ABSTRACT
OBJECTIVE: To compare the three-dimensional (3D) effects of canine traction on the maxillary teeth when using two different traction methods, the continuous and the segmented arch wire techniques; then to test whether adding a transpalatal arch (TPA) would affect their response to traction. DESIGN: Finite element analysis. METHODS: A cone-beam computed tomography (CBCT) scan of a patient with bilateral palatally impacted canines was chosen, from which a 3D model was derived and imported into ABAQUS. Two arch wires were modelled, a continuous round one and a segmented rectangular one. Four models were obtained by adding a TPA to both techniques. A 100° imposed rotation was then applied at the intersection between the vertical loop and the horizontal segment of each wire. Initial displacement of the maxillary tooth in the labio-lingual and in the vertical directions was measured. The absolute maximum principal stress of the periodontal ligament (PDL) was also assessed. RESULTS: Traction using a continuous arch wire led to different movement patterns of all teeth, some of them were tipped in a labial direction while others were lingually tipped. Traction using a segmented arch wire resulted in a retroclination of the posterior teeth and a proclination of the anterior teeth with a high level of stress on the premolars' PDL. Adding the TPA only affected the displacement of the first molars. The right side showed a maximum displacement of the first premolar, while the left side showed it on the lateral. The total displacement on the right side was higher than the left side. CONCLUSION: The segmented technique caused a uniform displacement of all teeth while the continuous one showed a non-uniform displacement. The angulation and position of the vertical loop affected the displacement of the maxillary teeth. The addition of a TPA acted only on the first molars.
