Self-assembly of perovskite nanoplates in colloidal suspensions.

In recent years, perovskite nanocrystal superlattices have been reported with collective optical phenomena, offering a promising platform for both fundamental science studies and device engineering. In this same avenue, superlattices of perovskite nanoplates can be easily prepared on different substrates, and they too present an ensemble optical response. However, the self-assembly and optical properties of these aggregates in solvents have not been reported to date. Here, we report on the conditions for this self-assembly to occur and show a simple strategy to induce the formation of these nanoplate stacks in suspension in different organic solvents. We combined wide- and small-angle X-ray scattering and scanning transmission electron microscopy to evaluate CsPbBr3 and CsPbI3 perovskite nanoplates with different thickness distributions. We observed the formation of these stacks by changing the concentration of nanoplates and the viscosity of the colloidal suspensions, without the need for antisolvent addition. We found that, in hexane, the concentration for the formation of the stacks is rather high and approximately 80 mg mL-1. In contrast, in decane, dodecane, and hexadecane, we observe a much easier self-assembly of the nanoplates, presenting a clear correlation between the degree of aggregation and viscosity. We, then, discuss the impact of the self-assembly of perovskite nanoplates on Förster resonant energy transfer. Our predictions suggest an energy transfer efficiency higher than 50% for all the donor-acceptor systems evaluated. In particular, we demonstrate how the aggregation of these particles in hexadecane induces FRET for CsPbBr3 nanowires. For the n = 2 nanowires (donor) to the n = 3 nanowires (acceptor), the FRET rate was found to be 4.1 ns-1, with an efficiency of 56%, in agreement with our own predictions.

Size-Dependent Photobleaching Mechanism and Kinetics Induced by Nanosecond Laser Pulses in Colloidal Semiconductor Quantum Dots.

An experimental-theoretical approach is proposed to investigate the size-dependent photobleaching of colloidal semiconductor quantum dots (QDs) excited by a nanosecond pulsed laser. In the experimental background, the ground-state absorption and photoluminescence (PL) spectra of chemically prepared QDs are monitored over an excitation time at distinct laser irradiances. The magnitude of photobleaching in the QD solution is quantified by the decay rate of the PL signal as a function of the excitation time and the laser power. A theoretical spectroscopy model is then used to estimate the particle size distribution (PSD) in colloidal solution from the absorption data generated at different laser powers. The resulting evolution of the PSD of the QD ensemble under irradiation is analyzed in terms of classical crystallization theories dealing with the formation, growth, and dissolution of colloidal particles in a supersaturated medium. The QD response to laser irradiation is also interpreted by a simple mechanical model that correlates the photoinduced hydrostatic strain at the solid/liquid interface and the predicted variation of the mean particle size. The reported experimental and theoretical methods are used to completely elucidate the basic physico-chemical processes responsible for the laser-induced photobleaching kinetics of glutathione-capped CdTe aqueous QDs with very small mean sizes. For this purpose, we synthesized a series of colloidal QD samples with mean particle diameters ranging from 1.95 to 2.68 nm. Our results indicate that a faster photobleaching rate occurs in QD samples with smaller sizes in which particle dissolution under laser irradiation is predominant. On the other hand, the photobleaching rate becomes slower in samples with larger dot sizes, possibly due to the formation of core/shell structures in solution via thermal degradation of thiol ligands either during the chemical synthesis or as a consequence of the subsequent interaction with the excitation laser.

Exciton, Biexciton, and Hot Exciton Dynamics in CsPbBr3 Colloidal Nanoplatelets.

Lead halide perovskites have emerged as promising materials for light-emitting devices. Here, we report the preparation of colloidal CsPbBr3 nanoplatelets (3 × 4 × 23 nm3) experiencing a strong quasi-one-dimensional quantum confinement. Ultrafast transient absorption and broadband fluorescence up-conversion spectroscopies were employed to scrutinize the carrier and quasiparticle dynamics and to obtain a full description of the spectroscopic properties of the material. An exciton binding energy of 350 meV, an absorption cross section at 3.2 eV of 5.0 ± 0.3 × 10-15 cm-2, an efficient biexciton Auger recombination lifetime of 9 ± 1 ps, and a biexciton binding energy of 74 ± 4 meV were determined. Moreover, a short-lived emission from hot excitons was observed, which is related to the formation of band-edge excitons. The time constant of both processes is 300 ± 50 fs. These results show that CsPbBr3 nanoplatelets are indeed quite promising for light-emitting technological applications.

Ligand induced switching of the band alignment in aqueous synthesized CdTe/CdS core/shell nanocrystals.

CdTe/CdS core/shell quantum dots (QDs) are formed in aqueous synthesis via the partial decomposition of hydrophilic thiols, used as surface ligands. In this work, we investigate the influence of the chemical nature (functional group and chain length) of the used surface ligands on the shell formation. Four different surface ligands are compared: 3-mercaptopropionic acid, MPA, thioglycolic acid, TGA, sodium 3-mercaptopropanesulfonate, MPS, and sodium 2-mercaptoethanesulfonate, MES. The QD growth rate increases when the ligand aliphatic chain length decreases due to steric reasons. At the same time, the QDs stabilized with carboxylate ligands grow faster and achieve higher photoluminescence quantum yields compared to those containing sulfonate ligands. The average PL lifetime of TGA and MPA capped QDs is similar (≈20 ns) while in the case of MPS shorter (≈15 ns) and for MES significantly longer (≈30 ns) values are measured. A detailed structural analysis combining powder X-ray diffraction, and X-ray photoelectron spectroscopy (XPS) indicates the existence of two novel regimes of band alignment: in the case of the mercaptocarboxylate ligands the classic type I band alignment between the core and shell materials is predominant, while the mercaptosulfonate ligands induce a quasi-type II alignment (MES) or an inverted type I alignment (MPS). Finally, the effect of the pH value on the optical properties was evaluated: using a ligand excess in solution allows achieving better stability of the QDs while maintaining high photoluminescence intensity at low pH.

Bone growth to metal implants is regulated by their surface chemical properties.

Bony ingrowth to control (non-treated) and heat-treated stainless steel and Ti-6Al-4V implants into the medullary canal of the femur in rats was studied by mechanical, chemical and Auger electron spectroscopic methods. At all time intervals up to 35 d post-implantation, the shear strengths of the heat-treated Ti-6Al-4V and stainless steel implants were significantly higher (1.6-fold to 3.4-fold) than in control implants. Using Auger electron spectroscopy depth profiling methods, it was found that the heat treatment modified the implant surface composition significantly, resulting in a thicker oxide layer and other chemical changes. It is concluded that heat treatment of metal implants prior to their insertion alters their chemical surface properties and augments bony ingrowth to them.

Learning the deictic meaning of third person pronouns.

Forty-two children (2;8-5;7) viewed video-taped "scenes' in which a SPEAKER addressed sentences containing a personal pronoun which referred to him/herself, the ADDRESSEE or a male or female OTHER. The child's task was to identify the referent of the pronoun. No other cues to the identity of the referent were given. Errors showed that initially gender was the variable used to identify referents and that person was used only later. Several of the oldest children still used only gender in some types of utterance situations. This was because the deictic roles OTHER and, to some extent, ADDRESSEE, were not fully understood until relatively late. Possible explanations concerned the use of Baby Talk to children and information processing necessary for referent identification.