A critical review on characterization, human health risk assessment and mitigation of malodorous gaseous emission during the composting process.

Composting has emerged as a suitable method to convert or transform organic waste including manure, green waste, and food waste into valuable products with several advantages, such as high efficiency, cost feasibility, and being environmentally friendly. However, volatile organic compounds (VOCs), mainly malodorous gases, are the major concern and challenges to overcome in facilitating composting. Ammonia (NH3) and volatile sulfur compounds (VSCs), including hydrogen sulfide (H2S), and methyl mercaptan (CH4S), primarily contributed to the malodorous gases emission during the entire composting process due to their low olfactory threshold. These compounds are mainly emitted at the thermophilic phase, accounting for over 70% of total gas emissions during the whole process, whereas methane (CH4) and nitrous oxide (N2O) are commonly detected during the mesophilic and cooling phases. Therefore, the human health risk assessment of malodorous gases using various indexes such as ECi (maximum exposure concentration for an individual volatile compound EC), HR (non-carcinogenic risk), and CR (carcinogenic risk) has been evaluated and discussed. Also, several strategies such as maintaining optimal operating conditions, and adding bulking agents and additives (e.g., biochar and zeolite) to reduce malodorous emissions have been pointed out and highlighted. Biochar has specific adsorption properties such as high surface area and high porosity and contains various functional groups that can adsorb up to 60%-70% of malodorous gases emitted from composting. Notably, biofiltration emerged as a resilient and cost-effective technique, achieving up to 90% reduction in malodorous gases at the end-of-pipe. This study offers a comprehensive insight into the characterization of malodorous emissions during composting. Additionally, it emphasizes the need to address these issues on a larger scale and provides a promising outlook for future research.

Adsorption characteristics of S-Metolachlor onto the sawdust biochar derived from Acacia auriculiformis.

The adsorption mechanism of S-Metolachlor in an aqueous solution by sawdust biochar derived from Acacia auriculiformis (SAB) was studied. SAB was manufactured at 500 °C for 4 h under oxygen-limited conditions and characterized for SEM, EDS, pHpzc, BET, and FTIR. The adsorption kinetics, isotherm, and diffusion studies of S-Metolachlor and SAB were further explored. Moreover, the effects of the solution pH were examined on the adsorption of S-Metolachlor by SAB. The BET analysis of SAB was achieved at 106.74 m2.g-1 and the solution pH did not significantly influence the S-Metolachlor adsorption. The adsorption data were fitted into a Langmuir isotherm and the PSO model. The film diffusion coefficient Df (4.93 × 10-11 to 8.17 × 10-11 m2.s-1) and the particle diffusion coefficient Dp (1.68 × 10-11 to 2.65 × 10-11 m2.s-1) were determined and the rate-limiting step of S-Metolachlor adsorption and SAB was governed by liquid film diffusion. The S-Metolachlor adsorption process onto SAB was controlled by multiple mechanisms, including pore filling, H-bonding, hydrophobic interaction, and π-π EDA interactions. H-bonding is the main interaction for the adsorption of S-Metolachlor and SAB. Conclusively, the study illustrates that biochar produced from Acacia auriculiformis sawdust possessed effective adsorption properties for S-Metolachlor herbicide.

Succession of biochar addition for soil amendment and contaminants remediation during co-composting: A state of art review.

This paper aimed to highlight the succession of biochar addition for soil amendment and contaminants remediation during composting process. Biochar incorporated into the compost mixture promotes composting performance and enhances contaminants reduction. Co-composting with biochar for soil biota has been demonstrated via modified soil biological community abundance and diversity. On the other hand, adverse alterations to soil properties were noted, which had a negative impact on the communication of microbe-to-plant interactions within the rhizosphere. As a result, these changes influenced the competition between soilborne pathogens and beneficial soil microorganisms. Co-composting with biochar promoted the heavy metals (HMs) remediation efficiency in contaminated soils by around 66-95%. Notably, applying biochar during composting could improve nutrient retention and mitigate leaching. The adsorption of nutrients such as nitrogen and phosphorus compounds by biochar can be applied to manage environmental contamination and presents an excellent opportunity to enhance soil quality. Additionally, the various specific functional groups and large specific surface areas of biochar allow for excellent adsorption of persistent pollutants (e.g., pesticides, polychlorinated biphenyls (PCBs)) and emerging organic pollutants, such as microplastic, phthalate acid esters (PAEs) during co-composting. Finally, future perspectives, research gaps, and recommendations for further studies are highlighted, and potential opportunities are discussed.

Assessment of water, sanitation, and hygiene services in district health care facilities in rural area of Mekong Delta, Vietnam.

Access to sufficient water, sanitation, and hygiene (WASH) services is a crucial requirement for patients during therapy and general well-being in the hospital. However, in low- and middle-income countries, these services are often inadequate, resulting in increased morbidity and mortality of patients. This study aimed at assessing the current situation of WASH services in six District Health Care Facilities (DHCFs) in rural areas of the Mekong Delta provinces, Vietnam. The results showed that these services were available with inappropriate quality, which did not compromise the stakeholders' needs. The revealed WASH infrastructures have raised concerns about the prolonged hospital stays for patients and push nosocomial infections to a high level. The safety of the water supply was doubted as the high E. coli (> 60%) and total coliform incidence (86%) was observed with very low residual chlorine concentration (< 0.1 mg/L) in water quality assessment. Moreover, water supply contained a high concentration of iron (up to 15.55 mg/L) in groundwater in one DHCF. Technical assessment tool analysis proved that the improper management and lack of knowledge by human resources were the primary roots of the observed status WASH services. Improvement of the perceptions of WASH should be done for the hospital staff with collaboration and support from the government to prevent incidents in the future.

