ABSTRACT
Li3Fe3Te2O12 adopts a crystal structure, described in space group Pnnm, related to that of LiSbO3, in which Te6+, Fe3+, and Li+ cations reside in a partially ordered configuration within an hcp array of oxide ions. Chemical or electrochemical insertion of lithium is accompanied by a fully reversible migration of some of the Fe cations with an initial capacity of 120 mA h g-1 (2.85 Li per formula unit). Long-term cycling stability is limited by the facile reduction of Te6+ to elemental Te, which leads to cathode decomposition. Partial substitution of Fe by In suppresses Te6+ reduction, such that Li3Fe2InTe2O12 shows no sign of this cathode decomposition pathway, even after 100 cycles. In contrast, Al-for-Fe substitution is chemically limited to Li3Fe2.6Al0.4Te2O12 and appears to have almost no influence on cathode longevity. These features of the Li3Fe3-xMxTe2O12 system are discussed on the basis of a detailed structural analysis performed using neutron and synchrotron X-ray diffraction.
ABSTRACT
Ni-rich layered oxide cathode materials such as LiNi0.8Mn0.1Co0.1O2 (NMC811) are widely tipped as the next-generation cathodes for lithium-ion batteries. The NMC class offers high capacities but suffers an irreversible first cycle capacity loss, a result of slow Li+ diffusion kinetics at a low state of charge. Understanding the origin of these kinetic hindrances to Li+ mobility inside the cathode is vital to negate the first cycle capacity loss in future materials design. Here, we report on the development of operando muon spectroscopy (µSR) to probe the Å-length scale Li+ ion diffusion in NMC811 during its first cycle and how this can be compared to electrochemical impedance spectroscopy (EIS) and the galvanostatic intermittent titration technique (GITT). Volume-averaged muon implantation enables measurements that are largely unaffected by interface/surface effects, thus providing a specific characterization of the fundamental bulk properties to complement surface-dominated electrochemical methods. First cycle measurements show that the bulk Li+ mobility is less affected than the surface Li+ mobility at full depth of discharge, indicating that sluggish surface diffusion is the likely cause of first cycle irreversible capacity loss. Additionally, we demonstrate that trends in the nuclear field distribution width of the implanted muons during cycling correlate with those observed in differential capacity, suggesting the sensitivity of this µSR parameter to structural changes during cycling.
ABSTRACT
Short-range ordering in cation-disordered cathodes can have a significant effect on their electrochemical properties. Here, we characterise the cation short-range order in the antiperovskite cathode material Li2FeSO, using density functional theory, Monte Carlo simulations, and synchrotron X-ray pair-distribution-function data. We predict partial short-range cation-ordering, characterised by favourable OLi4Fe2 oxygen coordination with a preference for polar cis-OLi4Fe2 over non-polar trans-OLi4Fe2 configurations. This preference for polar cation configurations produces long-range disorder, in agreement with experimental data. The predicted short-range-order preference contrasts with that for a simple point-charge model, which instead predicts preferential trans-OLi4Fe2 oxygen coordination and corresponding long-range crystallographic order. The absence of long-range order in Li2FeSO can therefore be attributed to the relative stability of cis-OLi4Fe2 and other non-OLi4Fe2 oxygen-coordination motifs. We show that this effect is associated with the polarisation of oxide and sulfide anions in polar coordination environments, which stabilises these polar short-range cation orderings. We propose that similar anion-polarisation-directed short-range-ordering may be present in other heterocationic materials that contain cations with different formal charges. Our analysis illustrates the limitations of using simple point-charge models to predict the structure of cation-disordered materials, where other factors, such as anion polarisation, may play a critical role in directing both short- and long-range structural correlations.
ABSTRACT
In situ muon spin relaxation is demonstrated as an emerging technique that can provide a volume-averaged local probe of the ionic diffusion processes occurring within electrochemical energy storage devices as a function of state of charge. Herein, we present work on the conceptually interesting NASICON-type all-solid-state battery LiM2(PO4)3, using M = Ti in the cathode, M = Zr in the electrolyte, and a Li metal anode. The pristine materials are studied individually and found to possess low ionic hopping activation energies of â¼50-60 meV and competitive Li+ self-diffusion coefficients of â¼10-10-10-9 cm2 s-1 at 336 K. Lattice matching of the cathode and electrolyte crystal structures is employed for the all-solid-state battery to enhance Li+ diffusion between the components in an attempt to minimize interfacial resistance. The cell is examined by in situ muon spin relaxation, providing the first example of such ionic diffusion measurements. This technique presents an opportunity to the materials community to observe intrinsic ionic dynamics and electrochemical behavior simultaneously in a nondestructive manner.
