Elastocapillary adhesion of a soft cap on a rigid sphere.

We study the capillary adhesion of a spherical elastic cap on a rigid sphere of a different radius. Caps of small area accommodate the combination of flexural and in-plane strains induced by the mismatch in curvature, and fully adhere to the sphere. Conversely, wider caps delaminate and exhibit only partial contact. We determine the maximum size of the cap enabling full adhesion and describe its dependence on experimental parameters through a balance of stretching and adhesion energies. Beyond the maximum size, complex adhesion patterns such as blisters, bubbles or star shapes are observed. We rationalize these different states in configuration diagrams where stretching, bending and adhesion energies are compared through two dimensionless parameters.

Marangoni Bursting: Evaporation-Induced Emulsification of Binary Mixtures on a Liquid Layer.

Adjusting the wetting properties of water through the addition of a miscible liquid is commonly used in a wide variety of industrial processes involving interfaces. We investigate experimentally the evolution of a drop of water and volatile alcohol deposited on a bath of oil: The drop spreads and spontaneously fragments into a myriad of minute droplets whose size strongly depends on the initial concentration of alcohol. Marangoni flows induced by the evaporation of alcohol play a key role in the overall phenomenon. The intricate coupling of hydrodynamics, wetting, and evaporation is well captured by analytical scaling laws. Our scenario is confirmed by experiments involving other combinations of liquids that also lead to this fascinating phenomenon.

Elasto-capillarity: deforming an elastic structure with a liquid droplet.

Although negligible at macroscopic scales, capillary forces become dominant as the sub-millimetric scales of micro-electro-mechanical systems (MEMS) are considered. We review various situations, not limited to micro-technologies, where capillary forces are able to deform elastic structures. In particular, we define the different length scales that are relevant for 'elasto-capillary' problems. We focus on the case of slender structures (lamellae, rods and sheets) and describe the size of a bundle of wet hair, the condition for a flexible rod to pierce a liquid interface or the fate of a liquid droplet deposited on a flexible thin sheet. These results can be generalized to similar situations involving adhesion or fracture energy, which widens the scope of possible applications from biological systems, to stiction issues in micro-fabrication processes, the manufacturing of 3D microstructures or the formation of blisters in thin film coatings.

Ex vivo rheology of spider silk.

We investigate the rheological properties of microliter quantities of the spinning material extracted ex vivo from the major ampullate gland of a Nephila clavipes spider using two new micro-rheometric devices. A sliding plate micro-rheometer is employed to measure the steady-state shear viscosity of approximately 1 microl samples of silk dope from individual biological specimens. The steady shear viscosity of the spinning solution is found to be highly shear-thinning, with a power-law index consistent with values expected for liquid crystalline solutions. Calculations show that the viscosity of the fluid decreases 10-fold as it flows through the narrow spinning canals of the spider. By contrast, measurements in a microcapillary extensional rheometer show that the transient extensional viscosity (i.e. the viscoelastic resistance to stretching) of the spinning fluid increases more than 100-fold during the spinning process. Quantifying the properties of native spinning solutions provides new guidance for adjusting the spinning processes of synthetic or genetically engineered silks to match those of the spider.

Investigation and control of a large outbreak of multi-drug resistant tuberculosis at a central Lisbon hospital.

An increase in the number of new cases of tuberculosis (TB) combined with poor clinical outcome was identified among HIV-infected injecting drug users attending a large HIV unit in central Lisbon. A retrospective epidemiological and laboratory study was conducted to review all newly diagnosed cases of TB from 1995 to 1996 in the HIV unit. Results showed that from 1995 to 1996, 63% (109/173) of the Mycobacterium tuberculosis isolates from HIV-infected patients were resistant to one or more anti-tuberculosis drugs; 89% (95) of these were multidrug-resistant, i.e., resistant to at least isoniazid and rifampicin. Eighty percent of the multidrug-resistant strains (MDR) available for restriction fragment length polymorphism (RFLP) DNA fingerprinting clustered into one of two large clusters. Epidemiological data support the conclusion that the transmission of MDR-TB occurred among HIV-infected injecting drug users exposed to infectious TB cases on open wards in the HIV unit. Improved infection control measures on the HIV unit and the use of empirical therapy with six drugs once patients were suspected to have TB, reduced the incidence of MDR-TB from 42% of TB cases in 1996 to 11% in 1999.