPSS software, resulting in scores representing the relative distribution of the Rapid Upper Limb Assessment (RULA) and Computer-Assisted Recording and Long-Term Analysis of Musculoskeletal Load (CUELA), and in-shoe plantar pressure. (3) Results: Significant differences were observed between the two measurement times of physical exertion and fatigue, but not for ergonomic risk scores. Contrary to the hypothesis of the authors, there were no significant differences between the in-shoe plantar pressures. Significant differences were observed between the dominant and non-dominant sides for all kinetic variables. (4) Conclusions: The posture scores of RULA and CUELA and in-shoe plantar pressure side differences were a valuable basis for adapting one-sided requirements in the work process of the workers. Traditional observational methods must be adapted more sensitively to detect kinematic deviations at work. The results of this field study enhance our knowledge about the use and benefits of sensors for ergonomic risk assessments and interventions.
Subject(s)
Occupational Diseases , Shoes , Male , Humans , Female , Occupational Diseases/diagnosis , Ergonomics/methods , Risk Factors , FatigueABSTRACT
The objectification of acute fatigue (during isometric muscle contraction) and cumulative fatigue (due to multiple intermittent isometric muscle contractions) plays an important role in sport climbing. The data of 42 participants were used in the study. Climbing performance was operationalized using maximal climbing-specific holding time (CSHT) by performing dead hangs. The test started with an initial measurement of handgrip strength (HGS) followed by three intermittent measurements of CSHT and HGS. During the test, finger flexor muscle oxygen saturation (SmO2) was measured using a near-infrared spectroscopy wearable biosensor. Significant reductions in CSHT and HGS could be found (p < 0.001), which indicates that the consecutive maximal isometric holding introduces cumulative fatigue. The reduction in CSHT did not correlate with a reduction in HGS over multiple consecutive maximal dead hangs (p > 0.35). Furthermore, there were no significant differences in initial SmO2 level, SmO2 level at termination, SmO2 recovery, and mean negative slope of the SmO2 saturation reduction between the different measurements (p > 0.24). Significant differences were found between pre-, termination-, and recovery- (10 s after termination) SmO2 levels (p < 0.001). Therefore, monitoring acute fatigue using athletes' termination SmO2 saturation seems promising. By contrast, the measurement of HGS and muscle oxygen metabolism seems inappropriate for monitoring cumulative fatigue during intermittent isometric climbing-specific muscle contractions.
ABSTRACT
Handgrip strength (HGS) appears to be an indicator of climbing performance. The transferability of HGS measurements obtained using a hand dynamometer and factors that influence the maximal climbing-specific holding time (CSHT) are largely unclear. Forty-eight healthy subjects (27 female, 21 male; age: 22.46 ± 3.17 years; height: 172.76 ± 8.91 cm; weight: 69.07 ± 12.41 kg; body fat: 20.05% ± 7.95%) underwent a maximal pull-up test prior to the experiment and completed a self-assessment using a Likert scale questionnaire. HGS was measured using a hand dynamometer, whereas CSHT was measured using a fingerboard. Multiple linear regressions showed that weight, maximal number of pull-ups, HGS normalized by subject weight, and length of the middle finger had a significant effect on the maximal CSHT (non-dominant hand: R2corr = 0.63; dominant hand: R2corr = 0.55). Deeper exploration using a machine learning model including all available data showed a predictive performance with R2 = 0.51 and identified another relevant parameter for the regression model. These results call into question the use of hand dynamometers and highlight the performance-related importance of body weight in climbing practice. The results provide initial indications that finger length may be used as a sub-factor in talent scouting.
ABSTRACT
The present study aimed to assess the effects of asymmetric muscle fatigue on the skin surface temperature of abdominal and back muscles. The study was based on a pre-post/follow-up design with one group and included a total of 41 subjects (22 male, 19 female; age, 22.63 ± 3.91; weight, 71.89 ± 12.97 kg; height, 173.36 ± 9.95). All the participants were asked to perform side bends in sets of 20 repetitions on a Roman chair until complete exhaustion. The pre-, post- and follow-up test (24 h after) skin surface temperatures were recorded with infrared thermography. Subjective muscle soreness and muscle fatigue were analyzed using two questionnaires. The results of the post hoc tests showed that skin temperature was statistically significantly lower in the post-tests than in the pre- and follow-up tests, but no meaningful differences existed between the pre- and follow-up tests. Asymmetric side differences were found in the post-test for the upper and lower areas of the back. Differences were also noted for the front in both the upper and lower areas. No thermographic side asymmetries were found at the pre- or follow-up measurement for either the back or the front. Our results support the potential of using thermographic skin surface temperature to monitor exercise and recovery in athletes, as well as its use in rehabilitational exercise selection.
ABSTRACT
Artificial intelligence and its subcategories of machine learning and deep learning are gaining increasing importance and attention in the context of sports research. This has also meant that the number of corresponding publications has become complex and unmanageably large in human terms. In the current state of the research field, there is a lack of bibliometric analysis, which would prove useful for obtaining insights into the large amounts of available literature. Therefore, the present work aims to identify important research issues, elucidate the conceptual structure of the research field, and unpack the evolutionary trends and the direction of hot topics regarding key themes in the research field of artificial intelligence in sports. Using the Scopus database, 1215 documents (reviews and articles) were selected. Bibliometric analysis was performed using VOSviewer and bibliometrix R package. The main findings are as follows: (a) the literature and research interest concerning AI and its subcategories is growing exponentially; (b) the top 20 most cited works comprise 32.52% of the total citations; (c) the top 10 journals are responsible for 28.64% of all published documents; (d) strong collaborative relationships are present, along with small, isolated collaboration networks of individual institutions; (e) the three most productive countries are China, the USA, and Germany; (f) different research themes can be characterized using author keywords with current trend topics, e.g., in the fields of biomechanics, injury prevention or prediction, new algorithms, and learning approaches. AI research activities in the fields of sports pedagogy, sports sociology, and sports economics seem to have played a subordinate role thus far. Overall, the findings of this study expand knowledge on the research situation as well as the development of research topics regarding the use of artificial intelligence in sports, and may guide researchers to identify currently relevant topics and gaps in the research.
Subject(s)
Artificial Intelligence , Deep Learning , Humans , Algorithms , Bibliometrics , Machine LearningABSTRACT
Clinical classification models are mostly pathology-dependent and, thus, are only able to detect pathologies they have been trained for. Research is needed regarding pathology-independent classifiers and their interpretation. Hence, our aim is to develop a pathology-independent classifier that provides prediction probabilities and explanations of the classification decisions. Spinal posture data of healthy subjects and various pathologies (back pain, spinal fusion, osteoarthritis), as well as synthetic data, were used for modeling. A one-class support vector machine was used as a pathology-independent classifier. The outputs were transformed into a probability distribution according to Platt's method. Interpretation was performed using the explainable artificial intelligence tool Local Interpretable Model-Agnostic Explanations. The results were compared with those obtained by commonly used binary classification approaches. The best classification results were obtained for subjects with a spinal fusion. Subjects with back pain were especially challenging to distinguish from the healthy reference group. The proposed method proved useful for the interpretation of the predictions. No clear inferiority of the proposed approach compared to commonly used binary classifiers was demonstrated. The application of dynamic spinal data seems important for future works. The proposed approach could be useful to provide an objective orientation and to individually adapt and monitor therapy measures pre- and post-operatively.