Metal salt-modified biochars derived from agro-waste for effective congo red dye removal.

Anionic Congo red dye (CR) is not effectively removed by conventional adsorbents. Three novel biochars derived from agro-waste (Acacia auriculiformis), modified with metal salts of FeCl3, AlCl3, and CaCl2 at 500 °C pyrolysis have been developed to enhance CR treatment. These biochars revealed significant differences in effluents compared to BC, which satisfied initial research expectations (P < 0.05). The salt concentration of 2 M realized optimal biochars with the highest CR removal of 96.8%, for AlCl3-biochar and FeCl3-biochar and 70.8% for CaCl2-biochar. The modified biochars were low in the specific surface area (137.25-380.78 m2 g-1) compared normal biochar (393.15 m2 g-1), had more heterogeneous particles and successfully integrated metal oxides on the surface. The CR removal increased with a decrease in pH and increase in biochar dosage, which established an optimal point at an initial loading of 25 mg g-1. Maximum adsorption capacity achieved 130.0, 44.86, and 30.80 mg g-1 for BFe, BCa, and BAl, respectively. As magnetic biochar, which is easily separated from the solution and achieves a high adsorption capacity, FeCl3-biochar is the preferred biochar for CR treatment application.

Antibiotic usage and resistance in animal production in Vietnam: a review of existing literature.

Inappropriate use of antibiotics in animal production system is one of the major factors leading to the antibiotic resistance (ABR) development. In Vietnam, the ABR situation is crucial as antibiotics have been used indiscriminately for disease prevention and as growth promoters in animals. Thus, a thorough understanding on the ABR in veterinary settings would be beneficial to the Vietnam public health authority in formulating timely interventions. This review aimed to provide information on the current status of antibiotic usage in animal husbandry in Vietnam, identified gaps in research, and suggested possible solutions to tackle ABR. To this end, data on ABR in animals were extracted from 3 major electronic databases (PubMed, Web of Science, and ScienceDirect) in the period of January 2013-December 2020. The review findings were reported according to PRISMA, which highlighted the emergence and persistence of ABR in bacterial isolates, including Escherichia coli, Enterococcus spp., and Salmonella species, obtained from pigs and poultry. The lack of awareness of Vietnamese farmers on the antibiotic utilization guidelines was one of the main causes driving the animal ABR. Hence, this paper calls for interventions to restrict antibiotics use in food-producing animals by national action plan and antibiotics control programs. Additionally, studies to evaluate knowledge, attitude, and practice (KAP) of the community are required to promote rational use of antibiotics in all sectors.

Similarities and differences in adsorption mechanism of dichlorvos and pymetrozine insecticides with coconut fiber biowaste sorbent.

In this study, the similarities and differences of the adsorption mechanisms between dichlorvos and pymetrozine and coconut fiber biowaste sorbent (CF-BWS) were investigated. CF-BWS was produced using the slow pyrolysis process at 600 °C for 4 h. HCl acid modification was used to improve the specific surface area. The properties of CF-BWS were analyzed by SEM, FT-IR, BET, and pHpzc. The adsorption kinetics of dichlorvos and pymetrozine on the CF-BWS were well explained by the pseudo-second-order model. The adsorption isotherms for both insecticides were followed the Langmuir isotherm. The difference in molecular structures and surface chemistry caused the difference in adsorption mechanisms of both insecticides. The pore-filling and the hydrophobic interactions were the key mechanisms for both insecticide adsorptions. However, the π-π electron donor-acceptor interaction played the major role in the pymetrozine adsorption but hardly impacted on the adsorption of dichlorvos. The hydrogen bonding mechanism was pronounced in the pymetrozine adsorption, but it had little influence on the dichlorvos adsorption. The CF-BWS is exhibited as an excellent material for the removal of both pollutants and has high potential to be used further as the adsorbent in water treatment process.

Adsorption mechanism of dichlorvos onto coconut fibre biochar: the significant dependence of H-bonding and the pore-filling mechanism.

The adsorption mechanism of dichlorvos onto coconut fibre biochar (CFB) was investigated by the batch adsorption technique. Coconut fibre waste material was synthesised at 600 °C for 4 h under oxygen-limited conditions. The biochar was modified by HCl acid to enhance the specific surface area and porosity. The characteristics of the biochar were analysed by scanning electron microscopy (SEM), Brunauer-Emmett-Teller (BET) specific surface area, and Fourier transform-infrared (FT-IR). The results showed that the BET specific surface area of biochar was 402.4 m2/g. Experimental data presented a good fit to Langmuir isotherm and the pseudo-second-order model. Langmuir isotherm illustrated that monolayer adsorption of dichlorvos occurred on the surface of CFB, with a maximum adsorption capacity of 90.9 mg/g. The diffusion model confirmed that the liquid film diffusion was the rate-limiting step, and the major diffusion mechanism of dichlorvos onto biochar. The BET result after dichlorvos adsorption demonstrated that pore-filling occurred and occupied 58.27%. The pore-filling and chemical interactions, performed important roles in the adsorption of dichlorvos onto CFB. Chemical adsorption is comprised of two interactions, which are hydrophobic and H-bonding, but the prime is H-bonding. CFB is a very potential material for the removal of dichlorvos and environmental pollutants.