ABSTRACT
We present a high-energy laser source consisting of an ultrafast thin-disk amplifier followed by a nonlinear compression stage. At a repetition rate of 5 kHz, the drive laser provides a pulse energy of up to 200 mJ with a pulse duration below 500 fs. Nonlinear broadening is implemented inside a Herriott-type multipass cell purged with noble gas, allowing us to operate under different seeding conditions. Firstly, the nonlinear broadening of 64 mJ pulses is demonstrated in an argon-filled cell, showing a compressibility down to 32 fs. Finally, we employ helium as a nonlinear medium to increase the energy up to 200 mJ while maintaining compressibility below 50 fs. Such high-energy pulses with sub-50 fs duration hold great promise as drivers of secondary sources.
ABSTRACT
Dual-comb spectroscopy (DCS) normally operates with two independent, relatively low power and actively synchronized laser sources. This hinders the wide adoption for practical implementations and frequency conversion into deep UV and VUV spectral ranges. Here, we report a fully passive, high power dual-comb laser based on thin-disk technology and its application to direct frequency comb spectroscopy. The peak power (1.2 MW) and the average power (15 W) of our Yb:YAG thin-disk dual-comb system are more than one-order-of-magnitude higher than in any previous systems. The scheme allows easy adjustment of the repetition frequency difference during operation. Both combs share all cavity components which leads to an excellent mutual stability. A time-domain signal recorded over 10 ms without any active stabilization was sufficient to resolve individual comb lines after Fourier transformation.
ABSTRACT
We demonstrate pulse compressibility from 840 fs to 38 fs of 10 mJ pulses from a thin-disk amplifier at a repetition rate of 3 kHz after nonlinear broadening in a multipass cell. In addition, the temporal-intensity contrast is enhanced via nonlinear ellipse rotation of more than a factor 50 with an optical efficiency of 56%. We believe this is the first published experimental combination of multipass cell-based nonlinear compression and nonlinear ellipse rotation-based contrast enhancement preserving both pulse compressibility and beam quality.
ABSTRACT
Several approaches to power scaling of mode-locked thin-disk oscillators exist. One of these approaches is based on the increased gain provided by multiple passes through the thin-disk laser medium. For the first time, to the best of our knowledge, we applied this approach to a Kerr-lens mode-locked thin-disk oscillator. The so obtained additional gain allowed mode-locked operation with up to 50% output coupling rate. This first demonstration is of particular importance for gain media with inherently low-emission cross sections and paves the way to even more powerful Kerr-lens mode-locked thin-disk oscillators. Moreover, the experimental results indicate an increased self-amplitude modulation related to an overall increase in the soft-aperture Kerr-lens effect.
ABSTRACT
In this work, we present a nonlinear spectral broadening and compression scheme based on self-phase modulation in bulk media inside a Herriott-type multipass cell. With this reliable approach, we achieved a spectral broadening factor of 22 while maintaining an efficiency of over 60% at an average input power of 100 W, and an excellent output beam quality with M2=1.2. The output pulses were compressed to 18 fs, with the broadest spectrum supporting a Fourier-transform limit of 10 fs. The high efficiency and approximately four-optical-cycle pulse duration mark an important milestone towards the realization of a compact, high power oscillator-based driver for XUV frequency combs and other nonlinear processes.
ABSTRACT
This is a report on a 100 W, 20 mJ, 1 ps Yb:YAG thin-disk regenerative amplifier. A homemade Yb:YAG thin-disk, Kerr-lens mode-locked oscillator with turn-key performance and microjoule-level pulse energy is used to seed the regenerative chirped-pulse amplifier. The amplifier is placed in airtight housing. It operates at room temperature and exhibits stable operation at a 5 kHz repetition rate, with a pulse-to-pulse stability less than 1%. By employing a 1.5 mm-thick beta barium borate crystal, the frequency of the laser output is doubled to 515 nm, with an average power of 70 W, which corresponds to an optical-to-optical efficiency of 70%. This superior performance makes the system an attractive pump source for optical parametric chirped-pulse amplifiers in the near-infrared and mid-infrared spectral range. Combining the turn-key performance and the superior stability of the regenerative amplifier, the system facilitates the generation of a broadband, CEP-stable seed. Providing the seed and pump of the optical parametric chirped-pulse amplification (OPCPA) from one laser source eliminates the demand of active temporal synchronization between these pulses. This work presents a detailed guide to set up and operate a Yb:YAG thin-disk regenerative amplifier, based on chirped-pulse amplification (CPA), as a pump source for an optical parametric chirped-pulse amplifier.
