Oxidatively stable nanoporous silicon photocathodes with enhanced onset voltage for photoelectrochemical proton reduction.

Stable and high-performance nanoporous "black silicon" photoelectrodes with electrolessly deposited Pt nanoparticle (NP) catalysts are made with two metal-assisted etching steps. Doubly etched samples exhibit an ∼300 mV positive shift in photocurrent onset for photoelectrochemical proton reduction compared to oxide-free planar Si with identical catalysts. We find that the photocurrent onset voltage of black Si photocathodes prepared from single-crystal planar Si wafers by an Ag-assisted etching process increases in oxidative environments (e.g., aqueous electrolyte) owing to a positive flat-band potential shift caused by surface oxidation. However, within 24 h, the surface oxide layer becomes a kinetic barrier to interfacial charge transfer that inhibits proton reduction. To mitigate this issue, we developed a novel second Pt-assisted etch process that buries the Pt NPs deep into the nanoporous Si surface. This second etch shifts the onset voltage positively, from +0.25 V to +0.4 V versus reversible hydrogen electrode, and reduces the charge-transfer resistance with no performance decrease seen for at least two months. PEC performance was stable owing to Pt NP catalysts that were buried deeply in the photoelectrode by the second etch, below a thick surface layer comprised primarily of amorphous SiO2 along with some degree of remaining crystalline Si as observed by scanning and transmission electron micrographs. Electrochemical impedance studies reveal that the second etch leads to a considerably smaller interfacial charge-transfer resistance than samples without the additional etch, suggesting that burying the Pt NPs improves the interfacial contact to the crystalline silicon surface.

Electric-field assisted immobilization and hybridization of DNA oligomers on thin-film microchips.

Single, square voltage pulses in the microsecond timescale result in selective 5'-end covalent bonding (immobilization) of thiolated single-stranded (ss) DNA probes to a modified silicon dioxide flat surface and in specific hybridization of ssDNA targets to the immobilized probe. Immobilization and hybridization rates using microsecond voltage pulses at or below 1 V are at least 10(8) times faster than in the passive control reactions performed without electric field (E), and can be achieved with at least three differently functionalized thin-film surfaces on plastic or glass substrates. The systematic study of the effect of DNA probe and target concentrations, of DNA probe and target length, and the application of asymmetric pulses on E-assisted DNA immobilization and hybridization showed that: (1) the rapidly rising edge of the pulse is most critical to the E-assisted processes, but the duration of the pulse is also important; (2) E-assisted immobilization and hybridization can be performed with micrometre-sized pixels, proving the potential for use on microelectronic length scales, and the applied voltage can be scaled down together with the electrode spacing to as low as 25 mV; and (3) longer DNA chains reduce the yield in the E-assisted immobilization and hybridization because the density of physisorbed single-stranded DNA is reduced. The results show that the E-induced reactions can be used as a general method in DNA microarrays to produce high-density DNA chips (E-immobilization) and speed the microarray-based analysis (E-hybridization).

Immobilization and hybridization by single sub-millisecond electric field pulses, for pixel-addressed DNA microarrays.

Single square voltage pulses applied to buried electrodes result in dramatic rate increases for (1) selective covalent bonding (immobilization) of single-stranded DNA (ssDNA) probes to a functionalized thin film SiO(2) surface on a plastic substrate and (2) hybridization of ssDNA to the immobilized probe. DNA immobilization and hybridization times are 100 ns and 10 micros, respectively, about 10(9) times faster than the corresponding passive reactions without electric field. Surface coverage is comparable. Duration, magnitude and slew rate of the voltage pulse are all key factors controlling the rates of ssDNA immobilization and hybridization. With rise times of 4.5 ns, pulses shorter than 1 ms and voltages below 1V are effective. The ssDNA adsorbed on the surface is reoriented by the rapidly changing electric field. This reduces steric barriers and speeds the immobilization and hybridization reactions. These results open the way for pixel-addressed microarrays driven by silicon microelectronics circuits.

Hydrogen above saturation at silicon vacancies: H-pair reservoirs and metastability sites.

We propose that hydrogen-passivated multivacancies which appear to be fully saturated with H can actually capture additional H in electrically inactive sites. In silicon, first-principles total energy calculations show that splitting an (m>or=2) multivacancy into a mono- and an (m-1) vacancy provides a low-strain pairing site for H, 0.4 eV per H lower than any known bulk pairing site. This monovacancy ejection mechanism is an excellent candidate for the H reservoir found both in crystalline and amorphous Si. A distinct H pairing on the fully saturated m vacancies, by forming an internal surface Si-Si dimer, provides the final state of light-induced metastable degradation of hydrogenated amorphous silicon.