ABSTRACT
The flux or beam density (equivalent current/area) of xenon atoms striking the sample target from a saddle field fast-atom bombardment (FAB) gun has been compared with that from a cesium ion gun mounted on the same instrument. A shielded Faraday cup mounted on the end of a solids probe was used to measure directly the flux of the Cs(+) beam. Samples of methylene blue in glycerol solution were then exposed to the ion beam at different fluxes and the extents of reduction were measured. The extent of reduction varied linearly with flux up to a value of about 1.16 × 10(13) particles s(-1) cm(-2) (1.85 µ cm(-2)); above this level, the reduction effect appeared to saturate. FAB spectra were obtained from the same dye solution by using varying settings of the FAB gun. By comparing the extents of reduction of the dye from the two guns, the flux from the atom gun could be estimated. Observation of luminescence from a CsI-coated target allowed estimation of the area of the atom beam. The atom beam "equivalent current" could then be calculated by multiplying the flux times the area. It was noted that for given settings, the flux from the atom gun depended on the physical condition of the gun electrodes. With new electrodes, a flux ≥ 1.16 × 10(13) particles s(-1) cm(-2) was obtained with nominal gun emission currents of 0.60-1.0 mA. Electrodes used extensively, but freshly cleaned, provided a flux of â¼ 8 × 10(12) particles s(-1) cm(-2) at nominal emission currents of 0.40-1.0 mA. With dirty electrodes this flux could only be achieved at the highest (1.0 mA) emission current. This decline in performance occurs over a matter of months as a result of contamination and erosion of the electrodes during use. Such behavior can adversely affect spectral reproducibility even when nominal FAB gun voltage and emission current are carefully reproduced.