ABSTRACT
The electroadsorption of proteins at aqueous-organic interfaces offers the possibility to examine protein structural rearrangements upon interaction with lipophilic phases, without modifying the bulk protein or relying on a solid support. The aqueous-organic interface has already provided a simple means of electrochemical protein detection, often involving adsorption and ion complexation; however, little is yet known about the protein structure at these electrified interfaces. This work focuses on the interaction between proteins and an electrified aqueous-organic interface via controlled protein electroadsorption. Four proteins known to be electroactive at such interfaces were studied: lysozyme, myoglobin, cytochrome c, and hemoglobin. Following controlled protein electroadsorption onto the interface, ex situ structural characterization of the proteins by FTIR spectroscopy was undertaken, focusing on secondary structural traits within the amide I band. The structural variations observed included unfolding to form aggregated antiparallel ß-sheets, where the rearrangement was specifically dependent on the interaction with the organic phase. This was supported by MALDI ToF MS measurements, which showed the formation of protein-anion complexes for three of these proteins, and molecular dynamic simulations, which modeled the structure of lysozyme at an aqueous-organic interface. On the basis of these findings, the modulation of protein secondary structure by interfacial electrochemistry opens up unique prospects to selectively modify proteins.
Subject(s)
Cytochromes c/chemistry , Gels/chemistry , Hemoglobins/chemistry , Muramidase/chemistry , Myoglobin/chemistry , Adsorption , Animals , Borates/chemistry , Cattle , Chickens , Electrochemical Techniques , Horses , Molecular Dynamics Simulation , Organophosphorus Compounds/chemistry , Protein Conformation, beta-Strand , Protein Unfolding , Water/chemistryABSTRACT
The controlled electrodeposition of nanoparticles at the surface of an emulsion droplet offers enticing possibilities in regards to the formation of intricate structures or fine control over the locus or duration of nanoparticle growth. In this work we develop electrochemical control over the spontaneous reduction of aqueous phase Au(III) by heterogeneous electron transfer from decamethylferrocene present in an emulsion droplet - resulting in the growth of nanoparticles. As gold is a highly effective conduit for the passage of electrical current, even on the nanoscale, the deposition significantly enhances the current response for the single electron transfer of decamethylferrocene when acting as a redox indicator. The nanostructures formed at the surface of the emulsion droplets were imaged by cryo-TEM, providing an insight into the types of structures that may form when stabilised by the interface alone, and how the structures are able to conduct electrons.
ABSTRACT
The mechanism of the Brust-Schiffrin gold nanoparticle synthesis has been investigated through the use of ion transfer voltammetry at the water/1,2-dichloroethane (DCE) solution interface, combined with X-ray absorption fine structure (XAFS) of the reaction between [AuCl4](-) and thiol (RSH) in homogeneous toluene (TL) solution. Ion transfer calculations indicate the formation of [AuCl2](-) at RSH/Au ratios from 0.2-2 with a time-dependent variation observed over several days. At RSH/Au ratios above 2 and after time periods greater than 24 h, the formation of Au(I)SR is also observed. The relative concentrations of reaction products observed at the liquid/liquid interface are in excellent agreement with those observed by XAFS for the corresponding reaction in a single homogeneous phase. BH4(-) ion transfer reactions between water and DCE indicate that the reduction of [AuCl4](-) or [AuCl2](-) to Au nanoparticles by BH4(-) proceeds in the bulk organic phase. On the other hand, BH4(-) was unable to reduce the insoluble [Au(I)SR]n species to Au nanoparticles. The number and size of the nanoparticles formed was dependent on the concentration ratio of RSH/Au, as well as the experimental duration because of the competing formation of the [Au(I)SR]n precipitate. Higher concentrations of nanoparticles, with diameters of 1.0-1.5 nm, were formed at RSH/Au ratios from 1 to 2.
ABSTRACT
The formation and use of iminyl radicals in novel and divergent hydroimination and iminohydroxylation cyclization reactions has been accomplished through the design of a new class of reactive O-aryl oximes. Owing to their low reduction potentials, the inexpensive organic dye eosin Y could be used as the photocatalyst of the organocatalytic hydroimination reaction. Furthermore, reaction conditions for a unique iminohydroxylation were identified; visible-light-mediated electron transfer from novel electron donor-acceptor complexes of the oximes and Et3N was proposed as a key step of this process.
ABSTRACT
Metal nanoparticles are readily formed, with a reasonable degree of size and shape control, using solution-based reduction methods under ambient conditions. Despite the large number of reports in this field, much of our knowledge of nanoparticle growth is largely empirical, with the relationship between particle form and growth conditions, for example, still not well understood. Many nanoparticle preparation routes actually depend on not one, but two, solution phases, i.e. the syntheses involve reaction or transfer at the liquid-liquid (organic-water) interface. This interface can be polarised electrochemically, an approach that offers promise as a route to better understanding, and ultimately control, of nanoparticle growth.
ABSTRACT
A surface enhanced Raman scattering system to detect silver nanoparticle adsorption at the water|1,2-dichlorobenzene interface is reported. The Raman response as a function of distance on either side of the interface reveals a reproducible spatial variation, which is potential dependent for a number of adsorption and desorption cycles.
