Quantitative analysis of brain microstructure following mild blunt and blast trauma.

We induced mild blunt and blast injuries in rats using a custom-built device and utilized in-house diffusion tensor imaging (DTI) software to reconstruct 3-D fiber tracts in brains before and after injury (1, 4, and 7 days). DTI measures such as fiber count, fiber length, and fractional anisotropy (FA) were selected to characterize axonal integrity. In-house image analysis software also showed changes in parameters including the area fraction (AF) and nearest neighbor distance (NND), which corresponded to variations in the microstructure of Hematoxylin and Eosin (H&E) brain sections. Both blunt and blast injuries produced lower fiber counts, but neither injury case significantly changed the fiber length. Compared to controls, blunt injury produced a lower FA, which may correspond to an early onset of diffuse axonal injury (DAI). However, blast injury generated a higher FA compared to controls. This increase in FA has been linked previously to various phenomena including edema, neuroplasticity, and even recovery. Subsequent image analysis revealed that both blunt and blast injuries produced a significantly higher AF and significantly lower NND, which correlated to voids formed by the reduced fluid retention within injured axons. In conclusion, DTI can detect subtle pathophysiological changes in axonal fiber structure after mild blunt and blast trauma. Our injury model and DTI method provide a practical basis for studying mild traumatic brain injury (mTBI) in a controllable manner and for tracking injury progression. Knowledge gained from our approach could lead to enhanced mTBI diagnoses, biofidelic constitutive brain models, and specialized pharmaceutical treatments.

Lead accumulation by tall fescue (Festuca arundinacea Schreb.) grown on a lead-contaminated soil.

Phytoextraction is gaining acceptance as a cost-effective and environmentally friendly phytoremediation strategy for reducing toxic metal levels from contaminated soils. Cognizant of the potential of this phytoremediation technique as an alternative to expensive engineering-based remediation technologies, experiments were conducted to evaluate the suitability of some plants as phytoextraction species. From one of our preliminary studies, we found that tall fescue (Festuca arundinacea Schreb. cv. Spirit) can tolerate and accumulate significant amounts of lead (Pb) in its shoots when grown in Pb-amended sand. To further evaluate the suitability of tall fescue as one of the potential crop rotation species for phytoextraction, a study was conducted to determine whether the addition of ethylenediaminetetraacetic acid (EDTA) alone or in combination with acetic acid can further enhance the shoot uptake of Pb. Seeds were planted in 3.8 L plastic pots containing top soil, peat, and sand (4:2:1, v:v:v) spiked with various levels (0,1000, 2000 mg Pb/kg dry soil) of lead. At six weeks after planting, aqueous solutions (0, 5 mmol/kg dry soil) of EDTA and acetic acid (5 mmol/kg dry soil) were applied to the root zone, and all plants were harvested a week later. Results revealed that tall fescue was relatively tolerant to moderate levels of Pb as shown by non-significant differences in root and shoot biomass among treatments. An exception to this trend however, was the slight reduction in root and shoot biomass of plants exposed to the highest Pb level in combination with the two chelates. Root Pb concentration increased with increasing level of soil-applied Pb. Further increases in root Pb concentrations were attributed to chelate amendments. Translocation index, which is a measure of the partitioning of the metal to the shoots, was significantly enhanced with chelate addition especially when both EDTA and acetic acid were used. Chelate-induced increases in translocation indices correspondingly led to higher shoot Pb concentrations.