Comparison of Anion-Exchange Membranes for Diffusion Dialysis of Mixtures of Acids and Their Iron Salts.

This study presents the possibility of using diffusion dialysis for the separation of inorganic acids (hydrochloric, nitric, and hydrofluoric) and their ferric salts whose composition corresponds to that of real spent pickling solutions. At a steady state, the transport properties of three different anion-exchange membranes (Fumasep-FAD, Neosepta-AFN, and Neosepta-AHA) are compared using a continuous counter-current dialyzer. At a constant composition of the solutions (acid concentration 3 mol L-1 and iron concentration 30-40 g L-1), the effects of volumetric liquid flow rates on the transport rate of H+ and Fe3+ ions through the membrane are studied. The dialysis process is characterized by the recovery of acids and the rejection of salts. Furthermore, the values of the dialysis coefficients of acids, iron, and the acid/iron separation factors are calculated and compared. The volumetric flow rates of the inlet streams change in limits from 3 × 10-8 to 6 × 10-8 m3 s-1 (from 3 to 6 L h-1 m-2, relative to the membrane area). A comparison of the tested membranes shows slightly better results for acid recovery, iron rejection, and acid/iron separation factors for the Fumasep-FAD membrane than for the Neosepta-AFN membrane. However, the results obtained show that both of these anion-exchange membranes can be considered good separators for tested mixtures that simulate real spent pickling solutions, and there is a good precondition for using diffusion dialysis for processing these solutions in industrial practice. On the contrary, very low values of acid recovery and the overall dialysis coefficient of acid are found for the Neosepta-AHA membrane in the test range of the volumetric flow rate, and, thus, this membrane is insufficient for the adequate separation of these acids and iron salts.

Application of Raney Al-Ni Alloy for Simple Hydrodehalogenation of Diclofenac and Other Halogenated Biocidal Contaminants in Alkaline Aqueous Solution under Ambient Conditions.

Raney Al-Ni contains 62% of Ni2Al3 and 38% NiAl3 crystalline phases. Its applicability has been studied within an effective hydrodehalogenation of hardly biodegradable anti-inflammatory drug diclofenac in model aqueous concentrates and, subsequently, even in real hospital wastewater with the aim of transforming them into easily biodegradable products. In model aqueous solution, complete hydrodechlorination of 2 mM aqueous diclofenac solution (0.59 g L-1) yielding the 2-anilinophenylacetate was achieved in less than 50 min at room temperature and ambient pressure using only 9.7 g L-1 of KOH and 1.65 g L-1 of Raney Al-Ni alloy. The dissolving of Al during the hydrodehalogenation process is accompanied by complete consumption of NiAl3 crystalline phase and partial depletion of Ni2Al3. A comparison of the hydrodehalogenation ability of a mixture of diclofenac and other widely used halogenated aromatic or heterocyclic biocides in model aqueous solution using Al-Ni was performed to verify the high hydrodehalogenation activity for each of the used halogenated contaminants. Remarkably, the robustness of Al-Ni-based hydrodehalogenation was demonstrated even for the removal of non-biodegradable diclofenac in real hospital wastewater with high chloride and nitrate content. After removal of the insoluble part of the Al-Ni for subsequent hydrometallurgical recycling, the low quantity of residual Ni was removed together with insoluble Al(OH)3 obtained after neutralization of aqueous filtrate by filtration.

Treatment of Spent Pickling Solutions by Diffusion Dialysis Using Anion-Exchange Membrane Neosepta-AFN.

This article presents the possibility of using diffusion dialysis for processing spent pickling solution from pickling stainless steels with a mixture of nitric acid and hydrofluoric acid. A counter-current two-compartment dialyzer equipped with an anion-exchange membrane Neosepta-AFN was used to study and compare the diffusion dialysis of model mixture of hydrofluoric acid and ferric nitrate and a real spent pickling solution. The separation efficiency was characterized by the acid recovery yield, the rejection coefficient of the metals, the permeability coefficient of the membrane, and the separation factor. These characteristics were calculated from the data obtained at steady state. For the real spent pickling solution tested, the permeability values of nitrates 1.7 × 10-6 m s-1, fluorides 0.4 × 10-6 m s-1, and ferric ions 1.1 × 10-7 m s-1 were achieved. The separation factor for nitrates/ferric ions was 15.7 and 3.6 for fluorides/ferric ions. Furthermore, the dependencies of recovery yield and rejection for different concentrations of hydrofluoric acid and ferric nitrate were determined.