Praseodymium-Doped Ge20In5Sb10Se65 Films Based on Argon Plasma Cosputtering for Infrared-Luminescent Integrated Photonic Circuits.

In this paper, we report on the infrared luminescence of amorphous praseodymium-doped Ge20In5Sb10Se65 waveguides, which can be used as infrared sources in photonic integrated circuits on silicon substrates. Amorphous chalcogenide thin films were deposited by radiofrequency magnetron cosputtering using an argon plasma whose deposition parameters were optimized for chalcogenide materials. The micropatterning as ridge waveguides of the chalcogenide cosputtered films was performed using photolithography and plasma-coupled reactive ion etching techniques. The influence of the rare earth concentration within those thin films on their optical properties and rare earth spectroscopic properties was investigated. Using an excitation wavelength of 1.55 µm, the mid-infrared luminescence of Pr3+ ions from 2.5 to 5.5 µm was clearly demonstrated for studied chalcogenide materials. A wide range of waveguide widths and doping ratios were tested, assessing the ability of the cosputtering technique to preserve the luminescence properties of the rare earth ions initially observed in the bulk glass through the thin-film deposition and patterning process.

Carbon dioxide mid-infrared sensing based on Dy3+-doped chalcogenide waveguide photoluminescence.

Climate-active gases, notably carbon dioxide (CO2), methane (CH4), and nitrous oxide (N2O), display fundamental absorption bands in the mid-infrared (mid-IR). The detection and monitoring of those gases could be enabled by the development of mid-IR optical sources. Broadband mid-IR on-chip light emission from rare-earth-doped chalcogenide photonic integrated circuits could provide a compact, efficient, and cost-effective gas sensing solution. Mid-IR photoluminescence of dysprosium-doped selenide ridge waveguides obtained under optical pumping at a telecommunication wavelength (∼1.3 µm) is investigated for Dy3+ ion concentrations in the 2500-10,000 ppmw range. CO2 detection at around 4.3 µm is then demonstrated based on absorption of this broadband mid-IR emission.

Co-sputtered Pr3+-doped Ga-Ge-Sb-Se active waveguides for mid-infrared operation.

This work reports on the properties of luminescent waveguides based on quaternary Ga-Ge-Sb-Se amorphous thin films doped with praseodymium. The waveguides were fabricated via magnetron co-sputtering, followed by inductively coupled plasma reactive ion etching. The initial thin film thickness and optical properties were assessed and the spectroscopic properties of the waveguides were measured. The measurements show promising results-it is possible to obtain mid-infrared fluorescence at 2.5 and 4.5 µm by injecting near-infrared light at 1.5 µm as the pump beam. By comparing waveguides with various praseodymium concentrations, the optimal doping content for maximum fluorescence intensity was identified to be close to 4100 ppmw. Finally, correlation between the intensity of mid-infrared emission and the width/length of the waveguide is shown.