Migration of photoinitiators, phthalates and plasticizers from paper and cardboard materials into different simulants and foodstuffs.

The migration of photoinitiators, phthalates and plasticizers from two paper and cardboard materials into food simulants (50% and 95% EtOH and Tenax) and foodstuffs (rice, cereals and milk powder) was studied. In the case of liquid simulants migration was observed to reach the equilibrium after 60 min and depended on the material type and the physicochemical parameters of the migrants, whereas the temperature (room temperature and 60 °C) did not show significant effects. The study of migration of the compounds from a baking paper to Tenax at high temperatures (150 and 250 °C) evidenced an increment of migration when increasing temperature, except for the most volatile analytes. Finally, the migration to foodstuffs was studied using fully validated analytical protocols. Overall, the comparison of the migration rates demonstrated that Tenax was adequate for the simulation of the migration to rice and cereals, but underestimated the migration to infant milk powder, for which 95% EtOH resulted a more suitable simulant.

Target and suspect screening of substances liable to migrate from food contact paper and cardboard materials using liquid chromatography-high resolution tandem mass spectrometry.

This work describes the analysis of both target and non-target compounds in paper and cardboard materials together with the characterization of their migration to Tenax® by means of liquid chromatography coupled to both low (LC-QqQ) and high resolution tandem mass spectrometry (LC-q-Orbitrap), respectively. To this aim, an entire analytical procedure was fully developed and validated for both matrices: paper/cardboard and Tenax®. A total of 97 chemicals, including photoinitiators, phthalates, biocides, antioxidants, etc., listed by the European Regulation, were found in the materials under study together with other substances not included in this list. Moreover, the majority of annotated substances were present in the simulant, giving evidence of their migration capacity. Migration percentages of 10 photoinitiators, 4 phthalates, bisphenol A, bis-(2-ethylhexyl) adipate, acetyltributyl citrate and caprolactam to Tenax® were quantified. Despite not exceeding the established specific migration limit (SML) in any case, benzophenone, 4-phenylbenzophenone and bisphenol A concentrations in some paper and cardboard materials were very close to the SML values established by the EU legislation.

Focused ultrasound solid-liquid extraction for the determination of organic biomarkers in beachrocks.

Beachrocks are consolidated coastal sedimentary formations resulting mainly from the relative rapid cementation of beach sediments by different calcium carbonate polymorphs. Although previous works have already studied the elemental composition and the mineral phases composing these cements, few of them have focused their attention on the organic matter present therein. This work describes an extraction methodology based on focused ultrasound solid-liquid extraction (FUSLE), followed by analysis using large volume injection (LVI) in a programmable temperature vaporizer (PTV) combined with gas chromatography-mass spectrometry (GC-MS) in order to determine organics such as polycyclic aromatic hydrocarbons (PAHs) and biomarkers (hopanes), which can increase and confirm the information obtained so far. This goal has been achieved after the optimization of the main parameters affecting the extraction procedure, such as, extraction solvent, FUSLE variables (amplitude, extraction time and pulse time) and also variables affecting the LVI-PTV (vent time, injection speed and cryo-focusing temperature). The developed method rendered results comparable to traditional extraction methods in terms of accuracy (77-109%) and repeatability (RSD<23%). Finally, the analyses performed over real beachrock samples from the Bay of Biscay (Northern Spain) revealed the presence of the 16 EPA priority PAHs, as well as some organic biomarkers which could increase the knowledge about such beachrock formation.

Microextraction with polyethersulfone for bisphenol-A, alkylphenols and hormones determination in water samples by means of gas chromatography-mass spectrometry and liquid chromatography-tandem mass spectrometry analysis.

In the present work, the suitability of polyethersulfone (PES) tube was assessed for the simultaneous sorptive microextraction of commonly found endocrine disrupting compounds in natural waters such as bisphenol-A (BPA), nonylphenol technical mixture (NP mix), 4-tert-octylphenol (4tOP), 4-n-octylphenol (4-nOP), 17ß-estradiol (E2) and 17α-ethynilestradiol (EE2). After the concentration of target compounds in the PES polymer, the analytes were recovered soaking the polymer with a suitable solvent (ethyl acetate or methanol), derivatized using N,O-bis(trimethylsilyl)trifluoroacetamide with 1% of trimethylchlorosilane (BSTFA+1% TMCS) and determined by gas chromatography-mass spectrometry (GC-MS). The analysis was also performed without derivatization step by means of liquid chromatography-tandem mass spectrometry (LC-MS/MS). Extraction parameters (addition of MeOH, ionic strength, extraction speed and time and desorption time) were evaluated and the optimum conditions were fixed as follows: 150 mL water samples containing a 10% (w/v) of sodium chloride and using 5 tubular PES sorbent fibers (1.5 cm length×0.7 mm o.d.). Equilibrium conditions were achieved after 9 h, with absolute extraction efficiencies ranging from 27 to 56%. On the whole, good apparent recoveries were achieved (68-103% and 81-122% for GC-MS and LC-MS/MS, respectively) using deuterated analogues as surrogates. Achieved quantification limits (LOQs) varied between 2-154 ng/L and 2-63 ng/L for all the compounds using GC-MS and LC-MS/MS, respectively. The effect of organic matter was evaluated previous to apply the final method to the analysis of estuarine and wastewater real samples. The comparison of both methods showed that overall, PES-LC-MS/MS provided shorter sample preparation time and better LODs, but PES-silylation-GC-MS allowed the simultaneous determination of all the studied compounds with adequate repeatability and accuracy.