Comparison of three different fluorescent visualization strategies for detecting Escherichia coli ATP synthase subunits after sodium dodecyl sulfate-polyacrylamide gel electrophoresis.

The correlation between protein molecular weight and the number of lysine or basic amino acid residues was found to be high for broad range molecular weight standards, subunits of Escherichia coli F1F0-ATP synthase and the translated open reading frame of E. coli. A relatively poor correlation between protein molecular weight and the number of cysteine residues was observed in all cases. The ability of amine-reactive, thiol-reactive and basic amino acid-binding fluorophores to detect the eight subunits of F1F0-ATP synthase complex was assessed using 2-methoxy-2,4-diphenyl-3(2H)-furanone (MDPF), monobromobimane (MBB) and SYPRO Ruby protein gel stain, respectively. Though experimentally none of the fluorophores provided accurate estimates of the subunit stoichiometry of this complex, MDPF and SYPRO Ruby protein gel stain were capable of semiquantitative detection of every subunit. MBB, however, failed to detect subunits a, b and c of the hydrophobic F0 complex, as well as subunit epsilon of the F1 complex. All three fluorescent detection procedures permitted subsequent identification of representative subunits by peptide mass profiling using matrix-assisted laser desorption ionization time-of-flight mass spectrometry (MALDI-TOF MS). The use of thiol-reactive fluorophores for the global analysis of protein expression profiles does not appear to be advisable as a significant number of proteins have few or no cysteine residues, thus escaping detection.

Rapid and simple single nanogram detection of glycoproteins in polyacrylamide gels and on electroblots.

The fluorescent hydrazide, Pro-Q Emerald 300 dye, may be conjugated to glycoproteins by a periodic acid Schiff's (PAS) mechanism. The glycols present in glycoproteins are initially oxidized to aldehydes using periodic acid. The dye then reacts with the aldehydes to generate a highly fluorescent conjugate. Reduction with sodium metabisulfite or sodium borohydride is not required to stabilize the conjugate. Though glycoprotein detection may be performed on transfer membranes, direct detection in gels avoids electroblotting and glycoproteins may be visualized within 2-4 h of electrophoresis. This is substantially more rapid than PAS labeling with digoxigenin hydrazide followed by detection with an antidigoxigenin antibody conjugate of alkaline phosphatase, or PAS labeling with biotin hydrazide followed by detection with horseradish peroxidase or alkaline phosphatase conjugates of streptavidin, which require more than eight hours to complete. Pro-Q Emerald 300 dye-labeled gels and blots may be poststained with SYPRO Ruby dye, allowing sequential two-color detection of glycosylated and nonglycosylated proteins. Both fluorophores are excited with mid-range UV illumination. Pro-Q Emerald 300 dye maximally emits at 530 nm (green) while SYPRO Ruby dye maximally emits at 610 nm (red). As little as 300 pg of alpha 1-acid glycoprotein (40% carbohydrate) and 1 ng of glucose oxidase (12% carbohydrate) or avidin (7% carbohydrate) are detectable in gels after staining with Pro-Q Emerald 300 dye. Besides glycoproteins, as little as 2-4 ng of lipopolysaccharide is detectable in gels using Pro-Q Emerald 300 dye while 250-1000 ng is required for detection with conventional silver staining. Detection of glycoproteins may be achieved in sodium dodecyl sulfate-polyacrylamide gels, two-dimensional gels and on polyvinylidene difluoride membranes.

Green/red dual fluorescence detection of total protein and alkaline phosphate-conjugated probes on blotting membranes.

A two-color fluorescence detection method is described based upon covalently coupling the succinimidyl ester of BODIPY FL-X to proteins immobilized on poly(vinylidene difluoride) (PVDF) membranes, followed by detection of target proteins using the fluorogenic substrate 9H-(1,3-dichloro-9,9-dimethylacridin-2-one-7-yl(DDAO)-phosphate in combination with alkaline-phosphatase-conjugated reporter molecules. This results in all proteins in the profile being visualized as green signal while those detected specifically with the alkaline-phosphatase conjugate appear as red signal. The dichromatic detection system is broadly compatible with a wide range of analytical imaging devices including UV epi- or transilluminators combined with photographic or charge-coupled device (CCD) cameras, xenon-arc sources equipped with appropriate excitation/emission filters, and dual laser gel scanners outfitted with a 473 nm second-harmonic generation or 488 nm argon-ion laser as well as a 633 nm helium-neon or 635 nm diode laser. The dichromatic detection method permits detection of low nanogram amounts of protein and allows for unambiguous identification of target proteins relative to the entire protein profile on a single electroblot, obviating the need to run replicate gels that would otherwise require visualization of total proteins by silver staining and subsequent alignment with chemiluminescent or colorimetric signals generated on electroblots.