Correlation of Boreholes through Well Logs: Application to the Western Sector of Madrid.

This study correlates the results obtained from the resistivity and spontaneous potential well logs in six boreholes for water extraction, located in the multilayer siliciclastic basin in the Madrid region, in the center of the Iberian Peninsula. Given the small lateral continuity that the layers considered in isolation show in this type of multilayer aquifer, geophysical stretches, with their corresponding average lithological assignments, have been established to achieve this objective from the well logs. These stretches allow for mapping the internal lithology in the studied area, obtaining a correlation of greater geological scope than that provided by the correlation between layers. Subsequently, the possible correlation of the lithological stretches selected in each of the boreholes was analyzed, verifying their lateral continuity and establishing an NNW-SSE section in the study area. In this work, the transcendence of the correlation of wells up to great distances (about 8 km in total, and average distance of 1.5 km between wells) is focused on the fact that, if there is a presence of pollutant in certain aquifer stretches in a part of the studied area, overexploitation in the Madrid basin will cause the mobilization of this pollutant to the whole basin, with a possible impact on non-polluted areas.

A Different Processing of Time-Domain Induced Polarisation: Application for Investigating the Marine Intrusion in a Coastal Aquifer in the SE Iberian Peninsula.

This study presents the developments regarding the time-domain induced polarisation method as a supporting tool for resistivity soundings during investigations of coastal detrital aquifers that are salinized by marine intrusion. The interpretation of resistivity measurements in such aquifers, which have variable hydrochemistry and lithology, involves uncertainties owing to the presence of low-resistivity lithologies, such as clays. To reduce these uncertainties, the use of other geophysical parameters is necessary; hence, this study focuses on induced polarisation since it can be measured simultaneously with resistivity. In detail, we propose the determination of induced polarisation using 1D techniques while developing a different algorithm for processing the induced polarisation data. The aim is to extend the results of this phenomenon, using, instead of chargeability, the concepts of polarisability and decay time, which are extracted from the decay curve, given that they represent more intrinsic properties of the various analyzed subsurface media. Results were obtained by applying this methodology to a Quaternary aquifer of the Costa del Sol in the SE Iberian Peninsula (in the province of Almería) during two different campaigns, one in mid-autumn and one late winter (i.e., in October and February, respectively) are presented. The results reveal the position of the saline front during each campaign while reflecting the seasonal movement of the marine intrusion.

Optimization of Dominant Frequency and Bandwidth Analysis in Multi-Frequency 3D GPR Signals to Identify Contaminated Areas.

Ground-penetrating radar (GPR) has been widely used in investigations of contaminated areas because of its sensitivity to variations associated with the nature of pore fluids. However, most of the studies were usually based on the visual interpretation of radargrams or on a time domain amplitude analysis. In this work, we propose a methodology that consists of analyzing the spectral content of the signal recorded in multi-frequency 3D GPR profiles. A remarkable advantage of this type of antenna is its step-frequency system, which provides a much wider emission spectrum than the one corresponding to conventional single-frequency antennas. From the data in the frequency domain, the dominant frequency and bandwidth were calculated as parameters whose variation could be related to the presence of light non-aqueous phase liquid (LNAPL) in the subsurface. By analyzing the variations of these two parameters simultaneously, we were able to delimit the contaminated zones in a case study, associating them with a significant shift of the frequency spectrum with respect to the average of the study area. Finally, as a validation method of the proposed methodology, the results of the frequency analysis were compared with resistivity data obtained with an electromagnetic conductivity meter, showing a very good correlation between the results.

Modelling the Transference of Trace Elements between Environmental Compartments in Abandoned Mining Areas.

An openly accessible cellular automaton has been developed to predict the preferential migration pathways of contaminants by surface runoff in abandoned mining areas. The site where the validation of the results of the Contaminant Mass Transfer Cellular Automaton (CMTCA) has been carried out is situated on the steep flank of a valley in the Spanish northwestern region of Asturias, at the foot of which there is a village with 400 inhabitants, bordered by a stream that flows into a larger river just outside the village. Soil samples were collected from the steep valley flank where the mine adits and spoil heaps are situated, at the foot of the valley, and in the village, including private orchards. Water and sediment samples were also collected from both surface water courses. The concentration of 12 elements, including those associated with the Cu-Co-Ni ore, were analyzed by ICP-OES (Perkin Elmer Optima 3300DV, Waltham, MA, USA) and ICP-MS (Perkin Elmer NexION 2000, Waltham, MA, USA). The spatial representation of the model's results revealed that those areas most likely to be crossed by soil material coming from source zones according to the CMTCA exhibited higher pollution indexes than the rest. The model also predicted where the probabilities of soil mass transfer into the stream were highest. The accuracy of this prediction was corroborated by the results of trace element concentrations in stream sediments, which, for elements associated with the mineral paragenesis (i.e., Cu, Co, Ni, and also As), increased between five- and nine-fold downstream from the predicted main transfer point. Lastly, the river into which the stream discharges is also affected by the mobilization of mined materials, as evidenced by an increase of up to 700% (in the case of Cu), between dissolved concentrations of those same elements upstream and downstream of the confluence of the river and the stream.

Application and limitations of time domain-induced polarization tomography for the detection of hydrocarbon pollutants in soils with electro-metallic components: a case study.

Nowadays, the growing concern about the environmental problems affecting the subsoil has focussed efforts on the detection and characterization of contaminated sites through geophysical prospecting methods. In the present study, a case of a contaminated site by hydrocarbons and their study by means of time domain-induced polarization tomography is presented. The response in chargeability of porous media due to this kind of pollutant allows its delimitation using this method. However, one of the limitations for the application of this technique is the presence of lithologies that contain electro-metallic salts. These salts can produce anomalies of chargeability and mask those due to nonaqueous phase liquids. The studies were conducted in an area contaminated by fuel leaks from supply tanks within a train maintenance facility. Those leaks occurred while the tanks were in use, but since their dismantling, the leak stopped. The geology of the area presented strong heterogeneities and the access was limited by train tracks. In order to locate and characterize the contaminant plume, measurements of resistivity and chargeability were carried out. A grid of monitoring wells in this area was also available from which information about free-phase pollutants was obtained, and a new drilling was carried out to verify an unexpected anomaly. The results obtained show that the location of the plume by the geophysical techniques employed can lead to ambiguity, as an anomaly that does not correspond to contaminated areas appeared but to the presence of clays rich in electro-metallic components such as Mg, Fe, Mn and Al.