Weathering and toxicity of marine sediments contaminated with oils and polycyclic aromatic hydrocarbons.

Many sediments are contaminated with mixtures of oil residues and polycyclic aromatic hydrocarbons (PAHs), but little is known about the toxicity of such mixtures to sediment-dwelling organisms and the change in toxicity on weathering. In the present study, we investigated the effects of a seminatural, two-year weathering period on PAH/oil chemistry and toxicity in a marine sediment that had been spiked with three different oils (a gas oil, a lubricating oil, and a crude oil; all tested at five concentrations). Toxicity of bioavailable, pore water-accommodated oil/PAH fractions was quantified using a bacterial (Vibrio fischeri) assay and the in vitro chemical-activated luciferase expression assay (DR-CALUX; using conditions to detect PAHs). Results of chemical analyses pointed to (microbial) degradation of all three oils: Sediment oxygen demand during weathering increased with increasing oil concentration, total oil concentrations decreased to between 17 and 29% of initial levels, and resolved n-alkanes were depleted in weathered oil fractions. Furthermore, a shift in the relative importance of different boiling-point fraction ranges of the oils was observed on weathering. Generally, the lowest fraction range (C10-C16) disappeared, whereas the relative proportion of the highest (C28-C40) fraction range increased considerably. Remarkably, for the gas oil, this fraction shift was dependent on the oil concentration in sediment. Similarly, degradation of PAHs was strongly affected by the sedimentary oil content, indicating that the presence of oil stimulated PAH degradation. This phenomenon applied to both low- and high-molecular-weight PAHs, although the first group (3- and 4-ring PAHs) was degraded most. Results from the V. fischeri and DR-CALUX assay showed that in most cases, pore-water toxicity decreased on weathering. Combining the assay responses with chemical data indicated that the observed toxicity probably was not caused by the analyzed PAHs but, rather, by specific oil constituents instead.

Sorption of polycyclic aromatic hydrocarbons to oil contaminated sediment: unresolved complex?

Oil is ubiquitous in aquatic sediments and may affect partitioning and bioavailability of hydrophobic organic chemicals (HOCs). In contrast to other sedimentary hydrophobic carbon phases (natural organic matter, soot-like materials), oil residues have hardly received any attention as far as it concerns effects on HOC sorption. This paper describes experimental work dealing with such effects of oil on polycyclic aromatic hydrocarbon (PAH) sorption to sediments. Three different oils were spiked to a marine sediment in concentrations between 0 and 100 g/kg. Sediment-water distribution coefficients (Kd) for six deuterated PAHs were then determined either directly after spiking the oil or after a semi-natural weathering process in the lab (lasting for more than 2 yr). Resulting Kd values demonstrated sorption-reducing (competitive) effects at relatively low oil concentrations and sorption-enhancing effects at high oil concentrations. The latter effects only occurred above a certain threshold [i.e., ca. 15% (w/w) of oil on a sedimentary organic carbon basis] marking the oil concentration at which the hydrocarbon mixture presumably starts forming separate phases. Assuming a two-domain (organic carbon + oil) distribution model, oil-water distribution coefficients (K(oil)) for PAHs were estimated. For fresh oils, log K(oil) values appeared to be very similar for different types of oils, proportional to log K(OW) values and indistinguishable from log K(OC) values. For weathered oils, K(oil) values were also rather independent of the type of oil, but the affinity of low molecular weight PAHs for weathered oil residues appeared to be extremely high, even higher than values reported for most types of soot. Because affinities of high molecular weight PAHs for oils had not changed upon weathering, sorption of all PAHs studied (comprising a log K(OW) range of 4.6-6.9) to the weathered oil residues appeared to be more or less constant (averaged log K(oil) = 7.0 +/- 0.24). These results demonstrate that it is crucial to take the presence of oil and its weathering state into account when assessing the actual fate of PAHs in aquatic environments.

Oil effect in freshly spiked marine sediment on Vibrio fischeri, Corophium volutator, and Echinocardium cordatum.

The purpose of this study was to provide data to be used in The Netherlands for development of ecotoxicologically based quality criteria for oil-contaminated sediments and dredged material. In addition, the relation of toxicity to specific oil boiling-point fraction ranges was explored. Natural marine sediment, with a moisture, organic carbon, and silt content of approximately 80, 1.8, and 33% of the dry weight, respectively, was artificially spiked using a spiking method developed in this project. Aliquots of one part of the sediment were spiked to several concentrations of Gulf distillate marine grade A (DMA) gasoil (containing 64% C10-19) and aliquots of the other part to several concentrations of Gulf high viscosity grade 46 (HV46) hydraulic oil (containing 99.2% C19-40). Thus, for each individual oil type, a concentration series was created. Vibrio fischeri (endpoint: bioluminescence inhibition), Corophium volutator (endpoint:mortality), and Echinocardium cordatum (endpoint:mortality) were exposed to these spiked sediments for 10 min, 10 d and 14 d, respectively. Based on the test results, the effective concentration on 50% of the test animals was statistically estimated. For DMA gasoil and HV46 hydraulic oil, respectively, the effective concentrations were 43.7 and 2,682 mg/kg dry weight for V. fischeri, 100 and 9,138 mg/kg dry weight for C. volutator, 190, and 1064 mg/kg dry weight for E. cordatum. This study shows that the toxicity is strongly correlated with the lower boiling-point fractions and especially to those within the C10-C19 range.