Subject(s)
Amplifiers, Electronic/standards , Equipment Design/standards , Oscillometry/methodsABSTRACT
Peak and average power scalability is the key feature of advancing femtosecond laser technology. Today, near-infrared light sources are capable of providing hundreds of Watts of average power. These sources, however, scarcely deliver pulses shorter than 100 fs which are, for instance, highly beneficial for frequency conversion to the extreme ultraviolet or to the mid- infrared. Therefore, the development of power scalable pulse compression schemes is still an ongoing quest. This article presents the compression of 90 W average power, 190 fs pulses to 70 W, 30 fs. An increase in peak power from 18 MW to 60 MW is achieved. The compression scheme is based on cascaded phase-mismatched quadratic nonlinearities in BBO crystals. In addition to the experimental results, simulations are presented which compare spatially resolved spectra of pulses spectrally broadened in self-focusing and self-defocusing media, respectively. It is demonstrated that balancing self- defocusing and Gaussian beam convergence results in an efficient, power-scalable spectral broadening mechanism in bulk material.
ABSTRACT
We report on a laser system based on thin-disk technology and chirped pulse amplification, providing output pulse energies of 200 mJ at a 5 kHz repetition rate. The amplifier contains a ring-type cavity and two thin Yb:YAG disks, each pumped by diode laser systems providing up to 3.5 kW power at a 969 nm wavelength. The average output power of more than 1 kW is delivered in an excellent output beam characterized by M2=1.1. The output pulses are compressed to 1.1 ps at full power with a pair of dielectric gratings.
ABSTRACT
We have recently demonstrated a simple power scaling procedure for Kerr-lens mode-locked thin-disk oscillators. Here we report on the extension of this scheme to a broadband high-peak-power thin-disk oscillator, delivering 140-fs pulses with a peak and average power of 62 MW and 155 W, respectively. This result shows that reaching the emission bandwidth of the gain material in Kerr-lens mode-locked thin-disk oscillators is feasible without sacrificing output power, efficiency, or stability by relying on high intracavity nonlinearities.
ABSTRACT
Spectral broadening in bulk material is a simple, robust and low-cost method to extend the bandwidth of a laser source. Consequently, it enables ultrashort pulse compression. Experiments with a 38 MHz repetition rate, 50 W average power Kerr-lens mode-locked thin-disk oscillator were performed. The initially 1.2 µJ, 250 fs pulses are compressed to 43 fs by means of self-phase modulation in a single 15 mm thick quartz crystal and subsequent chirped-mirror compression. The losses due to spatial nonlinear effects are only about 40 %. A second broadening stage reduced the Fourier transform limit to 15 fs. It is shown that the intensity noise of the oscillator is preserved independent of the broadening factor. Simulations manifest the peak power scalability of the concept and show that it is applicable to a wide range of input pulse durations and energies.
ABSTRACT
A power-scalable concept for carrier-envelope-phase stabilization is presented. It takes advantage of simultaneous pumping of the zero- and first-phonon absorption line of Yb:YAG at 969 and 940 nm. The concept was implemented to lock the carrier-envelope-offset frequency of a 45 W average power Kerr-lens mode-locked thin-disk oscillator. The lock performance is compared to previous experiments where carrier-envelope-stabilization was realized by means of cavity loss modulation.
ABSTRACT
We report a 100 W, 20 mJ, 1-ps, all-Yb:YAG thin-disk regenerative amplifier seeded by a microjoule-level Yb:YAG thin-disk Kerr-lens mode-locked oscillator. The regenerative amplifier is implemented in a chirped pulse amplification system and operates at an ambient temperature in air, delivering ultrastable output pulses at a 5 kHz repetition rate and with a root mean square power noise value of less than 0.5%. Second harmonic generation of the amplifier's output in a 1.5 mm-thick BBO crystal results in more than 70 W at 515 nm, making the system an attractive source for pumping optical parametric chirped pulse amplifiers in the visible and near-infrared spectral ranges.
ABSTRACT
A highly-dispersive mirror with the unprecedented group delay dispersion of -10000 fs2 in the wavelength range of 1025-1035 nm is reported. Reproducible production of a coating with such a high dispersion was possible due to the recently developed robust synthesis technique. Successful employment of the new highly-dispersive mirror in an oscillator is demonstrated.
ABSTRACT
A Kerr-lens mode-locked (KLM) Yb:YAG thin-disk oscillator delivering 215-fs pulses with 75-W average power and 1.4-MW peak power at a repetition rate of 260 MHz is presented. Self-starting KLM is demonstrated at an output power of 68 W. This is the highest repetition rate of any mode-locked thin-disk oscillators so far. Concepts for scaling the repetition rate up to 1 GHz are discussed.
ABSTRACT
Geometric scaling of a Kerr-lens mode-locked Yb:YAG thin-disk oscillator yields femtosecond pulses with an average output power of 270 W. The scaled system delivers femtosecond (210-330 fs) pulses with a peak power of 38 MW. These values of average and peak power surpass the performance of any previously reported femtosecond laser oscillator operated in atmospheric air.
