Structural evolution in thermoelectric zinc antimonide thin films studied by in situ X-ray scattering techniques.

Zinc antimonides have been widely studied owing to their outstanding thermoelectric properties. Unlike in the bulk state, where various structurally unknown phases have been identified through their specific physical properties, a number of intermediate phases in the thin-film state remain largely unexplored. Here, in situ X-ray diffraction and X-ray total scattering are combined with in situ measurement of electrical resistivity to monitor the crystallization process of as-deposited amorphous Zn-Sb films during post-deposition annealing. The as-deposited Zn-Sb films undergo a structural evolution from an amorphous phase to an intermediate crystalline phase and finally the ZnSb phase during heat treatment up to 573 K. An intermediate phase (phase B) is identified to be a modified ß-Zn8Sb7 phase by refinement of the X-ray diffraction data. Within a certain range of Sb content (∼42-55 at%) in the films, phase B is accompanied by an emerging Sb impurity phase. Lower Sb content leads to smaller amounts of Sb impurity and the formation of phase B at lower temperatures, and phase B is stable at room temperature if the annealing temperature is controlled. Pair distribution function analysis of the amorphous phase shows local ordered units of distorted ZnSb4 tetrahedra, and annealing leads to long-range ordering of these units to form the intermediate phase. A higher formation energy is required when the intermediate phase evolves into the ZnSb phase with a significantly more regular arrangement of ZnSb4 tetrahedra.

Structures and Role of the Intermediate Phases on the Crystallization of BaTiO3 from an Aqueous Synthesis Route.

Carbonate formation is a prevailing challenge in synthesis of BaTiO3, especially through wet chemical synthesis routes. In this work, we report the phase evolution during thermal annealing of an aqueous BaTiO3 precursor solution, with a particular focus on the structures and role of intermediate phases forming prior to BaTiO3 nucleation. In situ infrared spectroscopy, in situ X-ray total scattering, and transmission electron microscopy were used to reveal the decomposition, pyrolysis, and crystallization reactions occurring during thermal processing. Our results show that the intermediate phases consist of nanosized calcite-like BaCO3 and BaTi4O9 phases and that the intimate mixing of these along with their metastability ensures complete decomposition to form BaTiO3 above 600 °C. We demonstrate that the stability of the intermediate phases is dependent on the processing atmosphere, where especially enhanced CO2 levels is detrimental for the formation of phase pure BaTiO3.

A Fast, Low-Temperature Synthesis Method for Hexagonal YMnO3 : Kinetics, Purity, Size and Shape as Studied by In Situ X-ray Diffraction.

The reaction mechanisms, phase development and kinetics of the hydrothermal synthesis of hexagonal-YMnO3 from Y2 O3 and Mn2 O3 using in situ X-ray diffraction are reported under different reaction conditions with temperatures ranging from 300 to 350 °C, and using 1, 5 and 10 m KOH, and 5 m NaOH mineraliser. Reactions initiated with Y2 O3 hydrating to Y(OH)3 , which then dehydrated to YO(OH). Higher temperatures and KOH concentrations led to faster, more complete dehydrations. However, 1 m KOH led to YO(OH) forming concurrently with Y(OH)3 before Y(OH)3 fully dehydrated but yielded a very low phase purity of hexagonal-YMnO3 . Using NaOH mineraliser, no YO(OH) was observed. Dehydration also initiated at a higher temperature in the absence of Mn2 O3 . The evolution of Rietveld refined scale factors was used to determine kinetic information and approximate activation energies for the reaction. The described hydrothermal synthesis offers a fast, low-temperature method for producing anisometric h-YMnO3 particles.

Controlled Growth of Srx Ba1-x Nb2 O6 Hopper- and Cube-Shaped Nanostructures by Hydrothermal Synthesis.

Controlling the shape and size of nanostructured materials has been a topic of interest in the field of material science for decades. In this work, the ferroelectric material Srx Ba1-x Nb2 O6 (x=0.32-0.82, SBN) was prepared by hydrothermal synthesis, and the morphology is controllably changed from cube-shaped to hollow-ended structures based on a fundamental understanding of the precursor chemistry. Synchrotron X-ray total scattering and PDF analysis was used to reveal the structure of the Nb-acid precursor, showing Lindqvist-like motifs. The changing growth mechanism, from layer-by-layer growth forming cubes to hopper-growth giving hollow-ended structures, is attributed to differences in supersaturation. Transmission electron microscopy revealed an inhomogeneous composition along the length of the hollow-ended particles, which is explained by preferential formation of the high entropy composition, SBN33, at the initial stages of particle nucleation and growth.

Structure and Optical Properties of Titania-PDMS Hybrid Nanocomposites Prepared by In Situ Non-Aqueous Synthesis.

Organic-inorganic hybrid materials are attractive due to the combination of properties from the two distinct types of materials. In this work, transparent titania-polydimethylsiloxane hybrid materials with up to 15.5 vol. % TiO2 content were prepared by an in situ non-aqueous method using titanium (IV) isopropoxide and hydroxy-terminated polydimethylsiloxane as precursors. Spectroscopy (Fourier transform infrared, Raman, Ultraviolet-visible, ellipsometry) and small-angle X-ray scattering analysis allowed to describe in detail the structure and the optical properties of the nanocomposites. Titanium alkoxide was successfully used as a cross-linker and titania-like nanodomains with an average size of approximately 4 nm were shown to form during the process. The resulting hybrid nanocomposites exhibit high transparency and tunable refractive index from 1.42 up to 1.56, depending on the titania content.

Crystal structure across the ß to α phase transition in thermoelectric Cu2-x Se.

The crystal structure uniquely imparts the specific properties of a material, and thus provides the starting point for any quantitative understanding of thermoelectric properties. Cu2-x Se is an intensely studied high performing, non-toxic and cheap thermoelectric material, and here for the first time, the average structure of ß-Cu2-x Se is reported based on analysis of multi-temperature single-crystal X-ray diffraction data. It consists of Se-Cu layers with additional copper between every alternate layer. The structural changes during the peculiar zT enhancing phase transition mainly consist of changes in the inter-layer distance coupled with subtle Cu migration. Just prior to the transition the structure exhibits strong negative thermal expansion due to the reordering of Cu atoms, when approached from low temperatures. The phase transition is fully reversible and group-subgroup symmetry relations are derived that relate the low-temperature ß-phase to the high-temperature α-phase. Weak superstructure reflections are observed and a possible Cu ordering is proposed. The structural rearrangement may have a significant impact on the band structure and the Cu rearrangement may also be linked to an entropy increase. Both factors potentially contribute to the extraordinary zT enhancement across the phase transition.

Revealing the slow decomposition kinetics of type-I clathrate Ba8Ga16Ge30.

Inconsistencies in high temperature thermoelectric property measurements of Ba8Ga16Ge30 have prompted our study on the thermal stability of this heavily studied inorganic clathrate. Using X-ray diffraction, thermal analysis, and imaging techniques on both powder and spark plasma sintered pelletized samples, we probe the structure and decomposition characteristics of this important high temperature thermoelectric material. We demonstrate that the decomposition of Ba8Ga16Ge30 is extremely dependent on the heating conditions employed and, as a result of the slow decomposition kinetics of the clathrate, reveal that the true stability of this system has been overlooked in the extensive literature available. Loss of Ga and Ge from the clathrate cage is evident in all high temperature experiments under both air and inert environments. This study serves to highlight that the underlying structural chemistry and stability of thermoelectric materials at high temperature needs to be considered in parallel with the thermoelectric properties which constitute the figure of merit. Only then will reliable thermoelectric modules for real applications be realized.

Demonstration of thin film pair distribution function analysis (tfPDF) for the study of local structure in amorphous and crystalline thin films.

By means of normal-incidence, high-flux and high-energy X-rays, total scattering data for pair distribution function (PDF) analysis have been obtained from thin films (tf), suitable for local structure analysis. By using amorphous substrates as support for the films, the standard Rapid Acquisition PDF setup can be applied and the scattering signal from the film can be isolated from the total scattering data through subtraction of an independently measured background signal. No angular corrections to the data are needed, as would be the case for grazing incidence measurements. The 'tfPDF' method is illustrated through studies of as-deposited (i.e. amorphous) and crystalline FeSb3 films, where the local structure analysis gives insight into the stabilization of the metastable skutterudite FeSb3 phase. The films were prepared by depositing ultra-thin alternating layers of Fe and Sb, which interdiffuse and after annealing crystallize to form the FeSb3 structure. The tfPDF data show that the amorphous precursor phase consists of corner-sharing FeSb6 octahedra with motifs highly resembling the local structure in crystalline FeSb3. Analysis of the amorphous structure allows the prediction of whether the final crystalline product will form the FeSb3 phase with or without excess Sb present. The study thus illustrates how analysis of the local structure in amorphous precursor films can help to understand crystallization processes of metastable phases and opens for a range of new local structure studies of thin films.

Structural Evolution of Iron Antimonides from Amorphous Precursors to Crystalline Products Studied by Total Scattering Techniques.

Homogeneous reaction precursors may be used to form several solid-state compounds inaccessible by traditional synthetic routes, but there has been little development of techniques that allow for a priori prediction of what may crystallize in a given material system. Here, the local structures of FeSbx designed precursors are determined and compared with the structural motifs of their crystalline products. X-ray total scattering and atomic pair distribution function (PDF) analysis are used to show that precursors that first nucleate a metastable FeSb3 compound share similar local structure to the product. Interestingly, precursors that directly crystallize to thermodynamically stable FeSb2 products also contain local structural motifs of the metastable phase, despite their compositional disagreement. While both crystalline phases consist of distorted FeSb6 octahedra with Sb shared between either two or three octahedra as required for stoichiometry, a corner-sharing arrangement indicative of AX3-type structures is the only motif apparent in the PDF of either precursor. Prior speculation was that local composition controlled which compounds nucleate from amorphous intermediates, with different compositions favoring different local arrangements and hence different products. This data suggests that local environments in these amorphous intermediates may not be very sensitive to overall composition. This can provide insight into potential metastable phases which may form in a material system, even with a precursor that does not crystallize to the kinetically stabilized product. Determination of local structure in homogeneous amorphous reaction intermediates from techniques such as PDF can be a valuable asset in the development of systematic methods to prepare targeted solid-state compounds from designed precursors.